Pag. 6
he machine has to be placed on a sturdy, horizontal surface making sure it is well ventilated
by leaving a gap of 20 cm around it and do not install it near heat sources (fig.1); we
recomme d you to mai tai a room temperature betwee 24 a d 32°C.
F
or a safe and correct installation, it is essential to provide a suitable socket controlled by a
thermal cut-out switch whose contacts are at least 3 mm apart, in accordance with the current
national safety regulations.
I
f the power cable is damaged, it must be replaced by the manufacturer, its after sale service
or by qualified personnel, to prevent any possible risk.
he continuous, equivalent, weighted level of acoustic pressure is below 70 dB.
S
afety conditions during maintenance
o ensure sufficient industrial safety, the operator must observe the following points:
•
W
ith the machine on, avoid touching exposed components or electrical connections as
the machine is under dangerous voltages.
•
I
f you remove a guard or replace an electrical component, always make sure that you
have previously switched off the tension from the entire line.
•
A
ny maintenance operation must be carried out by qualified, authorized personnel.
•
A
ny kind of maintenance operation must be carried out with the machine off, checking
that the electric power has been previously turned off, that the water system (if present)
is closed and that the pneumatic system (if present) has been depressurized.
•
D
o not carry out any electrical maintenance in the presence of water or in areas with
high humidity.
•
M
ake sure the area where you carry out maintenance operations, is clean and dry.
•
I
f the line is live, cover the exposed terminals and work safely, always adopting
appropriate protections.
•
N
ever put your body, limbs or fingers in the chambers or openings of the machine when
it is operating.
•
D
o not wear watches, rings, jewelry; avoid wearing loose or dangling apparel such as
ties, torn garments, scarves, unbuttoned jackets, which could accidentally become
entangled in the moving parts of the machine.
A
lso not collected hair can be sucked in
from the motor fans, resulting in scalp laceration.
•
O
nly wear approved safety garments.
•
W
hen there is a possibility of getting hit by projections or from falling solid parts or
similar, use safety glasses with side blinkers, helmets or gloves, if necessary.
•
W
hen working with presence of heat on areas, surfaces or materials, it may be required
to wear gloves and other personal protective equipment, to avoid burns in case of
manual intervention.
