Eaton Cutler Hammer CHAUDC65 Manual de usuario
CHAUDC65
In-Wall Audio Speakers
INSTALLATION GUIDE
1000 Cherrington Parkway, Moon Township, PA 15108
1.800.525.2000 www.cutlerhammer.com
CSCHAUDC65
Eaton │Cutler-Hammer
Installing the Cutler-Hammer CHAUDC65 In-Wall Audio Speakers
1. After opening the box, locate the speaker installation template. Use
this template to cut a hole in the sheetrock.
2. To install the speakers, you must first remove the speaker grill. Push
in one of the four mounting arms on the rear of the speaker. This will
force the mounting arm screw into the grill and pop it off.
Mounting Arm Mounting Arm Screw
CHAUDC65 Installation Guide Page 1
Eaton │Cutler-Hammer
CHAUDC65 Installation Guide Page 2
3. Connect the RIGHT and LEFT channel speaker wire to the red and
black input connectors on the rear of the speaker. Insert the negative
wire in the black and the positive wire in the red.
Speaker Input
Red = Positive
Black = Negative
4. Insert the speaker into the hole. Tighten the Mounting arm screws until
the mounting arms press snug against the back of the sheetrock. Re-
insert the speaker grill.
Tabla de contenidos
Otros manuales de Oradores de Eaton
Eaton
Eaton MC5-EN Manual de usuario
Eaton
Eaton CROUSE-HINDS DB4BM UL Manual de usuario
Eaton
Eaton MC6-EN Manual de usuario
Eaton
Eaton DB4BM Manual de usuario
Eaton
Eaton Wheelock E70H Manual de instrucciones
Eaton
Eaton Cutler-Hammer ESWA0800SC Manual de usuario
Eaton
Eaton DB4B UL Manual de usuario
Eaton
Eaton MC5-EN Manual de usuario
Eaton
Eaton DB4B Manual de usuario
