STEP 4:
Note: The Pedals (No. 27L/R) are marked
"L" and "R" for Left and Right. Make sure
you attach the correct pedal to the
corresponding crank. Attaching the pedal
to the wrong crank can cause irreversible
damage to both the pedal and the crank.
The Bolts (No. 91L/R) are preassembled
to Pedals (No. 27L/R).
Attach Left Pedal (No. 27L) to Left Crank
(No. 29). Turn the Left Pedal (No. 27L)
counter-clockwise with hand until it is
tight, then use Crosshead Spanner (No.
89) to securely tighten. Use Crosshead
Spanner (No. 89) to hold the bolt of the
pedal in place, then use Open Wrench
(No. 92) to screw the Nut (No. 91L)
tightly in a clockwise direction to the
thread end of the Left Pedal (No. 27L).
Attach Right Pedal (No. 27R) to Right
Crank (No. 28). Turn the Right Pedal (No.
27R) clockwise with hand until it is tight,
then use Crosshead Spanner (No. 89) to
securely tighten. Use Crosshead Spanner
(No. 89) to hold the bolt of the pedal in
place, then use Open Wrench (No. 92) to
screw the Nut (No. 91R) tightly in a
counter-clockwise direction to the thread
end of the Right Pedal (No. 27R).
Remove 2 pre-assembled Screws (No.
42) and 2 Flat Washers (No. 43) from the
Main Frame (No. 1).Then attach the
Bottle Holder (No. 66)to the Main Frame
(No. 1) with 2 Screws (No. 42) and 2 Flat
Washers (No. 43) that were removed. Use
a Crosshead Spanner (No. 89) to tighten.
Assembly is now complete!
