EL1335 Access Control Panel
CHAPTER 1
1. SYSTEM INITIALIZATION
Hold down keys "1" and "3" on the keypad and simultaneously switch off and then switch back
on the power supply. (Alternatively, hold down keys "1" and "3" on the keypad and press the reset
switch while power is on.)
Release the two keys 3 seconds after the power supply is switched back on. If the cold start has
been properly performed, the display will show "PIN". When the display shows "PIN", key in the
6-digit Cold Start PIN code (packed in an envelope in your EL1335 package, otherwise
‘123456’).
