Disinfection and cleaning
Before you start disinfection or cleaning make sure the power adapter is
unplugged. It is recommended to perform cleaning with water and universal
washing liquids. Afterwards the machine should be carefully dried.
Warranty statements
•
Warranty applies to 24-month period from the date of purchasing.
•
Malfunctions arisen through the fault of manufacturer in this period, are
removed free of charge.
•
Guaranty is not valid in the following cases:
-
If the serial number label of the manufacturer is damaged.
-
If damages appear as a result of the incorrect operation, transportation or
storage.
•
These documents are necessary if applying for warrantyrepair:
-
User manual with serial number of the machine.
-
Officially signed report, describing the reasons and conditions of
equipment malfunction.
•
Warranty repair could be performed only if the equipment is delivered
in the original manufacturers packaging or equally safe packaging.
Therefore, please keep the transportation packaging after unpacking the
device.
•
If the above warranty requirements are disturbed, repair charges are applied
to the consumer.
For all further questions concerning exploitation and maintenance please
Contact manufacturer or product vendor.
Transportation and storage
To ensure safety during the transportation, transported equipment should be
packed in the original manufacturers’ packaging or similar packaging
substitute.
Equipment can be transported by any kind of closed transport so that
equipment is tightly fixed, and transportation runs accordingly to regulations
applied to this way of transport. Equipment should be stored in original
manufacturers packaging in dry room with humidity not more than 80% and
temperature range from +10 C up to +45 C.
It is not recommended to store the equipment more than 36 month.
Controls description
The control panel of the shaker consists of the following elements:
Setting regimes of operation
The operation regime is set by adjusting two parameters:
RPM - Platform rotation speed.
TIME –Platform rotation time, timer turn off.
Choose the desired parameter buy pressing mode button. The light indicator will
show which parameter is selected.
Set the desired parameter value.
If the time parameter is less than 1 minute, the timer automatically switches off and
the display will show OFF message.
Launch the operation with start / stop button. If you wish to end the operation before
the estimated time runs out press the start / stop button again.
All the TIME and RPM parameter settings are stored in the power independent
memory.
