ELICA EPBI 680 MMF Manual de usuario
SAFETY INFORMATION
DIRECTORY
SAFETY INFORMATION
INSTALLATION Door handle installation
Cabinet Diagram (Standing Cabinet)
Cabinet Diagram (Ground Cabinet)
Installation Important Instructions
Installation steps
04
05
06
07
08
PRODUCT INTRODUCTION Control Panel introduction
Mode introduction
First use
Regular operation
09
10
11
11
ACCESSORY Accessory included
Accessory use
12
12
01-03
CLEANING MAINTENANCE whole machine clean
Lamp Replacement
13
14
FAULT HANDLING FAULT HANDLING 15
TECHNICAL PARAMETERS TECHNICAL PARAMETERS 15
PRODUCT RECYCLING PRODUCT RECYCLING 16
01
Thank you for choosing us! Please read all instructions before using this appliance.
This book contains valuable information about operation, care and service. Keep it
in a safe place for future reference. Should the appliance be sold or transferred to
another owner, or should you move house and leave the appliance, always ensure
that the book is supplied with appliance in order that new owner can be acquaint-
ed with the functioning of the appliance and relevant warnings.
THESE WARNINGS ARE PROVIDED IN THE INTEREST OF SAFETY. PLEASE READ
THEM
CAREFULLY BEFORE INSTALLING OR USING THE APPLIANCE.
To maintain the EFFICIENCY and SAFETY of this appliance, we recommend:
· Call only the Service Centers authorized by store where you buy the cooker
· Always use original Spare Parts
When the oven is first switched on, it may give off an unpleas-
ant smell. This is due to the bonding agent used for the insulat-
ing panels within the oven. Please run the new empty product
with the conventional cooking function, 250°C, 90 minutes to
clean oil impurities inside the cavity.
During the first use, it is completely normal that there will be
slight smoke and door. If it does occur, you should wait for the
smell to be cleared before putting food into the oven.
Please use the product under an open environment.
The appliance and its accessible parts become hot during use.
Care should be taken to avoid touching heating elements. Chil-
dren less than 8 years of age shall be kept away unless continu-
ously supervised.
If the surface is cracked, switch off the appliance to avoid the
possibility of electric shock.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
SAFETY INFORMATION
1.
2.
3.
5.
4.
6.
02
During use, the appliance becomes very hot. Care should be
taken to avoid touching heating elements inside the oven.
Do not allow children to go near the oven when it is operating,
especially when the grill is on.
Ensure that the appliance is switched off before replacing the
oven lamp to avoid the possibility of electric shock.
The means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring specifications.
Children should be supervised to ensure that they do not play
with the appliance.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appli-
ance by person responsible for their safety.
Accessible parts may become hot during use. Young children
should be kept away.
An all-pole disconnection means must be incorporated in the
fixed wiring in accordance with the wiring rules.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Do not use harsh abrasive cleaners or sharp metal scrapers to
clean the oven door glass since they can scratch the surface,
which may result in shattering of the glass.
Only use the temperature probe recommended for this oven.
A steam cleaner is not to be used.
The appliance is not intended to be operated by means of an
external timer or a separate remote control system.
The instructions for ovens that have shelves shall include de-
tails indicating the correct installations of the shelves.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
Do not use the oven unless you are wearing something on
your feet. Do not touch the oven with wet or damp hands or
feet.
For oven: Oven door should not be opened often during the
cooking period.
The appliance must be installed by an authorized technician
and put into use. The producer is not responsible for any
damage that might be caused by defective placement, and
installation by unauthorized personnel.
When the door or drawer of oven is open do not leave any-
thing on it, or you may unbalance your appliance or break the
door.
Some parts of appliance may keep its heat for a long time; it is
required to wait for it to cool down before touching onto the
points that are exposed to the heat directly.
If you will not use the appliance for a long time, it is advised to
plug it off.
21.
22.
23.
24.
25.
26.
03
DECLARATION OF COMPLIANCE
When you have unpacked the oven, make sure that it has not been
damaged in any way. If you have any doubts at all, do not use it:
contact a professionally qualified person. Keep packing materials
such as plastic bags, polystyrene, or nails out of the reach of
children because these are dangerous to children.
04
As the appliance is constantly upgrading, the actual appliance shall prevail if the
picture is different from the actual appliance.
Door handle installation
INSTALLATION
Due to the continuous upgrading of the product, if the actual product does not
match the picture, please refer to the actual product.
1. Snap both ends of the door handle onto the two metal rings on the door glass.
2. Move the door handle parallel to the right so that the door handle is fully seated
on the oven door glass.
3. After installation, the handle will be centered with the door glass left and right.
05
600
Min. 590
Min. 50
Air vents
+8
560
*
590
5
20
20
Cabinet Diagram (Standing Cabinet)
Min. 540
Minimum bottom ventilation area: 250 mm2
≥
10
576
≥5
595
595 20
520
Native appliance
1.
2.
3.
Reserve 5 mm for the door panel at the top and
bottom respectively.
Reserve 20 mm for the door panel on the left
and right respectively.
Reserve 20 mm for the door panel in thickness.
The thickness of the cabinet board is 20 mm.
If the power socket is installed on the back of the appliance, the depth of the
cabinet opening shall be increased from a minimum of 590 mm to 620 mm.
The dimensions in the figures are in mm.
06
Minimum bottom ventilation area: 250 mm2
*
Min. 540
If the appliance is installed under the hob, the minimum
thickness of worktop A is shown below:
≥5
Native appliance
Native appliance
Without hob
Hob
576
≥
5
596
595 20
520
Cabinet Diagram (Ground Cabinet)
600
Min. 50
600 +2
Min. 590
+8
560
Air vents
≥5
A
With hob
576
≥
5
Hob type
Induction hob 37 mm
worktop A
Full-surface induction hob 47 mm
Gas hob
Electric hob
30 mm
27 mm
5
20
20
Reserve 5 mm for the door panel at the top and
bottom respectively.
Reserve 20 mm for the door panel on the left
and right respectively.
Reserve 20 mm for the door panel in thickness.
1.
2.
3.
The thickness of the cabinet board is 20 mm.
If the power socket is installed on the back of the appliance, the depth of the
cabinet opening shall be increased from a minimum of 590 mm to 620 mm.
The dimensions in the figures are in mm.
07
Content that means [note]
Installation Important Instructions
Content that means [mandatory]
1.
2.
3.
4.
The safe operation of this appliance can only be guaranteed if it has been
installed to a professional standard in accordance with these installation instruc-
tions. The installer shall be liable for any damage resulting from incorrect installa-
tion.
The entire installation process requires two professional installers. Wear dry
protective gloves during installation to avoid scratch or electric shock.
Fitted units must be heat-resistant up to 90°C, and adjacent unit fronts up to 70 °C.
Please use a 16A socket.
1.
2.
3.
4.
5.
Be very careful when moving or installing the appliance to avoid damage to the
appliance or damage to the cabinets.
Before starting up the appliance, remove all packaging materials and accessories
from the cavity.
The power socket shall be accessible to users (such as next to the cabinet) for
easy power-off.
After installation is complete, make sure that the power plug is firmly inserted
into the socket.
Please refer to the "Cabinet Diagram" for the requirements of net depth of the
cabinet. The clearance between the cabinet bottom board and the rear board (or
wall) shall not be less than 50 mm.
Content that means [prohibit ]
1.
2.
3.
4.
5.
Do not install the appliance behind a decorative door or the door of a kitchen
unit, as this may cause the appliance to overheat.
Check the appliance for damage after unpacking it. Do not connect the appliance
if it has been damaged in transit.
Do not block the vent of the appliance and the gap between the cabinet and the
appliance.
Use extreme caution when moving or installing the appliance. It is very heavy, do
not lift the appliance by the door handle.
If the power cord or power plug is damaged, stop using the appliance
immediately, to avoid fire, electric shock or other injuries.
Tabla de contenidos
Otros manuales de Horno de ELICA
