5
- 1.2 - MAINTENANCE
MAINTENANCE AND CLEANING THE UNIT
• Make sure the area below the installation place is free from unwanted persons during setup.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or
other particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the
main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe
the part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.
FUSE REPLACEMENT
1. Disconnect this product from the power outlet.
2. Using a screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a good fuse of the same type and rat-
ing (250V/T2A).
4. Screw the fuse holder cap back in place and reconnect power.
TROUBLESHOOTING
Problems Possible causes Checks and remedies
Fixture does not light up
• No mains supply
• Dimmer fader set to 0
• All color faders set to 0
• Faulty LED
• Faulty LED board
• Check the power supply voltage
• Increase the value of the dimmer channels
• Increase the value of the color channels
• Replace the LED board
• Replace the LED board
General low light intensity • Dirty lens assembly
• Misaligned lens assembly
•
• Install lens assembly properly
Fixture does not power up
• No power
• Loose or damaged power cord
• Faulty internal power supply
• Check for power on power outlet
• Check power cord
• Replace internal power supply
Fixture does not respond to DMX
• Wrong DMX addressing
• Damaged DMX cables
• Bouncing signals
• Check control panel and unit addressing
• Check DMX cables
• Install terminator as suggested
Contact an authorized service center in case of technical problems or not reported in the table can not be
resolved by the procedure given in the table.
16
3.12 DMX CONTROL
MODE FUNCTION DMX
Value
12 Ch
10
Auto programs 2
Auto programs 3
Auto programs 4
Auto programs 5
Auto programs 6
Auto programs 7
Auto programs 8
Auto programs 9
Auto programs 10
Auto programs 11
Auto programs 12
Fade programs
Auto programs 0 (Auto 1-12)
028 - 044
045 - 061
062 - 078
079 - 095
096 - 112
113 - 129
130 - 146
147 - 163
164 - 180
181 - 197
198 - 214
215 - 231
232 - 255
11 AUTO SPEED
Auto speed slow to fast 000 - 255
12
DIMMER SPEED
Preset dimmer speed from display menu
Dimmer speed mode1 (fast speed)
Dimmer speed mode2 (middle speed)
Dimmer speed mode3 (slow speed)
000 - 051
052 - 101
102 - 152
153 - 203
204 - 255
MODE FUNCTION DMX
Value
48 Ch
1RED1 000 - 255
2GREEN1 000 - 255
3BLUE1 000 - 255
4AMBER1 000 - 255
5WHITE1 000 - 255
6UV1 000 - 255
7RED2 000 - 255
8GREEN2 000 - 255
9BLUE2 000 - 255
10 AMBER2 000 - 255
11 WHITE2 000 - 255
12 UV2 000 - 255
... ... ...
... ... ...
... ... ...
43 RED8 000 - 255
44 GREEN8 000 - 255
45 BLUE8 000 - 255
46 AMBER8 000 - 255
47 WHITE8 000 - 255
48 UV8 000 - 255
