Eden 8 Series Manual de usuario

New Zealand: 0508 333 654

Australia: 1800 316 654

What you need to know: Front

•Shade bracket (optional)

•Ridge

•Slopes

•Door track

•Door posts

•Threshold

•Base

•Triangle

•Head section

•Track support arm

•Door brace

•Gussets

•Front brace

•Verticals

•Front sill

What you need to know: Back

•Shade bracket

(optional)

•Ridge

•Slope

•Centre vertical bar

•Rear end brace

•Rear/side sill

•Triangle

•Mitre

•Gusset

•Rear brace

•Vertical

•Base

What you need to know: Middle

Gutter

Side glazing bars

Base

Side brace

Instructions overview:

1. Assemble 2 sides, back, front.

2. Put those four sides together. Keep braces and gussets finger-tight only at this point.

3. Attach the roof and ridge.

4. Attach the roof ventilator

5. Move the whole structure into final position

6. Assemble the door

7. Glaze door while unattached to main structure.

8. Attach the glazed door.

9. If you have a shade kit, attach the aluminium brackets (but obviously not the shade cloth yet).

10. Identify the position for the anchor legs and, if necessary, dig holes for them.

11. Attach anchor legs.

12. Ensure the glasshouse is square and level.

13. Glaze all the lower level glass panels.

14. Attach the louvre on the back at this point (now it has something to sit on) using preloaded bolts.

15. Glaze the louvre.

16. Glaze all the middle level glass panels.

17. Glaze all the roof panels.

18. Glaze front and rear small upper panels.

19. Tighten all bolts up.

20. Re-square and level and, if necessary, concrete in

All 8 series DDHW have the same assembly procedures,

variations are in the length of Ridge, gutter, and sills also the

number of roof and side bars.

When the Glasshouse exceeds 4m in length we make this as an

extension, the join may vary as to where this goes, normally as

near to the middle as possible eg, 816 (5.1m) two units at 2.55m

NOTE: PLEASE READ INSTRUCTION THROUGH FULLY BEFORE ASSEMBLY. SOME PRELOADING OF BOLTS REQUIRED.

When the Glasshouse exceeds 4m in length we make this as an extension, the join may vary as to where this

goes, normally as near to the middle as possible eg, 1016 (5.1m) two units at 2.55m

Note:

All bolts are standard 10mm

size.

Do not fully tighten all bolts

until the glasshouse has been

glazed. This is to allow for

movement of the frame if the

base is not completely level or

square.

Page:

6 & 7 Front & Rear views

9-11 Side Wall Assembly

12-15 Rear Wall

16-18 Front Wall

19 & 20 Extensions

21 & 22 Joining sections together

23 & 24 Attaching Ridge and Roof bars

25-27 Ventilator, assemble & attach

28 & 29 Louvre, assemble & attach

30-32 Doors, assemble, fit and glaze.

33 Attaching End Caps

34 Anchoring Glasshouse

35 Glazing instructions

36 Glazing layout

37 Alternative Base Options

You are now embarking on your journey to build your Eden

glasshouse! If the ride gets rough, don’t hesitate to contact us at

[email protected]. You will build the sides, back and front

separately and then join them together afterwards. Please start by

opening the box/s marked ‘middle’.

Good luck!

For ease of assembly, lay out on the ground or a table with the bolt hole / tracks, top side up, like the internal view.

The model shown here has the Eden

base kit attached. If you did not

purchase this, secure your side sills to

a concrete or wooden sleeper. (see

page 37 for base ideas)

Note:

All bolts are standard 10mm size.

Do not fully tighten all bolts until the

glasshouse has been glazed. This is

to allow for movement of the frame

if the base is not completely level or

square.

Parts needed:

•Gutter

•Side glazing bar (1490mm)

•Bracing angle (1598mm)

•Side sills

•Base

•Nuts and bolts

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Kit de invernadero de Eden

Eden

Eden 10 Series Manual de usuario

Eden

Eden Birdlip Manual de usuario

Eden

Eden Countess Royale 56 Manual de usuario

Eden

Eden Zero-Threshold Series Manual de usuario

Eden

Eden Burford Manual de usuario

Eden

Eden Zero Threshold Birdlip Manual de usuario

Eden

Eden Blockley Manual de usuario

Eden

Eden Blockley Manual de usuario

Manuales populares de Kit de invernadero de otras marcas

ACD PRESTIGE

ACD PRESTIGE MR3 H Manual de usuario

Vitavia

Vitavia VA0040-TRP Manual de usuario

VegTrug

VegTrug Nursery Manual de usuario

Riverstone Networks

Riverstone Networks Monticello 041315V Manual de usuario

STC

STC Easy Grow 6x12 Greenhouse Manual de usuario

CLIMA POD

CLIMA POD Spirit V7 Series Manual de usuario

Vitavia

Vitavia GAIA JUMBO Manual de usuario

Palram

Palram Harmony 6'x4' Manual de usuario

ClearSpan

ClearSpan Storage Master 104598 Manual de usuario

Sproutwell

Sproutwell GRANGE - 5 Manual de usuario

ACD

ACD Piccolo 03 Manual de usuario

Growhouse

Growhouse Lean To 6 x 8 Manual de usuario

Riverstone Networks

Riverstone Networks Grower's 181010V Manual de usuario

GrowSpan

GrowSpan 500 Series Manual de usuario

Robinsons

Robinsons 5ft Wide LEAN-TO Manual de usuario

Botanica

Botanica E Manual de usuario

PNI

PNI SP6000 Manual de usuario

Hortus

Hortus 211-203 Manual de programación