Công Ty TNHH Thiết Bị Tự Động BẢO PHÁT
Điện thoại: 0904 668 997
E-mail: automaticgatevn@gmail.com
Website: https://automaticdoor.vn
Địa chỉ: 40/4H Đông Lân – Hưng Lân, Bà Điểm, Hóc Môn, Tp. Hồ Chí Minh.
Auto Gate System
EL-888A
Function Description:
LED Indications:
CPU, D15 : blinking when power is ON
2SIDE, D6 : light up upon button pressed for opening or closing 2 gates
1SIDE, D7 : light up upon button pressed for opening or closing 1 gate
PHOTO BEAM, D8:
o If Photo Beam Jumper (J5) is enabled:
Light up when no object is detected with the detection ray (if available).
The LED will turn OFF when object is detected
o If Photo Beam Jumper (J5) is disabled: Light up at all time
Red LED, D13 : light up when gates closing
Green LED, D14 : light up when gates opening
Red LED, D16 : fully light up when gate 1 is under overloaded condition
Red LED, D17 : fully light up when gate 2 is under overloaded condition
Jumper Indications:
J1, Light Delay Jumper (Default: DLY):
o J1 enabled (DLY) – the light (if available) will turn ON and remain ON when the gate is
opened. When the gate closed, the light will remained ON for 30 seconds before turning
OFF.
o J1 disabled (FLW) – the light (if available) will turn ON only for the duration of the gate
swings open/close.
J2, Half Way Swing (HWS) Jumper (Default: HWS):
o J2 enabled (OP/CL) – when the control is being pressed when the gate is swinging half-
way, it will immediately swing in reverse direction.
o J2 disabled (HWS) – when the control is being pressed when the gate is swinging half-
way, it will stop moving. The gate will swing in reverse direction when the control is
pressed again.
J3, Open Reverse Jumper (Default: ON):
o J3 enabled (ON) – the gate will reverse slightly upon opening
o J3 disabled (OFF) – the gate will open normally
