Important Safety Instructions
1.
“WARNING: To reduce the risk of injury, do not permit children to operate this device.”
2.
“WARNING: heavy pool (or spa) usage, and higher temperatures may require higher chlorine output to maintain
proper free available chlorineresiduals.”
3.
“If additional chlorine is required due to heavy bather loads, use Sodium Hypochlorite (Liquid Chlorine) to
maintain an appropriate chlorine residual in the water.”
4.
“Maintaining high salt and chlorine levels above recommended range can contribute to corrosion of pool or spa
equipment.”
5.
“DO NOT add pool or spa chemicals directly to the skimmer. This may damage thecell.”
6.
“Check the expiry date of the test kit as test results may be inaccurate if used after that date.”
7.
“The life expectancy of the electrolytic cell is 30,000 hours under normal use conditions.”
8.
“When replacing the cell, only use replacement cells having a label that clearly states that it is a replacement cell
for the chlorine generating device ECO-matic COMM 2400 Automatic Chlorine Generator unit.,
REGISTRATION NUMBER 30297
PEST CONTROL PRODUCTSACT
.”
9.
“Follow all aspects of the local and National Electrical Code(s) when installing the ECO-matic COMM 2400
Automatic Chlorine Generator unit.”
10.
“NOTE: For outdoor pools, chlorine residuals can be protected from destruction by sun light by
addition of stabilizer (cyanuric acid).
11.
“For proper sanitation, spas must be completely drained periodically. The number of days between
COMPLETE SPA DRAINAGE is equal to the volume of spa water in litres, divided by 10 times the maximum
number of daily spa users. Refill spa with water and repeat DIRECTIONS FOR USE of thedevice.”
12.
Do not use this device with bromide products.
Health and Hyperthermia warnings for spas:
1.
“People with a medical condition should consult a physician before entering pool or spawater.”
2.
“Maximum spa water usage temperature is 40°C. Bathing in spa water at 40°C should not exceed 15 minutes.
”When installing and using this electrical equipment, basic safety precautions should always be followed, including
the following:
1.
READ AND FOLLOW ALL INSTRUCTIONS
2.
A green colored terminal or a terminal marked G, GR, Ground, Grounding, or the international ground
symbol is located inside the power control box (‘power supply’). To reduce the risk of electric shock, this
terminal must be connected to the grounding means provided in the electric supply panel with a continuous
copper wire equivalent in size to the circuit conductors supplying thisequipment.
3.
At least two lugs marked ‘Bonding Lugs’ are provided on the external surface or on the inside of the power
control box (‘power supply’). To reduce the risk of electric shock, connect the local common bonding grid in
the area of the hot tub or spa or pool to these terminals with an insulated or bare copper conductor not smaller
than No. 6 AWG.
