USER MANUAL – LED WASH PRO RGB
6
1
3
2
1 PIN GND
2 PIN SIGNAL－
2
3
1
DMX IN DMX OUT
In uild-in programs 6-13, uild-in program 1-4 is to set Stro e. 1 refers to
non-stro e; Stro e speed of 2, 3, 4 is 0.3s/sec, 1s/sec, 5s/sec respectively.
7. Custom-defined White Balance
In Mode 1, set the first channel to 255, through controller to adjust 2, 3,4
channel value, the other channels is 0, When it achieves the expected value,
press Button 【ENTER】. When there appears “W” efore the temperature value
on the LCD display interface, the white alance is set successfully.
If all the user-defined white alance RGB values are set to 0, the white alance
will resume to default value.
8. aster-slave setting
Under master-slave mode, only need to set 1 “HOST”, the other lights will e DMX
mode(no need to adjust ID code), only 1“HOST” in entire communication system.
prohi ited to connect controller.
IV. Connection of Fixture
1. 3-Pin XLR Socket connection line: 1 pin: signal GND, 2 pin Signal－, 3 pin signal
＋，as listed in the graph elow.
2. DMX line should use STP (Shielded Twisted Pair). The transfer distance should e
within the range of 300m. If out of this range, it should e equipped with a DMX
distri utor. Each distri utor can connect up to 32 fixtures.
3. The DMX line should e connected in series one y one. That is each output of
former fixture connects to the input of its follower, and each output DMX line can
not e divided into more than one outputs;
4. There should e a terminator on the last unit of DMX line. A terminator is a 120
ohm 1 watt resistor which is a connection etween Pin 2 and Pin 3 of a Male XLR
connector. Using a ca le terminator will decrease the possi ility of erratic
ehavior.
V. Notice
1. efore install or use of this fixture, please read and follow these instructions
carefully and keep this manual in a safe place for future reference;
2. efore install or use of this fixture, please check the address code and operating
modes are set right;
3. efore install or maintain this fixture, make sure the power is off;
4. When the fixture is running, don’t unplug live DMX connection line;
