www.elinz.com.au / sales@elinz.com.au / 1300 881 773
Explosion and fire hazard!
Gaseous hydrogen (detonating gas) may form when charging the
battery. Contact with open fire (flame, embers, sparks) may result in
explosions.
Never charge the battery close to an open fire or in places where
sparks may occur.
Always ensure sufficient ventilation.
Be sure the power supply voltage matches the input voltage specifies
on the device (220-240V AC) to prevent damage to the device.
Only connect and disconnect the battery connecting cables when the
charger is disconnected from the mains.
Do not cover the device while charging, as it may be damaged from
extreme heating. Immediately stop using the device if you notice
smoke or an unusual odor.
Do not use the device in rooms where explosive or flammable
substances are stored (e.g. petrol or solvents).
Risk of Electrical Shock!
Charges may interfere with the operation of active electronic
implants, e.g. pacemakers
Avoid pouring or dripping water or other liquids over it. If water
penetrates electrical devices, the risk of electric shock increases.
Ensure that all plugs and cables are free of moisture. Never connect
the device to the mains with wet or moist hands.
Never touch both connections at once when the device is in use.
Unplug from mains before connecting or disconnecting the charging
cable with the battery, or when the device is no longer being used.
Remove all the device cables from the battery before attempting to
drive your vehicle.
