Eaton Powerware 5115A USB Manual de usuario
POWERWARE®5115A USB
User’s Guide
500-1400 VA
www.powerware.com.au
5115AUSBManual.qxd Rev 1
© Copyright 2004, Powerware. All rights reserved.
Powerware is a registered trademark and Advanced Battery Management (ABM) is a trademark of Powerware Corporation.
Where the brand name “Powerware” is used,
the term refers to Eaton’s Powerware Division, trading in Australia
as Eaton Power Quality Pty Ltd
POWERWARE®5115A USB
500-1400 VA
User’s Guide
www.powerware.com.au
Special Symbols
The following are examples of symbols used on the UPS to alert you to important information.
CAUTION To reduce the risk of electric shock,
Do not remove cover (or back)
No user-serviceable parts inside
Refer servicing to the factory
CAUTION
Risk of Electric Shock
Do Not Open Cover
RISK OF ELECTRIC SHOCK - Indicates that a risk of electric shock is
present and the associated warning should be observed.
CAUTION: REFER TO OPERATOR’S MANUAL - Refer to your operator’s
manual for additional information, such as important operating and
maintenance instructions.
SAFETY EARTHING TERMINAL - Indicates the primary safety ground.
LOAD ON/OFF - Press the button with this symbol to energise the output
receptacles ( indicator illuminates) or to de-energise the output
receptacles ( is off).
RJ-45 RECEPTACLE - This receptacle provides network interface
connections. Do not plug telephone or telecommunications equipment into this
receptacle.
This symbol indicates that you should not discard the UPS or the UPS
batteries in the trash. The UPS may contain sealed, lead-acid batteries.
Batteries must be recycled.
TABLE OF CONTENTS
1 Powerware 5115 -Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Inspecting the Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Installing the UPS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
UPS Rear Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
3 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Turning the UPS On . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Starting the UPS on Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Turning the UPS Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Standby Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
UPS Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Initiating the Self-Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
4 Additional UPS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Communication Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
USB Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Network Transient Protector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
5 UPS Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
UPS and Battery Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Storing the UPS and Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Replacing Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Testing New Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
Recycling the Used Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
6 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
7 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
Audible Alarms and UPS Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
Silencing an Audible Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25
Service and Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29
8 Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31
1
Powerware®5115A USB User’s Guide • www.powerware.com.au
Figure 1. Powerware 5115
CHAPTER 1
POWERWARE 5115 - INTRODUCTION
The Powerware 5115 uninterruptible power system (UPS) protects your sensitive
electronic equipment from power problems such as power failures, power sags, power
surges, brownouts, and line noise.
Power failure can occur when you least expect it and power quality can be erratic.
Power problems have the potential to corrupt critical data, destroy unsaved work
sessions and damage hardware - causing hours of lost productivity and expensive
repairs.
With the Powerware 5115, you can safely eliminate the effects of power disturbances
and guard the integrity of your equipment. The Powerware 5115’s flexibility to handle an
array of network devices makes it the perfect choice to protect your LANs, servers,
workstations and other electrical equipment.
2Powerware®5115A USB User’s Guide • www.powerware.com.au
Powerware 5115 - Introduction
Because an integral part of power protection is power management software, the
Powerware 5115 comes fully equipped with a communication port, USB port, serial
cable and a CD containing both LanSafe III for networked systems and FailSafe III for
standalone systems.
Providing outstanding performance and reliability, the Powerware 5115’s unique benefits
include the following:
• Advanced Battery Management (ABM ™) doubles battery service life, optimises
recharge time and provides advanced warning before the end of battery life.
• Buck and Boost voltage regulation ensures consistent voltage to your load by
correcting voltage fluctuations.
• Hot-swappable batteries simplify maintenance by allowing you to replace
batteries safely without powering down the critical load.
• Network Transient Protector guards your modem, fax machine and other network
communications equipment from surges.
• Start-on-battery capability allows you to power up the UPS even if utility power
is not available.
• The Powerware 5115 is backed by worldwide agency approvals.
3
Powerware®5115A USB User’s Guide • www.powerware.com.au
CHAPTER 2
INSTALLATION
This section explains
• Equipment inspection
• Safety precautions
• UPS Installation
• UPS rear panels
Inspecting the Equipment
If the UPS has been damaged during shipment, contact your vendor immediately.
Safety Precautions
Read the following precautions before you install the UPS.
SAVE THESE INSTRUCTIONS.
This manual contains important instructions that you should follow during installation and
maintenance of the UPS and batteries. Please read all instructions before operating the
equipment and save this manual for future reference.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
• This UPS contains its own energy source (batteries). The output receptacles
may carry live voltage even when the UPS is not connected to an AC supply.
• Do not remove or unplug the input cord when the UPS is turned on. This
removes the safety ground from the UPS and the equipment connected to the
UPS.
• To reduce the risk of fire or electric shock, install this UPS in a temperature and
humidity controlled, indoor environment, free of conductive contaminants.
Ambient temperature must not exceed 40oC. Do not operate near water or
excessive humidity (95% max).
• To comply with international standards, the sum of earth leakage current from
the load connected to the UPS must not exceed 1.5 mA.
4Powerware®5115A USB User’s Guide • www.powerware.com.au
Installation
Installing the UPS
The following steps explain how to install the UPS. Figure 2 shows a typical installation
only. See “UPS Rear Panels” on page 6 for the rear panel of each model.
1. If you are installing power management software, connect your computer
to the USB port of UPS communication port using the supplied
communication cable.
2. Plug the power cord supplied into the input connector on the UPS rear
panel.
3. Plug the UPS power cord into a power outlet.
Figure 2. Typical UPS Installation
Tabla de contenidos
Otros manuales de Unión Postal Universal de Eaton
Eaton
Eaton 3S Instrucciones de montaje
Eaton
Eaton 5S 1000VA Manual de usuario
Eaton
Eaton EX 700 Manual de usuario
Eaton
Eaton 3S550IEC Manual de usuario
Eaton
Eaton SPM Series Manual de usuario
Eaton
Eaton Powerware 5125 Manual de usuario
Eaton
Eaton Powerware 5130 Manual de usuario
Eaton
Eaton EX 700 Manual de usuario
Eaton
Eaton Powerware 9155 Manual de usuario
Eaton
Eaton Power Xpert 9395 Manual de usuario
Eaton
Eaton 93P Manual
Eaton
Eaton Evolution 650/650 Rack 1UEvolution 850 Manual de usuario
Eaton
Eaton Powerware 5115 Manual de usuario
Eaton
Eaton Powerware 9355 Manual de usuario
Eaton
Eaton Power Xpert 9395P Manual de usuario
Eaton
Eaton UPS 225275 kVA Powerware 9395 Guía de solución de problemas
Eaton
Eaton 9315 Manual de usuario
Eaton
Eaton 5P 1550G RL Manual de usuario
Eaton
Eaton Power Xpert 9395 Manual de usuario
Eaton
Eaton 9393PM Manual
Manuales populares de Unión Postal Universal de otras marcas
Pylontech
Pylontech Victron & Pylontech US5000 Manual de usuario
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manual de usuario
Mecer
Mecer ME-1000-WTU Manual de usuario
Mustek
Mustek PowerMust 530(B) Plus Manual de instalación y operación
Emerson
Emerson Liebert NXL series Manual de usuario
MAKELSAN
MAKELSAN BOXER SERIES Manual de usuario
