Elframo VE Manual de usuario
VE Control Panel
R&S Washing - ATC
Pagina 1 di 2
1) Turn on the machine by holding the power button ( ) for 3 sec
2) Press the arrow buttons ( ) to change the selected cycle
3) Press the button ( ) to start the cycle
The 10 min cycle can be interrupted at any time by pressing the button ( ) again
The machine will automatically switch to the rinsing phase
4) Press the button ( ) for 5 sec to enable / disable the automatic cycle startup
85
53
Short
Medium
Long
10 min
01:42
3 Sec
AUTO
MANUAL
5 Sec
5 Sec
VE Control Panel
R&S Washing - ATC
Pagina 2 di 2
5) Press the button ( ) for 2 sec to access the parameters setup mode
a) Press the button ( ) to change the parameter
Boiler temperature Rinsing phase length
Tank temperature Detergent dosing time for the tank
Short cycle time Detergent recovery time
Medium cycle time Rinse aid recovery time
Long cycle time
b) Press the arrow buttons ( ) to change the parameter value
c) Press the button ( ) to return to the main menu
6) Press the button ( ) for 2 seconds to access the information menu
a) Press the arrow buttons ( X) to change the displayed information
Number of performed cycles Temperature of the last 20 wash cycles
Number of regenerations Temperature of the last 20 rinse cycles
Water consumption in liters Last 20 errors entries
b) Press the button ( ) to exit the menu
85
53
85
53
2 Sec
2 Sec
Tabla de contenidos
