To remove the hook, proceed as follows:
1 Bend out the edge of the lock washer (item 3) to be able to remove the nut
(item 4).
2 Unscrew and remove the nut (item 4).
3 Remove the pin (item 2) by gently knocking it through the hook (item 1).
4 Remove the hook (item 1).
5 Unscrew the nut (item 5) and remove the bolt (item 6).
6 Remove the pins (item 7 and 8).
7 Turn out the side clamp cylinder (item 12) a bit, to be able to reach the
other end of the side clamp (item 15).
8 Unscrew and remove the bolt and washer (item 9 and 10) and remove the pin
(item 11).
9 Loosen and remove the pin (item 14) by gently knocking it out from underneath
the side clamp.
10 Extort and remove the bushings (item 13) from the hole in the side clamp by
using suitable tools.
Inspection/greasing prior to reassembly
11 Aer removal of all parts, remove all grease and dirt from the parts and also from
the head. Steam clean or clean with some form of solvent.
12 Check the hook (item 1) for wear and replace if necessary. Replace the pin
(item 2, the nut (item 4), the lock washer (item 3) and the bushings (item 13).
It should be noted that the the recess in the hook (item 1) and the pin (item 2)
isveryimportant,asthesepartsarecarryingtheloadwhenacontainerislied.
Replacing / Fitting hooks
7 Replace/reassemble in reverse order, see above (from point 10 and backwards).
5
