WARNING: Risk of electric shock. Failure to observe may result in personal
injury, death or equipment damage.
WARNING: Air pressure has the potential to cause injury, do not perform
maintenance duties until air supply is isolated, vented, and is safe to carry out
work. Failure to observe may result in personal injury, death or equipment
damage.
WARNING: All control cabinets requiring electrical supply leads should be
installed by qualified electrical personnel only. Failure to observe may result in
personal injury, death or equipment damage.
CAUTION: It’s recommended installation of an air dryer, after cooler and other
air preparation equipment. Condensate in the air may cause the malfunction
of pneumatic equipment.
CAUTION: Use the product within the specified range of fluid and ambient
temperature. Take measures to prevent freezing, since moisture in airlines will
be frozen under 5ºC, and this may cause damage to seals and lead to
malfunction.
INSTALLATION
Installation –Electrical and Pneumatic
!
!
•All electrical and pneumatic connections and installations of this equipment are to
be carried out by qualified personnel. Be sure to follow installation instructions for
components and accessories.
•If electrical power is required to operate the equipment; do not perform
maintenance duties until electricity is isolated, and is safe to carry out work. Apply
the correct power voltage to the equipment, incorrect voltage will result in damage
to the electrical instruments in the control cabinet.
•Cables which run outside of the unit must be checked for wear or damage.
•Power supply wire gauge and insulation must be sufficient to handle the rated
current consumption.
•Cables must never be squeezed or pinched. Do not locate cables or hoses in high
traffic areas.
•Do not operate service or repair equipment or attempt to remove components until
safety is confirmed.
•Install air filters at the upstream side of the valves and/or pneumatic equipment.
The standard level of filtration should be 5µ or finer.
!
Pneumatic equipment
Maintenance and service manual
www.proway.com.au 5
