Elite Screens Evanesce Tension Series Manual de usuario

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

In-Ceiling Electric Motorized Front Projection Screen

Evanesce Tension Series

User’s Guide

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Make sure to read this user’s guide and follow the procedure below.

Caution: The screen’s Black Top Drop is already set to its maximum drop distance. There is NO extra Black

Top Drop in the roller. Please be aware of this as it will void your warranty with Elite Screens. Unapproved

changes or modifications (except for cutting the power cord for hardwire installations) to this unit are

prohibited and will void your warranty. For more information, please contact our Technical Support

Department at (877) 511-1211 Ext. 604.

Please retain this user’s guide for future reference.

To avoid damaging the unit, do not use with any unauthorized accessories not

recommended by the manufacturer.

Handle the unit carefully during transportation to avoid any damages.

To ensure safe and reliable operation, direct connection to a properly grounded power

source is advised.

The power outlet supplying power to the unit should be close to the unit and easily

accessible.

Do not install the unit on uneven or inclined surfaces.

Do not place any heavy objects over the power cord.

Position the power cord properly to avoid creating a trip obstacle.

To avoid an electrical shock or fire, due to a loose contact or short circuit, do not

overload the power cord.

The internal & external parts of this unit are not end user serviceable. Do not attempt to

disassemble this unit by yourself. No one except authorized technicians can open and

make repairs to this unit.

Make sure the power source that this unit is connected to has a continuous power flow.

If there is need to use an extension cord, make sure the cord has an equal rating as the

appliance to avoid over heat.

Do not handle the power plug when your hands are wet or your feet are in contact with

water.

Do not use this unit under the following circumstances.

Disconnect the power cord under the conditions of heavy rain, wind thunder or

lightning.

Avoid direct sun light, rain shower and moisture.

Keep away from fire sources and high temperature to prevent this device from

overheating.

Cut off the power supply first before transportation or maintenance.

To avoid possible injury and/or an electric shock, do not attempt to use this screen if

there is obvious damage or if there are any evident broken parts.



Important Safety & Warning Precautions

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Due to various installation environments, the instructions provided in this user’s guide are for

reference only. Please consult a professional installation company for further installation and

safety advice. The installer must insure that proper mounting hardware is used to provide

adequate strength suitable for the installation. Elite Screens is not liable for any faulty

installations. For limit adjustment instructions, please contact our Technical Support

Department at (877) 511-1211 Ext. 604

The Screen’s Top Black Drop is already set to its maximum drop distance. There is NO extra top black

drop in the roller. Please be aware of this as it will void the limitation of your warranty.

Individual modifications to this product are prohibited and will void the warranty with the

manufacturer. Please contact Elite Screens Customer Service for any questions.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur on a particular installation. If this

equipment causes harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures.

Reorient or relocate the receiving antenna of the device which may be casing the interference.

Increase the separation between the screen and the device’s receiver.

Connect the equipment into a different power outlet other than the device.

1. Carefully unpack the screen.

2. Always handle the screen in a leveled position on a clean surface.

3. In order to protect the screen from exposure to stains, keep the screen out of contact with

foreign particles such as dust, sawdust, and/or liquids.

Regardless of the mounting method, the screen should be securely supported so that the vibration or

pulling on the viewing surface will not cause the casing to become loose or fall. The installer must insure

that the fasteners used are of adequate strength and suitable for the installation location.

Installation Warning

Pre-Installation

NOTE

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Please make sure all accessories listed below are included before proceeding.

A. B. C. D.

IR Remote RF Remote 3 Way Wall Switch IR Eye Receiver

AAA Batteries

Red+ Green-

E. F. H.

12V Trigger In-Wall RJ-45 Module Bubble Level

Accessories for Evanesce Tension Series

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Stop

Down

RJ-45 INPUT FOR 5-12V TRIGGER

5-12 VOLT TRIGGER CABLE

Control System for Evanesce Tension Series

1. 5-12V Trigger: The built-in 5-12V trigger input

allows your screen to synchronize its drop & rise

with the projector’s power cycle. The screen

deploys when the projector powers up and will

retract when the projector powers down. The 5-

12 volt adaptor connects to your projector’s

trigger output via a separate cable that may or

may not be provided by the manufacturer of the

projector. The trigger feature will not work

without an output cable from the projector, but it

can be tested by connecting the Red (+) and

Green (-) cable to a 9-volt battery.

2. 3-Way Wall Switch: The 3-way wall

switch is a wall mount control box with

an up/stop/down button and plugs

directly into the screen’s RJ-45 input.

3. IR “Eye” Receiver: plugs directly into the

screen’s RJ-45 input to present a low profile

line-of-sight control option for your IR remote

control even in a recessed ceiling installation.

4. IR Remote Control: The Infrared

functions by direct line of sight contact

with a beam range of 30 feet.

5. RF Remote Control: The radio

waves eliminate the need for a direct

line of sight with a range of 150 feet.

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

6. In-Wall RJ-45 Module: The RJ-45 Module connects to a local wall switch for UP/Down control of your

screen. Please follow the picture diagram below for instructions on how to connect the accessory.

Steps to attach Elite Screens Motorized Screen to your local wall switch

1. Attach Elite Screens ZIW-Module (in-wall switch module) to your local wall switch as

shown in diagram above.

2. Attach an RJ-45 Ethernet cable (not included) to the ZIW-Module and the other end to

the RJ-45 input on your Elite electric screen.

3. After testing the connection, place the in-wall switch module in or on the wall and wire

the Ethernet cable to complete the set up.

NOTE: Please be aware that Ethernet cables have length limitations so please make test before

concealing the cable into the wall.

Elite Screens In-Wall Switch Module ( ZIW-Module )

Ethernet (RJ45) network

cable (not included)

Local Wall Switch

In-Wall UP/DOWN Switch Module (ZIW-Module)

Elite Electric Motorized Screen

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Please make sure all parts listed below are included before proceeding with the installation.

Please consult a professional installer. Elite Screens is not liable for faulty installations.

Power

1. The Evanesce Series includes a 3-Prong Power Cord for use in a non-concealed power outlet. If

your installation will be entirely concealed (including power outlet), Elite Screens strongly

recommends a hardwire connection. Please refer to the image below for both 110v & 220v

wiring information.

Hardware Parts List

QTY

A. Case Rail Nut

4-6

B. Hex Screw

4-6

C. Hanging Bracket

2-3

D. Suspension Bar

E. Washer

8-10

F. Hex Nut

4-6

G. Suspension Bar J- Hook

Hardware Parts List for Evanesce Series

Installation Instructions

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Assembly

2. Insert the Hex Screw (B) through the Hanging Bracket’s (C) screw hole and secure with the Case

Rail Nut (A). Slide the Hanging Bracket (C) through the railing on top of the case.

3. Place the Suspension Bar (D) on the Hanging Bracket (C) and align with the hole as shown below.

Secure the Suspension Bar (D) with the Hex Screw (B), Washer (E) and the Hex Nut (F). Install the

Suspension Bars (D) to your ceiling according to their distance.

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Optional Suspension Bar J-Hook (G)

1. Attach the Suspension Bar J- Hook (G) to the bottom of the Suspension Bar (D) and secure with

the Hex Screw (B), Washer (E) and Hex Nut (F).

2. Attach the Suspension Bar J-Hook (G) to the Hanging Bracket (C) as shown in figure below. Install

the Suspension Bars (D) to your ceiling according to their distance.

Rev.122411-AS

www.elitescreens.com info@elitescreens.com

Optional Installation (parts & hardware not included)

1. Place the Hanging Bracket (C) in the desired location on the screen’s housing and measure the

distance as shown below. (L = Distance)

2. Mark the location of where the screen will be installed according to the distance (L) and then

secure the bolt to the ceiling.

3. Install the screen to the screw bolt as shown in the figure below.

Otros manuales para Evanesce Tension Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Pantalla de proyección de Elite Screens

Elite Screens

Elite Screens F100NWH Manual de usuario

Elite Screens

Elite Screens Kestrel Series Manual de usuario

Elite Screens

Elite Screens Elite ES-M120UWV2 Manual de usuario

Elite Screens

Elite Screens EVANESCE TAB-TENSION Series Guía

Elite Screens

Elite Screens Evanesce Tension Series Manual de usuario

Elite Screens

Elite Screens F100NWH Manual de usuario

Elite Screens

Elite Screens OMS90H2 Manual de usuario

Elite Screens

Elite Screens Home100IWH2-A Manual de usuario

Elite Screens

Elite Screens Starling Tab-Tension Series Manual de usuario

Elite Screens

Elite Screens Elite ezFrame Series Manual de usuario

Elite Screens

Elite Screens EDGE FREE Aeon CineWhite UHD 2 Series Manual de usuario

Elite Screens

Elite Screens Planate Tab-Tension Series Guía

Elite Screens

Elite Screens Evanesce Tension Series Manual de usuario

Elite Screens

Elite Screens WhiteBoardScreen Universal Series Manual de usuario

Elite Screens

Elite Screens YardMaster 2 WraithVeil Dual Series Manual de usuario

Elite Screens

Elite Screens Starling Series Manual de usuario

Elite Screens

Elite Screens 2 CLR Series Manual de usuario

Elite Screens

Elite Screens TE100HC2 Manual del propietario

Elite Screens

Elite Screens Lights-On Portable Series Manual de usuario

Elite Screens

Elite Screens ZWBMS-58 Manual de usuario

Elite Screens

Elite Screens Evanesce B Series Manual de usuario

Elite Screens

Elite Screens Spectrum Series Manual de usuario

Elite Screens

Elite Screens Lunette Series Manual de usuario

Elite Screens

Elite Screens VMAX PLUS 4 SERIES Manual de usuario

Manuales populares de Pantalla de proyección de otras marcas

FART PRODUKT

FART PRODUKT Standard SCREEN Manual de usuario

Draper

Draper E Series Manual

Laarhoven

Laarhoven Companion II Manual de usuario

Renogy

Renogy RMS-LFPS-US Manual de usuario

Da-Lite

Da-Lite ExecutiveElectrol Manual de usuario

Samsung

Samsung S*H65* Manual de usuario

FONESTAR

FONESTAR PPTR-43100-FA Manual de usuario

Slide Clear

Slide Clear Varro XL Manual de usuario

OS РХ-090Н Manual de usuario

Niko

Niko 10-845 Manual de usuario

Speaka Professional

Speaka Professional 2357532 Manual de funcionamiento

Sima

Sima XL-72 Manual de usuario

Jasic

Jasic EVO 2.0 ET-200P Manual de usuario

InFocus

InFocus SC-WALL GRY-92H Manual

Barco

Barco OverView MVL-615 Manual de usuario

Draper

Draper Envoy Manual

SI Dynamic 2 XL Manual de usuario

Draper

Draper Nocturne+ E Instrucciones de instalación