ELERIX EX-L12V100R Manual de usuario
www.elerix.com
ELERIX EX-L12V100R
High Energy LFP Front Terminal 12V Battery
12.8V / 100Ah / 1C
Service Connector Application Notes
The EX-L12V100R Service Connector is a magnetic 5-pin connector that allows direct access to
theindividual cells of the 12V battery.
The function of the connector is following
►
Measure the voltage of the individual cells.
►
Allow monitoring and connection of the BMS
►
Connect auxiliary devices to charge or balance individual cells
►
Integrate the battery into a large solution with direct access single cells.
The wiring of the connector
MAXIMAL CONNECTOR CURRENT LOAD: 2 AMPS
If you wish to use the magnetic connector to charge or balance individual cells, the current passed through
the connector may not exceed 2 Amps.
WARNING
the maximal continuous load of the connector is 2 Amps.
Page 2
Page 3
SHORT-CIRCUIT WARING
WARNING
the individual output pins are directly connected to the individual cells. There are
no fuses, nor any other protection.
You must avoid any short circuit by accidental connection of the pins or by improper wiring on the opposite
part of the connector.
Do not try to disassemble the service connector by removing the screws.
Safety recommendation: if not used, please cover the service connector by a self-sticking tape or any other
adhesive cover. This way you can prevent accidental touching of the pins by some metal objects put on the
upper side of the battery.
Warning - no parallel connection
Never connect individual 12V batteries in parallel by means of the service connector. The service connector
is not designed to transfer large currents for a parallel connection of the batteries.
Limited Warranty
There is no warranty for the whole battery if there is a user damage to the service connector or if there was a
short circuit or abuse from over-current on the terminals of the service connector.
www.elerix.com
ELERIX EX-L12V100R
High Energy LFP Front Terminal 12V Battery
12.8V / 100Ah / 1C
Tabla de contenidos
