Ecom Instruments Ex-Handy 06 Instrucciones de instalación
Ex-Handy 06
Safety instructions
18
Contents
1. Application 19
2. Safety precautions 19
3. Faults and damage 19
4. Safety regulations 20
5. Ex-Data 22
6. Technical specifications 22
7. SAR certification 23
8. Button functions 24
9. Rechargeable battery and commissioning 25
9.1 Changing the battery 25
9.2 Commissioning 25
9.3 Safety instructions 27
10. Repair 28
11. Cleaning, maintenance and storage 29
12. Disposal 29
13. Warranty and liability 30
14. EC Declaration of Conformity 32
15. EC type approval test certificate 33
Note:
The current safety precautions, operating instructions, EC Declara-
tion of Conformity and the EC type approval test certificate can be
downloaded from the relevant product page at www.ecom-ex.com, or
alternatively they can be requested directly from the manufacturer.
19
1. Application
The Ex-Handy 06 is an explosion-shielded, water-, dust- and impact-
resistant mobile phone for industrial application in areas with an
increased risk of explosion in zones 1, 2, 21 and 22 in accordance
with directive 1999/92/EC (ATEX 137) and 94/9/EC (ATEX 95).
2. Safety instructions
These safety instructions contain information and safety regula-
tions which are to be observed without fail for safe operation in
the described conditions. Non-observance of this information and
these instructions can have serious consequences or it may violate
regulations.
Please read these operating instructions carefully before starting to
use the unit! In the event of conflicting information the details speci-
fied in the safety precautions shall apply.
In case of any doubt (in the form of translation or printing errors) the
German version shall apply.
3. Faults and damage
If there is any reason to suspect that the safety of the unit has been
impaired, it must be withdrawn from use and removed immediately
from the Ex-area. Measures must be taken to prevent it from being
restarted accidentally.
The safety of the unit may be compromised, if, for example:
- there is visible damage to the housing.
20
- the unit has been subjected to excessive loads.
- the unit has been improperly stored.
- the unit has been damaged in transit.
- unit markings or inscriptions are illegible.
- malfunctions occur.
- permitted limit values have been exceeded.
4. Safety regulations
Use of the explosion-proof mobile phone Ex-Handy 06 assumes that
the operator complies with conventional safety regulations and has
read the certificate in order to eliminate faulty operation of the unit.
The following points are to be observed:
- The unit is to be protected from increased impact.
- The unit should not be opened inside the Ex-area.
- The battery module may not be changed inside the Ex-area!
- The battery module may only be charged outside the Ex-area and
only then using the following appropriate chargers:
battery charger DSA-0051-05C, DSC-6PFA-05 or car charger
ALX 20. Data synchronization and charging via USB data cable
PCX 20 connected to a commercially digital evaluation device (eg
personal computer) tested according to EN 60950.
The USB signals are specified to Um = 6 V.
- The battery module may only be charged in a temperature range of
0 °C - 45 °C.
- Only accessories approved by ecom instruments GmbH may be
used.
21
- Observe the corresponding laws that are in force in the respecti-
ve country regarding the use of mobile phones while operating a
vehicle!
- Use of the mobile phone in an airplane is not permitted!
- Switch off the mobile phone when in close proximity to medical
instruments and if you are requested to do so by corresponding
regulations!
- Manufacturers of cardiac pacemakers recommend a minimum
distance of 15.3 cm (6“) is maintained between a mobile phone and
a pacemaker.
- Do not switch on the mobile phone when the use of such devices is
prohibited, as it may cause interference or result in danger.
- Only the original battery module AMX 60 Ex-AMH 06 (Li-Ion 3,7V)
should be used!
- The charging socket cover must be firmly engaged in the unit.
- When changing the battery the unit and the battery terminals are to
be checked for cleanliness and cleaned, if necessary.
- It must be ensured that the unit is not taken into zones 0 or 20!
22
5. Ex-Data
Certificate of Conformity no.: PTB 10 ATEX 2009 X
Ex-designation: II 2G Ex ib IIC T4
II 2D Ex ibD 21 T130°C
Ex-Handy 06
Approved for zone 1, device group II, explosion group IIC (explosive
gases, vapours or mist), temperature class T4.
Approved for zone 21, device group II, dust Ex-atmosphere, max. sur-
face temperature (for surfaces on which dust can develop) +130 °C.
6. Technical specifications
Networks:
GSM 900 MHz
1800 MHz
1900 MHz
Power supply: Battery module Ex-AMH 06
Dimensions: 119 x 57 x 30 mm
Weight: approx. 200 g
CE-designation: 0 0102
Ambient temperature: -20 °C ... +50 °C
Protection rating: IP 67
23
7. SAR certification
When communicating over the wireless network, the mobile phone
emits low radio waves known as radio frequency energy or RF. The
Specific Absorption Rate or SAR is the unit used to measure the
amount of RF energy absorbed by the body while using the phone
and is expressed in watts/kilogram. In compliance with the product
standards in EN 50360:2001, the allowed limit of SAR averaged for
10g tissue is 2.0 (W/kg). The localised (SAR) of the portable Ex-Handy
06 device has been measured in all cases as requested by the relevant
international standards.
The maximum localised SAR value for which the device has been
tested and certified for specific exposure limits and different network
bands is given below:
Maximum SAR
GSM900 MHz Band
0,663 W/kg Head SAR
DCS1800 MHz Band
0,198 W/kg Head SAR
24
8. Button functions
Volume control
Phonebook/
PTT-function
Left
selection
button
Accept/Make-
call button
Press and hold
to access
the mailbox
Press and hold
to lock/unlock
the keypad.
For entering a ‚+‘ for
international numbers
Press and hold
to activate/
deactivate
the silent mode.
To activate/
deactivate the loud-
speaker during a call.
To display the ring
type menu in the
standby mode.
On/Off/Call
end button
Right selection
button
Flashlight
disabled for
Ex-protection
Menu
button
Navigation buttons
(up/down/left/right)
Charging socket cover
25
9. Rechargeable battery and commissioning
9.1 Changing the battery
The battery module Ex-AMH 06 of the Ex-Handy 06 may only be
changed outside the Ex-area. Only those battery modules which are
approved by the manufacturer for your device type may be used (see
Safety regulations under point 4). Other battery modules may not be
taken into the Ex-area.
9.2 Commissioning
1) Inserting the SIM:
Slide the charcoal colored card holder
to the right and carefully lift the SIM
card holder. Insert the SIM card into the
designated holder in the lower part of the
phone.
2) Securing the SIM:
Lower the SIM card holder. Slide the card
holder gently to the left over the SIM card.
26
3) Inserting the battery
Insert the battery into the recesses on the lower side of the battery
compartment. Then press the battery against the device and turn the
screws of the battery clockwise. The screws should only be tightened
by hand! The phone should not be connected to the charger if the
battery has not been assembled.
4) Charging the phone:
The battery supplied with the phone is not
fully charged. It is recommended to char-
ge the phone for three hours before using
it for the first time. The full capacity of
the battery is reached after 4-6 complete
charge/discharge cycles.
NOTE - There is a risk of explosion if the battery is not exchanged
properly or if it is exposed to a flame. Do not short-circuit the battery.
The battery does not contain any parts that can be exchanged.
The casing of the battery should not be opened under any circum-
stances. Only use ecom charging accessories (see point 4).
IMPORTANT:
To ensure the IP protection rating the screws should
only be tightened by hand!
Tabla de contenidos
Otros manuales de Teléfono móvil de Ecom Instruments
Ecom Instruments
Ecom Instruments Ex-GSM 01 EU Manual de usuario
Ecom Instruments
Ecom Instruments x.com 400/401 Manual de usuario
Ecom Instruments
Ecom Instruments Ex-CDMA 02 Instrucciones de instalación
Ecom Instruments
Ecom Instruments XP3410 IS Instrucciones de instalación
Ecom Instruments
Ecom Instruments Ex-Handy 05 Manual de usuario
Ecom Instruments
Ecom Instruments Ex-Handy 05 Instrucciones de instalación
Ecom Instruments
Ecom Instruments x.com 500-Ex Instrucciones de instalación
Ecom Instruments
Ecom Instruments Ex-Handy 05 Manual de usuario
Ecom Instruments
Ecom Instruments Ex-GSM 01 Instrucciones de instalación
Ecom Instruments
Ecom Instruments X.COM 21x -Ex Instrucciones de instalación
