10 CTK3170X
GB
When the appliance is set at 100°C (Boil), the KEEP WARM function cannot be
chosen.
1. When the appliance is set at 100°C (Boil), the KEEP WARM button is disabled.
2. If 100°C has already been selected in standby mode, the KEEP WARM fun-
ction can be started by pressing KEEP WARM and resetting the temperature
to 85°C at the same time.
3. If the KEEP WARM function is operating in standby mode you can turn it off
by pressing 100°C (Boil).
While the appliance is working: You can press the temperature buttons to set the
temperature; You can press the “KEEP WARM” button to start or stop the KEEP
WARM function; You can press the “START/STOP” button to start or turn off the
appliance.
If the KEEP WARM function is set, and it will keep warm for 2 hours. The appli-
ance will then turn off and enter standby mode automatically.
The light around the base will come on during heating, and it will turn off after
heating.
3. Boil-dry protection with auto safety shut off
If there is no water in kettle, the appliance will enter self-protection mode.
4. Product alarm
1. If pressing the buttons does not have any effect, the indicator lights are turned
off, or the kettle gives two audible alarms when it is plugged in, this means
that the kettle has poor contact with the base. If you place the kettle correctly
on the base, everything will return to normal again after plugging in.
2. If the kettle beeps continuously and all the indicator lights flicker it means that
the kettle has boiled dry and overheated. If this happens, unplug the kettle
immediately and fill with cold water to cool it down.
3. If the indicator lights flicker continuously, there is no audible alarm and none of
the buttons work, this means there is a problem with the temperature sensor.
Unplug the kettle and plug it back in again. If the problem persists, stop
using the kettle and return it to the retailer for repair.
5. WARNING Electric Shock Hazard.
Do not immerse the kettle, power base, or plug in water or any other liquid.
1. With the kettle unplugged, empty any remaining water and rinse. Allow the
kettle to cool. The mesh filter may be removed by pulling up on the filter tab
