Eaton Powerware 5110 Manual de usuario
Powerware 5110 UPS
User’s manual
©2005 Eaton Corporation
All Rights Reserved
The contents of this manual are the copyright
of the publisher and may not be reproduced (even extracts)
unless permission granted.
Every care has been taken to ensure the accuracy of
the information contained in this manual, but no liability
can be accepted for any errors or omission. The right
to make design modifi cations is reserved.
Powerware 5110 UPS
U
ser
’
s manua
l
1023922 Revision A
Contents
Introduction
.................................................................................................
4
Features:
...................................................................................................................
4
Unit inspection
.........................................................................................................
4
Requesting for CE-declaration
................................................................................
4
Safety Instructions
......................................................................................
5
Battery connection required before use!
.....................................................
6
Connecting the Battery:
...........................................................................................
6
Installation and Operation:
..........................................................................
6
Typical applications
.................................................................................................
7
Indicators
....................................................................................................
7
Indicator table
.............................................................................................
9
Status Indicators
......................................................................................................
9
LED Indicator Table
..................................................................................................
9
LED Audible Alarm Table
........................................................................................
9
Battery replacement procedure:
..................................................................
9
Troubleshooting
.....................................................................................................
1
2
Specifi cation*:
........................................................................................................
1
3
Service and Support
..................................................................................
1
4
User’s manual
350 - 1500 VA
4
1023922
Revision A
Introduction
The Powerware 5110 uninterruptible power system (UPS) fi lters the input line from
line disturbances and protects your sensitive electronic equipment from fi ve common
power problems such as power failures, power sags, power surges, over-voltage and
under- voltage.
Features:
Processor-controlled voltage regulation (AVR)
Eight outlets:
- Four with surge and backup protection
- Four with surge protection only
Data Line (Internet fax – modem – DSL) or telephone line surge protection
Cold start capability
USB communication port
User-replaceable batteries
Unit inspection
Once you have received the Powerware 5110 UPS product, you should remove the
package and inspect the product for shipping damage. If any damage is found, please
notify the carrier and your dealer. Please keep the shipping carton and the packing
foam in the event the product must be returned to the factory for service.
Requesting for CE-declaration
Can be downloaded from
http://www.powerware.com/Service_support/EMEA_certifi cates.asp
Eaton Power Quality Oy
Koskelontie 13, FIN-02920 Espoo Finland
Phone: +358-9-452 661
Fax: +358-9-452 66 396
•
•
•
•
•
•
User’s manual
350 - 1500 VA
5
1023922
Revision A
Safety Instructions
ATTENTION
Maintenance, other than battery replacement must be performed by a
qualifi ed technician. Failure to do so could result in an electrical shock.
Although the unit may be unplugged from utility power, hazardous
voltage still may be present through the battery.”
1. Place the Powerware 5110 UPS indoors in an area that has adequate airfl ow and
is free of excessive dust. Do NOT allow the UPS to be exposed to moisture, rain,
excessive heat, or direct sunlight.
2. Use of the Powerware 5110 UPS product in life support applications, where failure
of this equipment can reasonably be expected to cause failure of life support
equipment or to signifi cantly affect its safety or effectiveness is NOT recommended.
3. Shut off the UPS and disconnect the input power cord from the wall outlet before
replacing the battery.
4. When replacing the battery, use the same number and type of battery
5. Do NOT dispose of battery in a fi re. The battery may explode.
6. Do NOT open or mutilate the battery. They contain an electrolyte that is toxic and
harmful to the skin and eyes.
7. Proper disposal of the battery is required. Please refer to your local laws/
regulations regarding battery disposal.
8. Use tools with insulated handles to replace the battery to avoid personal injury.
Due to energy hazard, please remove wristwatches and jewelry such as rings when
replacing battery.
User’s manual
350 - 1500 VA
6
1023922
Revision A
Battery connection required before use!
Connecting the Battery:
Principal shown below for detailed information how to connect please refer to battery
replacement section.
Installation and Operation:
Following steps explain how to connect and operate the Powerware 5110 UPS.
1. Connect the UPS to a grounded power outlet.
2. Plug your computer, monitor or load to be protected into the “Battery Backup &
Surge Protection” outlets. (These outlets will provide emergency battery backup
power during power outages as well as protection from surges and spikes.)
Do NOT plug LASER PRINTERS into the “Battery Backup” outlets.
Do NOT plug ACCESSORY SURGE strips into the “Battery Backup” outlets.
3. Plug your peripheral equipment or non-critical loads (printer, scanner, fax, speaker,
etc.) into the “Surge Protection” outlets. (These outlets provide surge and spike
protection only, they will NOT provide battery backup power during a utility power
failure).
4. With your equipment turned off, switch on the UPS.
5. When the “On/Off” LED light is illuminated, turn on the connected equipment.
6. Connect your computer to the UPS using USB cable provided.
Install Power management software provided with the UPS
User’s manual
350 - 1500 VA
7
1023922
Revision A
Typical applications
Indicators
1. On/Off/Test Switch
One switch controls power to your equipment and performs a self-test to detect
overload/undercharge.
Turn on the UPS.
Press and hold the switch for more than one second and release the switch after the
beep. The UPS will start.
Turn off the UPS.
Press and hold the switch for more than one second and release the switch. The UPS
will shut down completely.
Perform Self-test.
The UPS will perform self-test for about 4.5 seconds when the UPS is turned on and
the utility power is present.
User’s manual
350 - 1500 VA
8
1023922
Revision A
2. Normal mode (Green)LED
Indicates the UPS is providing mains power to your equipment. When the LED is
blinking the UPS is providing power from the battery.
3. Fault (Red)LED
When blinking, LED could indicate an overload condition or that the battery should
be replaced. When the LED is always on it indicates a short or UPS fault. For details
please see Indicator Table.
4. Battery mode (Yellow)LED
Indicates the UPS is providing battery power to your equipment.
5. Four Battery Backup & Surge Protection Outlets
These three outlets not only provide full time surge protection but also provide
emergency battery backup power.
6. Four Surge Protection Outlets
These Three outlets provide full time protection from surge and spike.
7. Phone/modem/ADSL Protection
Built-in RJ11 jacks protect the Internet, phone or fax line from surges. Connect the line
in from the wall into the jack named “in” and connect the phone, modem, ADSL box to
the jack named “out”
8. USB Communication Port
The provided LanSafe monitoring and shutdown software can be automatically
confi gured to save your fi les and shut down your computer in the event of a prolonged
power outage.
9. Circuit Breaker
The button will protrude when the overload condition occurs. The UPS will switch off
of utility power. If the button protrudes, disconnect some non-essential equipment and
reset the circuit breaker by pushing the button inward.
10. Input Power Connector IEC C13
Plug your load power cable to power your UPS
User’s manual
350 - 1500 VA
9
1023922
Revision A
Indicator table
Status Indicators
The UPS provides both visual and audible status indicators. Visual indicators consist of
three LEDs to represent the following conditions:
On utility power operation
On battery power operation
UPS fault/alarm
LED Indicator Table
On Utility (AC mode)
Green Lighting
On Battery (Backup mode)
Yellow Lighting
Low Battery
Yellow Flashing
Fault/Output Short
Red Lighting
Overload/Check Battery
Red Flashing
LED Audible Alarm Table
On Battery (Backup mode)
Sounding every 5 seconds
Low Battery
Sounding (two beeps) every 5 seconds
Overload
Sounding every 0.5 seconds
Replace battery
Sounding (three beeps) every 30 seconds
Fault or output short circuit
Continuous sounding
Battery over charge
Sounding (three beeps) every 5 seconds
Battery replacement procedure:
1. Shut off the UPS and disconnect the input power cord from the wall outlet.
2. Open battery door.
3. Disconnect used battery. Connect new battery. (It is important that connectors be
fi rmly attached to new batteries.)
4. Close battery door
5. Properly recycle used battery.
•
•
•
User’s manual
350 - 1500 VA
10
1023922
Revision A
5Ah batteries (350VA, 500VA models)
7Ah x 1 battery (700VA models)
Otros manuales para Powerware 5110
3
Tabla de contenidos
Otros manuales de Unión Postal Universal de Eaton
Eaton
Eaton Powerware 3105 UPS Manual de usuario
Eaton
Eaton Power Xpert 9395P Manual de usuario
Eaton
Eaton 93PM UPS Manual de usuario
Eaton
Eaton ON-LINE Series Manual de usuario
Eaton
Eaton PowerXpert 9395P-600/600 Manual de usuario
Eaton
Eaton 5S 700VA Manual de usuario
Eaton
Eaton Powerware 9390 Manual de usuario
Eaton
Eaton 9PX5KiRTN Manual de usuario
Eaton
Eaton MX Frame 15000 RT Manual de usuario
Eaton
Eaton Powerware 9125 Manual de usuario
Eaton
Eaton 9395 UPS and Plus 1 UPS 650825 kVA Manual de usuario
Eaton
Eaton Powerware 9140 Manual de usuario
Eaton
Eaton 9395 Plus 1 Manual de usuario
Eaton
Eaton Powerware 9355 Manual de usuario
Eaton
Eaton 9PX 6000 G Manual de usuario
Eaton
Eaton Powerware 9135 Manual de usuario
Eaton
Eaton Powerware 9x55 series Manual
Eaton
Eaton BladeUPS Series Manual de usuario
Eaton
Eaton Powerware Series Manual de usuario
Eaton
Eaton DIN500AC Manual de instalación y funcionamiento
Manuales populares de Unión Postal Universal de otras marcas
Pylontech
Pylontech Victron & Pylontech US5000 Manual de usuario
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manual de usuario
Mecer
Mecer ME-1000-WTU Manual de usuario
Mustek
Mustek PowerMust 530(B) Plus Manual de instalación y operación
Emerson
Emerson Liebert NXL series Manual de usuario
MAKELSAN
MAKELSAN BOXER SERIES Manual de usuario
