1.3: MDVR NOTICE:
Tomake sure MDVRsafety use, acquiresatisfactory performance, andextend the servicelife
of the equipments, please fullyconsider the followingfactors when installthe equipment :
1.When install andoperate the equipment, please obeyall the electronic products guide, vehicles
and other connectionequipments requirements
2.Power supply andequipment grounded :Direct input rangeof the machinepower supply isfrom
DC 8V-36V, please dont get inverse,and.inputcan t be shortcircuit.Please note thepower supply
capacity of thepower line. Eventhe equipment isshut down ,it may becharged . pleaseavoid short
circuit . Beforeconnect with otherexternal devices, pleasecut the connectionbetween this
equipment and thepower supply.The input modeof equipment sensoris level mode, with external
voltage below 4Vis considered aslow level ,above 4V andbelow 30V isconsidered as highlevel.
Beyond 30V willdamage the equipment.Correctly connect theearth wires ofthe device andthe
vehicle and forma loop; Ifdon t use themachine for along time .It s better tocut the powersupply
completely to extend the service life
3.Humidity requirements :Install equipment indry environment, avoiddamp, water-drop, water
spray and otherplaces. Don't takethe equipment installedin places wherewater will sagor wet
places liquid willdrip down ;Do not usewet hand totouch the equipment,Donot stand inthe water
or touch withother water placeswhile contact theequipment, it mayget electric shock
4.Installation position:
Toextend the lifeof the equipment,please try toinstall it inplace with weakvibration, such as
behind the driver'sseat .The equipmentshould be installedon the vehicle'sventilation installation
part .Equipment installedon the planeshould remain adistance of 6inches (15 centimeters)
away from otherobjects to assurethe air flowand heat dissipation; Don't installit on theenclosed
area, such ascar trunk. Thismachine can beright side installedor side loading.The equipment s
external wiring musthave the enoughintervals and externalflame retardant protection, to ensure
the wire notto be bentor leakage ofelectricity due towear and vibration;Ensure that equipment
away from heatsource of thevehicle, the equipmentcan't have sundrypile up around,prohibit
placing anything onthe equipment .
5.Equipment safety:
Ensure passengers orthe driver can'tintervene and damagethe equipment unit,camera, wire and
other accessories .Don't install theequipment near othercomponents of vehicle; When install
equipment components, camera,accessories and wire,launch vehicles maycause damage tothe
equipment, Keep thevehicles static duringthe installation process,to prevent equipmentfalling
from vehicles.
'
'
''
'
Installation notes:
1.Equipment contains theelectronic devices, pleasehandle gently duringtransport .
2.All installation andmaintenance must beexecuted by theprofessional qualified person.
3.This product cant be installed in partof the vehiclewhere there waserosion by rainor other
liquid for along time .
4.Installation and allmaterials must beable to withstandthe weight ofthe fuselage.
5.Keep fuselage awayfrom the heatsource, dust andstrong magnetic fields.
6.Do not putheavy objects onthe equipments.
7.Don't flush theequipment directly whileclean the Vehicles .
8.The equipment outputpower shall notconnect to devicesthat are notrecommended.
9.Don't insert fingeror some objectsfrom the gapwhile operate theequipments.
10.Without professional guide,please do notopen or unloadthe equipment.
11.Don't changeany modules whenthe mainframe ischarged.
'
3
SD CardMobile DVRUser Manual
3
