HOW TO USE
• Preferably, wax all the hair around the treatment area before use. If you can't wax, you
can shave the treatment area.
• Insert the power cable into the machine and plug it in.
• Turn on the machine by pressing and holding the touch power button on the LCD
screen for two or three seconds until the device turns on.
• Use the same power button to select the desired power level. Each press of the button
will increase the power level. If you don't feel any tingling or discomfort at the lowest
power levels, it's best to select the highest possible power level.
• Place the lamp on the skin, and once the green lights around the LCD screen of the
device flash, press the fire button on the device handle. Repeat the shots on the same
area 2 or 3 times for the best results. To trigger the next shot, wait for the green lights on
the side of the machine to flash.
• For skin rejuvenation treatment, activate the SR mode. Once this mode is activated,
simply place the lamp on the skin and press the fire button. This treatment mode can be
used on the same body areas as the hair removal treatment.
Treatment Modes
• Four treatment modes can be selected using the top button on the LCD screen: hair
removal, hair removal with cooling, skin rejuvenation, and skin rejuvenation with cooling.
• Each time you press the top button, the treatment mode will change. When the top
button lights up in blue upon pressing it, it means that the cooling mode is activated.
When pressing the button displays the abbreviation "SR" on the LCD screen, it signifies
that the skin rejuvenation treatment mode is active. If the "SR" disappears from the
display upon pressing the button, it indicates that the hair removal mode is active.
Automatic Use Mode
• To allow the machine to emit light pulses automatically without pressing the shutter
button, switch to automatic mode. To do this, press the shutter button for four or five
seconds until you hear two beeps, and the green lights around the LCD screen of the
device will flash. The machine will automatically emit light pulses when the lamp is in
contact with the skin. It is recommended to keep the lamp in contact with the skin until
two or three pulses are emitted for faster results. To return to manual pulse emission
mode, press the shutter button again for four or five seconds until you hear two beeps,
and the green lights around the LCD screen of the device will flash.
TREATMENT INTERVALS
Treat every three to five days during the first month, weekly during the second
month, every 15 days during the third month, and every 30 days from the fourth
month until permanent hair removal is achieved.
Permanent hair removal is a process that takes several months. Immediate
results are not expected for two reasons:
