ECS P4IBAD2 Manual de usuario

Preface

This publication, including all photographs, illustrations and software, is protected un-

of the material contained herein, may be reproduced without writtenconsent ofthe au-

thor.

Version 1.0

Disclaimer

The information in this document is subject to change without notice. The manufac-

turer makes no representations or warranties with respect to the contents hereof and

specifically disclaims any implied warranties of merchantability or fitness for any par-

ticular purpose. The manufacturer reserves the right to revise this publication and to

make changes from time to time in the content hereof without obligation of the manu-

facturer to notify any person of such revision or changes.

Trademark Recognition

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.

MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel

Corporation.

Other product names used in this manual are the properties of their respective owners

and are acknowledged.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B digi-

tal device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not in-

stalled and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not oc-

cur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

−Reorient or relocate the receiving antenna.

−Increase the separation between the equipment and the receiver.

−Connect the equipment onto an outlet on a circuit different from that to which

the receiver is connected.

−Consult the dealer or an experienced radio/TV technician for help.

Shielded interconnect cables and a shielded AC power cable must be employed with

this equipment to ensure compliance with the pertinent RF emission limits governing

this device. Changes or modifications not expressly approved by the system's manu-

facturer could void the user's authority to operate the equipment.

Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the follow-

ing conditions:

−This device may not cause harmful interference, and

−This device must accept any interference received, including interference

that may cause undesired operation.

Canadian Department of Communications

This class B digital apparatus meets all requirements of the Canadian Interference-

causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement

sur le matériel brouilieur du Canada.

About the Manual

The manual consists of the following:

Chapter 1

Introducing the Mainboard Describes features of the mainboard,

and provides a shipping checklist.

Go to ⇒page 1

Chapter 2

Installing the Mainboard Describes installation of mainboard

components.

Go to ⇒page 7

Chapter 3

Using BIOS Provides information on using the BIOS

Setup Utility.

Go to ⇒page 25

Chapter 4

Using the Mainboard Software Describes the mainboard software.

Go to ⇒page 45

iii

Preface i

Features and Packing List Translations 錯誤! 尚未定義書籤。

CHAPTER 1 1

Introducing the Mainboard 1

Introduction............................................................................................................1

Checklist.................................................................................................................1

Standard Items...................................................................................................1

Features..................................................................................................................2

Choosing a Computer Case................................................................................4

Mainboard Components.......................................................................................5

CHAPTER 2 7

Installing the Mainboard 7

Safety Precautions................................................................................................7

Quick Guide...........................................................................................................7

Installing the Mainboard in a Case.....................................................................8

Checking Jumper Settings...................................................................................8

Setting Jumpers.................................................................................................8

Checking Jumper Settings .................................................................................9

Jumper Settings .................................................................................................9

Connecting Case Components.........................................................................10

Front Panel Connector.....................................................................................12

Installing Hardware.............................................................................................13

Installing the Processor ...................................................................................13

Installing MemoryModules............................................................................16

Installing a Hard Disk Drive/CD-ROM..........................................................17

Installing a Floppy Diskette Drive..................................................................18

InstallingAdd-on Cards...................................................................................19

Connecting Optional Devices..........................................................................21

ConnectingI/ODevices.....................................................................................23

External Connector Color Coding...................................................................24

CHAPTER 3 25

Using BIOS 25

About theSetup Utility........................................................................................25

The Standard Configuration............................................................................25

Entering the Setup Utility................................................................................26

Updating the BIOS..........................................................................................26

Using BIOS..........................................................................................................27

Standard CMOS Features................................................................................28

Advanced BIOS Features ................................................................................30

Advanced Chipset Features.............................................................................32

Integrated Peripherals......................................................................................34

Power Management Setup...............................................................................37

PNP/PCI Configurations.................................................................................40

PC Health Status..............................................................................................41

Frequency/Voltage Control..............................................................................42

Load Fail-Safe Defaults Option......................................................................43

Load Optimized Defaults Option....................................................................43

Set Supervisor/User Password.........................................................................43

Save & Exit Setup Option...............................................................................44

Exit Without Saving........................................................................................44

CHAPTER 4 45

Using the Mainboard Software 45

About the Software CD-ROM............................................................................45

Auto-installing under Windows 98/ME/2000/XP............................................45

Running Setup.................................................................................................46

Manual Installation..............................................................................................48

Utility Software Reference.................................................................................48

Introducing the Mainboard

Congratulations on purchasing the P4IBAD2 mainboard. The P4IBAD2 main-

board is an ATX mainboard that uses a 4-layer printed circuit board and

measures 304.8 mm x 220 mm. The mainboard features a mPGA478 Socket

that accommodates Intel Pentium 4 Willamette/ Northwood processors sup-

porting system speeds up to 400/533 MHz and data bus bandwidths up to 3.2

GB/s.

The mainboard comes with a full set of I/O features conveniently integrated on

the rear I/O panel, includingsupport for PS/2 keyboard and mouse connectors,

two USB ports, a LAN connector, two high-speed serial port, an EPP/ECP

parallel port, audio jacks for microphone, line-in, line-out and CD-in and a

game port, as well as supporting Plug and Play.

The P4IBAD2 incorporates the Intel i82845 (MCH) and the Intel 82801BA

(ICH2) chipsets, which supports 2.5V DDR DRAM, 2X/4X AGP (1.5V only),

andtheAC’97 codec.

Compare the mainboard’s package contents with the following checklist:

Standard Items

•One mainboard

•One diskette drive ribbon cable

•One IDE drive ribbon cable

•Software support CD

•Retention Module

•This user’s manual

ProcessorThe P4IBAD2 mainboard uses a mPGA478 Socket that has

the following features:

•Accommodates Intel Pentium 4 478-pins CPU

•Supports a system bus (FSB) of 400/533 (enhanced)

MHz

•Supports 3.2 GB/s data bus bandwidth

Chipset Intel’s innovative i82845 (MCH) and 82801BA (ICH2) chipsets

are based on an innovative and scalable architecture with

proven reliability and performance. A few of the advanced

features of the chipsets are:

•Host interface controller supports 400 MHz frontside (sys-

tem) bus frequency

•Supports 266 MHz DDR SDRAM devices

•Supports a max of 2 Double-Sided DIMMs (4 rows popu-

lated) with unbuffered DDR266 (w/ or w/out ECC).

•Supports a maximum memory bandwidth of 2.1 GB/s with

DDR266

•AGP controller is AGP 2.0 compliant and supports 2x/4x

Fast Write Protocol (1.5V only)

•PCI IDE controller supports PCI bus mastering, PIO

modes 0~4, and UDMA 33/66/100

•Two USB controllers double the bandwidth to 24 Mbps

across four ports

•Integrated AC’ 97 audio that supports full surround sound

with up to six channels

Additional key features include support for an AC 97 link for audio

and modem, hardware monitoring, and ACPI/OnNow power man-

agement.

Memory •Supports DDR up to 200/266/333 (enhanced) MHz DDR

SDRAM memory module

•Accommodates two unbuffered 2.5V 184-pin slots

•Each slot supports up to 1 GB with a total maximum

capacity of 2 GB

AGP The P4IBAD2 includes a 4xAGP slot that provides four times the

bandwidth of the original AGP specification. AGP technology pro-

vides a direct connection between the graphics sub-systemand

the processor so that the graphics do not have to compete for

processor time with other devices on the PCI bus.

Audio •Compliant with AC’97 codec

•Supports 4.1/5.1 speakers, C3DX positional audio in 4/6

channel speaker mode

•6 channel DAC for AC3® 5.1channel purpose

•Professional digital audio interface supporting 24-bit

SPDIF IN and OUT (44.1K and 48K format)

•Compatible with legacy audio SBPRO™

USB 2.0

(optional) The built-in VIA VT6202 PCI USB 2.0 Controller is compliant

with Universal Serial Bus Specification Revision 2.0.

The USB 1.1 connectors and other full speed cables can sup-

port the higher speed of USB 2.0 without any changes.

The chipset has the following advanced USB features:

•Integrated multi-PCI function in a single chip including two

UHCI host Controllers for low/full speed data transactions

and one EHCI host controller for high-speed data transac-

tions

•Four downstream ports, each port providing full support

for low/full/high speed data rates

•YSB device wake-up function support

•Legacy function support

•PCI Specification Revision 2.2 compliant

•PCI Bus Power Management Interface Revision 1.1 com-

pliant

•3.3V/2.5V multi-power supply and 3.3V suspend power

for wake-up function

Expansion

Options The mainboard comes with the following expansion options:

•Six 32-bit PCI slots

•One 4xAGP slot (support 1.5V only)

•One Communications Network Riser (CNR) slot

•Two IDE connectors which support four IDE channels and

a floppy disk drive interface

The P4IBAD2 supports Ultra DMA bus mastering with transfer

rates of 33/66/100 MB/sec.

Integrated I/O The mainboard has a full set of I/O ports and connectors:

•Two PS/2 ports for mouse and keyboard

•Two serial ports

•One parallel port

•One MIDI/game port

•Two USB ports

•Audio jacks for microphone, line-in and line-out

BIOS

Firmware This mainboard uses Award BIOS that enables users to con-

figure many system features including the following:

•Power management

•Wake-up alarms

•CPU parameters and memory timing

•CPU and memory timing

The firmware can also be used to set parameters for different

processor clock speeds.

There are many types of computer cases on the market. The mainboard com-

plies with the specifications for the ATX system case. Some features on the

mainboard are implemented by cabling connectors on the mainboard to indi-

cators and switches on the system case. Ensure that your case supports all

the features required. The mainboard can support one or two floppy diskette

drives and four enhanced IDE drives. Ensure that your case has sufficient

power and space for all the drives that you intend to install.

Most cases have a choice of I/O templates in the rear panel. Make sure that

the I/O template in the case matches the I/O ports installed on the rear edge

of the mainboard.

This mainboard has an ATX form factor of 304.8 mm x 220 mm. Choose a

case that accommodates this form factor.

Table of Mainboard Components

Label Component

AGP1 Accelerated Graphics Port (supports 1.5V 4x AGP card only)

ATX1 Standard 20-pin ATX power connector

AUDIO1 Mic/SpeakerOut header

BAT1 Three volt realtime clock battery

CASFAN1 Case fan connector

CDIN1 CD-in connector (Panasonic)

CDIN2 CD-in connector (Sony)

CHS1 Chassis Detect Intrusion

CPUFAN1 Cooling fan for CPU

CNR1 Communications Networking Riser slot

CPU Socket CPU socket (mPGA478)

DIMM1 ~ DIMM2 Two 184-pin DDR sockets

FDD1 Floppy disk drive connector

IDE 1 Primary IDE channel

IDE 2 Secondary IDE channel

JP1 Clear CMOS jumper

JP2 BIOS protect jumper

JP4 Onboard USB jumper

LSJ1 Single color LED header (comply with OEM specs. only)

PANEL1 Front panel connectors for case switches and LEDs

PCI1 ~ PCI6 Six 32-bit add-on card slots

PWRFAN1 Power fan connector

SIR1 Serial IR port

SPEAKER1 Speaker connector

SJ1 Single color LED header

USB1 Front panel USB headers

This concludes Chapter 1. The next chapter explains how to install the main-

board.

Tabla de contenidos

Otros manuales de Placa madre de ECS

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario