Embedded Computer EPC-5500 Pentium M Manual de usuario

USER’S

MANUAL

EPC-5500

Intel®Pentium®M

EmbeddedPC

EPC-5500 M1

EPC-5500 Pentium® M

Embedded PC

OPERATION MANUAL

This operation manual is meant to assist both Embedded Computer

manufacturers and end users in installing and setting up the system. The

information contained in this document is subject to change without any

notice.

This manual is copyrighted in February, 2007. You may not reproduce or

transmit in any form or by any means, electronic, or mechanical, including

photocopying and recording.

ACKNOWLEDGEMENTS

All trademarks and registered trademarks mentioned herein are the

property of their respective owners.

CE NOTICE

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

FCC NOTICE

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

You are cautioned that any change or modifications to the equipment not

expressly approve by the party responsible for compliance could void

your authority to operate such equipment.

Contents

TABLE OF CONTENTS

CHAPTER 1 INTRODUCTION

1-1 About This Manual ........................................................ 1-2

1-2 Case Illustration ……………………………………….. 1-3

1-3 System Specification ...................................................... 1-4

1-4 Safety Precautions ......................................................... 1-6

CHAPTER 2 HARDWARE CONFIGURATION

2-1 Jumper & Connector Quick Reference Table ................ 2-2

2-2 Component Locations .................................................... 2-3

2-3 How to Set the Jumpers ................................................. 2-4

2-4 COM Port Connector ……..…………………………... 2-6

2-5 COM3/4 RI& Voltage Selection ................……............ 2-8

2-6 RS232/422/485(COM2) Selection ................................ 2-9

2-7 Keyboard Connector ...................………………..….... 2-10

2-8 PS/2 Mouse Connector .....................……………..….. 2-10

2-9 Reset Connector ............................................................ 2-10

2-10 Hard Disk Drive LED Connector .................................. 2-11

2-11 ATX Power Button ….................................................... 2-11

2-12 External Speaker Connector .......................................... 2-11

2-13 Power LED Connector ……............................................ 2-12

2-14 KeyLock Connector ..………………………………… 2-12

2-15 EXTSMI Connector ………………………………….. 2-12

2-16 CPU Fan Connector ………………………………….. 2-13

2-17 System Fan Connector ………………………………… 2-13

2-18 VGA CRT Connector ………………………………… 2-14

2-19 Hard Disk Drive Connector ........................................... 2-15

2-20 Printer Connector .......................................................... 2-17

2-21 Universal Serial Bus Connector ……………………… 2-18

2-22 LAN Connector ………………………………………. 2-19

2-23 GigaLAN (LAN2) Enable/Disable Selection ………… 2-20

2-24 Clear CMOS Data Selection ………………………… 2-20

2-25 AT/ATX Power Selection ……………………………. 2-21

2-26 ATX Power Connector ……………………………….. 2-22

2-27 Reset/NMI Watchdog Selection ………………………. 2-23

Contents

2-28 DVO Connector ……………………………………….. 2-24

2-29 Sound Connector ………………………………………. 2-25

2-30 CD-IN Connector ……………………………………… 2-25

CHAPTER 3 SOFTWARE UTILITIES

3-1 Introduction …………..........................................…....... 3-2

3-2 VGA Driver Utility ……………………………….…… 3-2

3-3 Flash BIOS Update ..............................................…....... 3-4

3-4 LAN Driver Utility …...........................................…...... 3-6

3-5 Sound Driver Utility …………………………………… 3-7

3-6 Intel Chipset Software Installation Utility …..……..….. 3-8

3-7 USB2.0 Software Installation Utility ………………….. 3-9

3-8 Watchdog Timer Configuration ……………………….. 3-10

CHAPTER 4 AWARD BIOS SETUP

4-1 Introduction ................................................................... 4-2

4-2 Entering Setup ............................................................... 4-3

4-3 The Standard CMOS Features ………............................ 4-4

4-4 The Advanced BIOS Features ....................................... 4-8

4-5 Advanced Chipset Features ........................................... 4-11

4-6 Integrated Peripherals …............................................... 4-14

4-7 Power Management Setup ............................................. 4-19

4-8 PNP/PCI Configuration …............................................. 4-22

4-9 PC Health Status …….................................................... 4-24

4-10 Frequency Control ....................................…………...... 4-25

4-11 Load Fail-Safe Defaults ................................................. 4-26

4-12 Load Optimized Defaults .........................................…. 4-26

4-13 Password Setting ……………………………………… 4-27

4-14 Save & Exit Setup ......................................................... 4-28

4-15 Exit Without Saving ………………………………… 4-29

Contents

APPENDIX A SYSTEM ASSEMBLY

Exploded Diagram for Whole System ....................................... A-2

Exploded Diagram for System Power .............………............. A-3

Exploded Diagram for Front System …………………………. A-5

Exploded Diagram for Motherboard …………………………. A-7

Exploded Diagram for Hard Disk Drive ……………………… A-8

APPENDIX B TECHNICAL SUMMARY

Block Diagram ........................................................................... B-2

Interrupt Map ............................................................................ B-3

RTC & CMOS RAM Map ........................................................ B-4

Timer & DMA Channels Map .................................................. B-5

I/O & Memory Map ...............................................…................ B-6

Page:1-1

INTRODUCTION

This chapter gives you the information for EPC-5500. It also

outlines the System specification.

Section includes:

zAbout This Manual

zSystem Specifications

zSafety precautions

Experienced users can skip to chapter 2 on page 2-1

for Quick Start.

CHAPTER

Chapter 1 Introduction

Page: 1-2 EPC-5500 USER

′

S MANUAL

1-1. ABOUT THIS MANUAL

Thank you for purchasing our EPC-5500 Pentium M Embedded PC, which is

fully PC / AT compatible. EPC-5500 provides faster processing speed, greater

expandability and can handle more task than before. This manual is designed

to assist you how to install and set up the system. It contains four chapters.

The user can apply this manual for configuration according to the following

chapters :

Chapter 1 Introduction

This chapter introduces you to the background of this manual, and the

specification for this system. Final part of this chapter will indicate you how

to avoid damaging this Embedded Card.

Chapter 2 Hardware Configuration

This chapter outlines the component location and their functions. In the end of

this chapter, you will learn how to set jumper and how to configure this card

to meet your own needs.

Chapter 3 Software Utilities

This chapter contains helpful information for proper installations of the VGA

utility, LAN utility, sound utility, and BIOS update. It also describes the

Watchdog timer configuration.

Chapter 4 Award BIOS Setup

This chapter indicates you how to set up the BIOS configurations.

Appendix A System Assembly

This Appendix introduces you the exploded diagram of the system.

Appendix B Technical Summary

This section gives you the information about the Technical maps.

Chapter 1 Introduction

EPC-5500 USER

′

S MANUAL Page: 1-3

1-2. CASE ILLUSTRATION

Chapter 1 Introduction

Page: 1-4 EPC-5500 USER

′

S MANUAL

1-3. SYSTEM SPECIFICATION

zCPU (mPGA 478) :

Intel® Pentium® M processor in mPGA478 socket

Available at 1.3~ 2.0GHz

System bus frequency at 400MHz

Auto detect voltage regulator

zSYSTEM CHIPSET :

Intel® 855GME chipset

zMEMORY :

Supports up to 2 GB DDR SDRAM.

Two 184-pin DDR333 DIMM sockets on board

zCACHE :

Built-in CPU

zREAL-TIME CLOCK / CALENDAR :

256-byte battery backed CMOS RAM.

Hardware implementation to indicate century rollover

zBIOS :

Phoenix-AwardBIOS™ for plug & play function

Memory size with 4 MB, with VGA BIOS

zKEYBOARD/MOUSE CONNECTOR :

Keyboard with 1 x 4 pin wafer connector.

PS/2 mouse connector with 1 x 4 pin wafer connector.

zUNIVERSAL SERIAL BUS :

Universal Serial Bus Connector on board

Supports up to four USB 2.0 ports.

Tabla de contenidos

Manuales populares de De oficina de otras marcas

HP m9060n - Pavilion - Elite Hoja de especificaciones

Asus

Asus E210 Series Manual de usuario

Dell

Dell Inspiron 600m Manual de usuario

Dell

Dell Inspiron 3662 Manual de usuario

TotalFlow

TotalFlow uFLO Manual de usuario

HP Presario SV7000 - Desktop PC Manual de usuario

HP ProDesk 400 G5 Manual

Logitech

Logitech MK320 Manual de usuario

Dell

Dell XPS 730 H2C Manual de usuario

Sony

Sony Vaio Series Manual de usuario

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manual de usuario

Alto

Alto MD 250 Manual de usuario

Lenovo

Lenovo ThinkCentre Edge 72 Manual

Lenovo

Lenovo ThinkStation D20 Manual

Arbor Technology

Arbor Technology FPC-7800 Series Manual de usuario

Sony

Sony VAIO VGX-TP1 Series Manual de usuario

Asus

Asus Eee Box B204 Manual de usuario

Dell

Dell Optiplex 9010 All In One Manual de usuario