
6
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the “POWER” indicator blinks.
5. Replace the ice basket and close the front cover.
6. Press “ON/OFF” key, and the “POWER”indicator lights solidly. At that
time, press ”SELECT” key to select the ice size. If need to clean the appli-
ance, press “SELECT” key to select “CLEAN” function under standby mode.
7. The ice-making cycle will last approximately 7-15 minutes, depending on
the ambient temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray
situated below the evaporator. Over the next 7-15 minutes ice forms on the
evaporator. Once this has completed, the ice tray will tilt backwards and
the remaining water in the ice tray is drained back into the water reservoir.
The ice cubes are then dropped from the evaporator and pushed forward
into the ice basket by the ice shovel. The ice tray will automatically move
back into position under the evaporator and start the next cycle.
9. The “ICE FULL” indicator will light up when the ice basket is full and then
the ice maker will stop the ice-making cycle automatically. Gently remove
the ice from the ice basket with the ice scoop. About 7.5 seconds later, the
ice maker will restart its ice making cycle automatically.
10. The “ADD WATER” indicator will light up when the water reservoir is lack
of water and the ice-making cycle will stop automatically. At that time,
remove the ice basket and add water to the water reservoir, and then press
“ON/OFF” key again to restart the ice-making cycle.The appliance will start
working automatically after about 20minutes if the operator forgets to
restart the appliance after refill.
11. When you have got your desired amount of ice, stop the ice making
cycle by pressing the “ON/OFF” key and unplug the unit from the wall
outlet.
12. Open the front cover and transfer the ice to a freezer.
NOTE: Please make the ice maker be rested for 30 minutes before plug
if it has been moved.
3. Open the front cover and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.