UNIVERSAL 600
FOR TV-VCR-SAT-CD-CTV-AUX:
Manual Programing:
1-put batteries in the control and turn on the TV or VCR or SAT or
CD or CTV or AUX and point the control at it
2-look at the name of the TV or VCR or SAT or CD or CTV or AUX in
the codes table and see its code
3-press the device name TV or VCR or SAT or CD or CTV or AUX that
you want
4-press (P+) and (V-) at the same time until the indicator lights up
5-enter the code you need the light will go off
6-try the control
Auto Programing:
1-put batteries in the control and turn on the TV or VCR or SAT or
CTV and point the control at it
2-press the device name TV or VCR or SAT or CD or CTV or AUX that
you want
3-press (P+) and (V-) at the same time until the indicator lights up
4-enter the following code: -TV: 0001 -VCR: 0002 -SAT: 0003
-CTV: 0004 -CD: 0005
5-press the device name TV or VCR or SAT or CD or CTV or AUX that you pressed before
6-press (P+) and (V-) at the same time until the indicator lights up
7-press (POWER) many times one by one watch the TV or VCR or SAT or CD or CTV or AUX and when
the device power off press (P+) and (V-)
Note: you have to stop pressing (POWER) directly when the device power off
8-6-try the control if it did not work good repeat the operation again
