Electrical Connection
Before completing any connection, make sure the house voltage corresponds to the voltage
indicated on the label affixed inside the appliance.
It is advisable to call a qualified technician to make the electrical connection.
Appliance fitted with plug
Connect it to a socket which conforms to current regulations. If you intend to connect it directly
to the electric mains, remove the plug and fit an approved bipolar switch with a minimum
contact opening of not less than 3mm.
If the plug is not accessible once it has been inserted in the socket, it will however be
necessary to fit an approved bipolar switch with a minimum contact opening of no less than
3mm.
Appliance without plug
Fit an approved plug or an bi-polar switch with a minimum contact opening of no less than
3mm. The company is not liable for any problems caused by the user’s failure to comply
with the above instructions.
10
Cleaning & Maintenance
Regular maintenance and cleaning ensures good performance and reliability, while
extending the working-life of the appliance.
SURFACE :
Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring
pads, steel wool or solvents on any part of this appliance as this will cause irreparable
damage.
Note:Never use metallic scouring pads or abrasive products that could damage the surface.
ALUMINIUM GREASE FILTERS : Wash in the dishwashers or soak the panels in a
degreasing agent for an hour, then rinse off. The filter must be cleaned at least
once a month or depending on the frequency of appliance usage.
CHARCOAL FILTERS:(only in re-circulating model): Charcoal filter cannot be
reused. They must be replaced once every 6 months or depending on the frequency
of appliance usages to ensure good performance.
LED LIGHT REPLACEMENT:Before attempting to replace the LED light, make sure
that the light switch is turned off. Remove the grease filter to access the LED light.
