Electrolux Electric and Gas Cookers Instrucciones de funcionamiento
SERVICE INSTRUCTION
© Electrolux Distriparts
Muggenhofer Straße 135
D-90429 Nürnberg
Germany
Fax +49 (0)911 323 1022
DGS-TDS-N
Publ.-Nr.:
599 529 016
685
11.08
Edition:
EN
COOKERS
Autark cooker hob with
induction
„Maxima Extension“
Service instructions
- 3 and 4 cooking zones
„Maxima Extension“
- 5 cooking zones
- 2 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
Table of contents
1. ESD=electrostatic discharge ............................................................................................... 3
2. Appliance variants............................................................................................................... 4
2.1 Induction hobs with 3 respectively 4 cooking zones „Maxima Extension“........................... 4
2.2 Induction hobs with 5 cooking zones .................................................................................. 6
3. Notes for interventions on the device.................................................................................. 8
4. Error analysis .................................................................................................................... 11
Changes.......................................................................................................................................... 13
- 3 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
1. ESD=electrostatic discharge
As the single electronic interfaces are not protected internally against statical electricity and are
partially open, you must pay attention to that, in case of a repair, there will be a potential
compensation via the housing of the appliance (touch it) in order to neutralize a possible
charging and to prevent a damaging of the affected electronic interface.
You also have to be careful with those electronics delivered as spare parts, which have to be put
out of the ESD protective package only after a potential compensation (discharge of possible
statical electricity).
If a potential compensation with an existing static electricity is not executed, it does not mean
that the electronic is demaged directly. Consequential damages may result due to the damaging
of internal structures which arise only in case of load through temperature and current.
Endangered are all assembly groups which are provided with control entries, wire paths lying
open and free-accessible processors.
- 4 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
2. Appliance variants
2.1 Induction hobs with 3 respectively 4 cooking zones „Maxima Extension“
(Sample illustration ... with 4 cooking zones)
- 5 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
glass ceramics
induction coils
input electronic
induction module
mains connecting
terminal
carrying plate
- 6 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
2.2 Induction hobs with 5 cooking zones
(Sample illustration)
- 7 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
glass ceramics
induction coils
input electronic
induction module
mains connecting
terminal
carrying plate
- 8 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
Fig.: Appliance complete without glass.
Fig.: Connections left Fig.: Connections right
Connections instructions:
Care should be taken with regard to the two right connections that when making a replacement, the
non-occupied connections must also be tightened using a screwdriver (for induction hobs with 3
cooking zones).
3. Notes for interventions on the device
our example: induction cooking platform with 3 cooking zones
- 9 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
Fig.: Design without inductors
Fig.: Torx sheet metal screw Fig.: Phillips screw
The carrier plate can be removed after all of the screws have been removed and the earthed
conductor disconnected.
- 10 - 599 529 016DGS-TDS-N 11.08 U.H. © Electrolux EN
Appliance access instructions:
Ensure the correct spare parts numbers when replacing the filter board. The filter, electronics,
configured left, has a differnet spare parts number than the right one. The plug-in force of
disconnected plug-in connections are also to be taken into account, i.e. if the plugs are inserted too
lightly, there is a risk of plug burnout. The wiring should also be replaced if the plug area of the
defective filter module should show signs of burnout stages.
Performance
electronics
Filter right
Performance
electronics
Filter left
Fig.: Modular arrangement induction modules „Maxima Extension“ - Induction module with
wiring
Fig.: Modular arrangement induction modules with 5 cooking zones
Otros manuales para Electric and Gas Cookers
3
Tabla de contenidos
Otros manuales de Estufa de Electrolux
Electrolux
Electrolux U03306 EK 5701 Manual de usuario
Electrolux
Electrolux EHG645BE Manual de usuario
Electrolux
Electrolux CF501 Manual de instrucciones
Electrolux
Electrolux EKM 90450 X Manual de usuario
Electrolux
Electrolux EKC5611X Manual de usuario
Electrolux
Electrolux Insight EKC6046 Manual de usuario
Electrolux
Electrolux EKG 603102 Manual de usuario
Electrolux
Electrolux WTM165ERA Manual de usuario
Electrolux
Electrolux EK 5701 Manual de usuario
Electrolux
Electrolux EK 5731 Manual de usuario
Electrolux
Electrolux Elco 700 Manual de instrucciones
Electrolux
Electrolux EKC 60353 Manual de usuario
Electrolux
Electrolux PROline EFE503 Manual de usuario
Electrolux
Electrolux EVE611 Manual de usuario
Electrolux
Electrolux Premier DSO51ELSS Manual de usuario
Electrolux
Electrolux LKR64000BX Manual de usuario
Electrolux
Electrolux Insight EKG6046 Manual de usuario
Electrolux
Electrolux EKG 603101 Manual de usuario
Electrolux
Electrolux EHL2X-4 Manual de usuario
Electrolux
Electrolux FGH50K2-41 Manual de usuario
