Set date format 47
5.5 Measurement series name 48
Set measurement series name 48
5.6 Result Unit 48
Set result unit 48
Section 6: Operation
6.1 Information before operation 49
Electrical current 49
Risk of infection 49
6.2 Power up device 50
6.3 Modify user preferences 51
6.4 Measure individual/batch samples 54
6.5 Calibrate device 58
Calibration methods 58
Calibrate device 58
Perform zero point calibration 60
Calibrate device using calibration standard 61
6.6 Power down device 64
Section 7: Troubleshooting
7.1 Safety notices 65
Electrical current 65
Risk of infection 65
Risk of injury 65
7.2 Notes regarding errors 66
7.3 Error table 67
7.4 Resolve Errors 71
Replace Initiation needle 71
Replace the thermistor probe 75
Align the Thermistor probe 80
Replace micro-fuses 83
Clean cooling clamp 84
Replace printer paper (Models 6000P / 6000SP only) 84
Replace printer ribbon (Models 6000P / 6000SP only) 86
7.5 Reset device to default settings 88
Section 8: Servicing
8.1 Safety notices 89
8.2 Routine maintenance 90
8.3 Remove device front panel 91
8.4 Install device front panel 94
8.5 Lubricate elevator 95
8.6 Perform visual inspection of device 96
8.7 Check repeatability of measurements 97
Sample test protocol measurement check 97
Section 9: Disposal
Section 10: Specications
10.1 Dimensions 99
10.2 Performance parameters 99
Precision (within run repeatability) 99
Accuracy (Linearity)* 100
10.3 Operating Conditions 101
10.4 Nameplate 102
10.5 Repeatability vs Reproducibility 102
Appendix A: Shipping the device 103
Appendix B: Consumables, Accessories, and Replacement Parts 105
Accessories 105
Supplies 105
Replacement Parts 105
Distilled Water 105
