Tug Axis 4T—Operating Manual
7
Controls
Key switch
The key switch must be turned clockwise to switch the unit on. When ON, the LED
status indicator will be illuminated. If a fault occurs with the electronics, this LED light
will ash an error code (refer to Appendix 2). It is important to note that the unit should
be switched o and the key removed, whenever it is not in use. This eliminates the risk
of unauthorised movement and also prevents an unnecessary use of battery power.
Emergency stop and back-o button
The controls have two emergency buttons.
1. Emergency stop button—in an emergency, push this button to stop the unit.
To release, slightly twist the button and it will pop back up.
2. Emergency back-o button—when pressed, the unit will travel backwards until
released, to avoid pinning the operator against an obstacle.
Only use the emergency buttons in an emergency.
Direction selector
This determines the direction of travel. Push
the button corresponding to the desired travel
direction (forward/reverse).
Throttle lever
This lever provides variable speed control
from zero up to 100% of the governed speed.
Releasing the lever stops the unit.
Speed selector
The speed selector will always start in the SLOW position. Select a speed that you are
comfortable using. The speed can be changed whilst driving. It is advisable that you
operate this unit at a slow speed when entering a conned area.
Battery level indicator
The battery level indicator indicates the amount of charge left in the batteries. When it
appears to be running low, return the unit to the closest charging station to charge the
batteries. Being aware of the level of charge of the batteries will eliminate the possibility
of running low on power whilst away from the charging station. Red light only indicates
no usable battery power remaining.
