Dynasound DS30002 Manual de usuario
DS30002, DS3008, and DS8000
Networked Soundmasking, Paging,
and Music Processors with
Privacy Manager Software
Version 9.00
Print Date: 05/21/2014
3
Table of Contents
Important Safety Information .............................................................5
Soundmasking Systems by Dynasound.....................................................6
Dynasound Network Soundmasking: How it works.... ..........................................6
Dynasound Networked Soundmasking Overview .............................................7
Install Privacy Manager ................................................................10
Use Privacy Manager .................................................................. 11
Home Screen Views...................................................................12
Home Screen Quick Adjustment Buttons ...................................................13
System Proles.......................................................................14
Device Controls - Inputs, Soundmasking, and Outputs ........................................15
Device Properties .....................................................................17
Saving System Power-Up Settings........................................................24
Saving and Restoring Device Settings with a Disk File ........................................25
Saving and Restoring Total System Settings with a Disk File ................................... 25
Dynasound DS3002 and DS3008 ........................................................26
Dynasound DS8000 ...................................................................28
DS3002 DSP Block Diagram ............................................................29
DS3008 DSP Block Diagram ............................................................30
DS8000 DSP Block Diagram - Version 3 ...................................................31
DS8000 Firmware Version - Version 1 .....................................................32
DS8000 Firmware Version - Version 2 .....................................................32
DSM16 Contact Closure Module - Fire Alarm Mute ...........................................33
DSM16 Contact Closure Module - Prole Selection...........................................33
Waiting on conrmation about what to do with this section .....................................33
Using the DS1404 Programmable Level Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Initial Installation and System Conguration.................................................35
Specications ........................................................................36
System Notes: .......................................................................38
Tech Support ........................................................................ 39
Warranty ............................................................................39
5
Important Safety Information
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings.
8. Install in accordance with manufacturer’s instructions.
9. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
ampliers) that create heat.
10. Only use the attachments/accessories as specied by the manufacturer.
11. Refer all servicing to qualied personnel. Servicing is required when the apparatus has been damaged in
any way, such as power supply cord has been damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been
dropped.
CobraNet is the registered trademark of Cirrus Logic.
Windows XP, Windows Vista and Windows 7 are registered trademarks of Microsoft.
6
Soundmasking Systems by Dynasound
Congratulations on your selection of Dynasound equipment. This equipment represents the latest advances
in soundmasking technology. The DS3002 and DS3008 processors can be used for traditional centralized
soundmasking systems or for state-of-the-art networked, addressable systems. The DS8000 power over
Ethernet (PoE) speaker controllers introduce an unprecedented level of control to the soundmasking industry.
Centralized Systems
Centralized soundmasking systems consist of a masking generator with equalizer, a mixer for paging
inputs, and an audio power amplier hard wired to predetermined zones of speakers. The DS3002 and
DS3008 processors each incorporate four separate soundmasking generators, each having 1/3 octave band
equalization. Balanced audio inputs and outputs and multi-channel matrix mixers make the DS3002 / DS3008
processors an ideal choice for complex centralized masking and paging systems.
Addressable Systems
An addressable soundmasking paging and music system incorporates very little centralized equipment.
Instead of a central rack of generators, mixers and ampliers, the system is comprised of speakers which are
networked together. The mark of a well-designed system is that every speaker can be individually controlled. A
poorly designed network system often cluster groups of speakers on a single audio output.
Hybrid Systems
Dynasound’s soundmasking processors provide balanced analog audio outputs and CobraNet™ digital
network audio outputs. This means they can be the central control and the paging and music inputs location for
systems using both standard 70 volt lines and networked speakers.
Dynasound Network Soundmasking: How It Works....
Dynasound networked systems feature a minimum of parts and pieces, yet provide the most exible and
adjustable soundmasking system available. The entire system is comprised of varying quantities of four easy
to understand components:
1. DS3002 or DS3008 soundmasking, paging and music processor
2. DS8000 PoE speaker controllers
3. DS1356 or DS1388 speakers
4. PoE network switches
CobraNet™ audio networking capability provides 8 channels of networked digital audio between the D3002/
DS3008 and DS8000s. The DS3002/DS3008 is used to input standard audio signals, such as paging or music
into the audio network. Additionally, in the factory conguration, the DS3002/DS3008 is used to broadcast
soundmasking signals though network audio channels 7 and 8.
The DS8000 speaker controllers receive power and network audio though the Cat-5 network cable. Each
DS8000 is capable of receiving eight audio channels. The DS8000 incorporates full DSP (digital signal
processing) and can route any mix of the eight audio channels to any individual speaker or group of speakers.
In addition each speaker has individual access to the four internal masking generators inside each DS8000.
7
Dynasound Networked Soundmasking Overview
Main Network System Components
Dynasound DS1356 speakers wire directly to DS8000 networked speaker controllers using
standard two conductor audio cable. Dynasound’s DS1388 speakers may also be used with
network systems. For sample diagram of a networked system, see page 8.
Dynasound DS8000 speaker controllers are PoE, 8 channel network receivers including
full DSP and internal soundmasking generators. They are connected using standard CAT-5
connections.
Industry standard PoE switches and cables are used. Expensive managed
switches are not required. Switches used for data ow only do not require
PoE and may be standard network switches.
Soundmasking, Paging, Music Processor
Dynasound DS3002/DS3008 soundmasking processors are used to route
analog signals such as paging and background music into or out of the
digital audio network. Network systems can use broadcast soundmasking
from the DS3002/DS3008, or localized masking generated internally in
the DS8000s, or both.
Automation and Control
A touchscreen on a PC can be used to control and automate system functions and
schedules. Privacy Manager software provides the ability to easily adjust sound levels
system-wide, per zone or per speaker. Functions include the ability to assign multiple
soundmasking schedules, system proles, and even to automatically run system proles on
a timed basis.
The Dynasound DS1404 four channel programmable level controller can
be used to modify the level of analog masking , paging or music signals,
depending on the time of day and day of week.
8
Touch screen controller with
Privacy Manager Software
DS3008 Soundmasking,
Paging and Music Processor
PoE switch
PoE switch
PoE switch
switch
DS8000
DS8000
DS8000
DS1356 speakers
DS1356 speakers
DS1356 speakers
Cat 5 cable
speakers wired with 18-2 standard speaker cable
9
Example Speaker Identication - Networked Systems
A drawing showing DS8000 and DS1356 speaker locations is required to make adjustments to individual
speakers or Control Zones. This example represents four DS8000s labeled 1.1, 1.2, 2.1 and 2.2. The typical
naming convention for the system is to label each DS8000 with the oor number and sequential ID. In this
example the DS8000s are labeled in two groups even though on the same oor.
While there is exibility in the naming convention, the goal is to make it easy to reference a particular DS8000
and the speakers attached to it.
These screen above shows the quick utility to
adjust the volume of speaker 1 connected to
DS8000 number 1.1. On the drawing that speaker
is labeled 1.1.1.
These screens show connection to the DS8000
having an IP address 192.168.100.7 and location
1.2. The Output Manager screen indicates that
speaker 1 is selected. The Output Manager
screen also illustrates the level of control
available. Note that individual speakers have
access to eight network audio channels and four
independent masking generators.
10
Install Privacy Manager
If Privacy Manager is already installed and congured, you can skip this section and proceed to the next page.
If not, proceed as follows:
Insert the USB drive provided with the DS3002/DS3008/DS8000. Open the drive and run the setup program
provided. You can also download the latest version of Privacy Manager from www.soundmasking.com/support.
html.
Conguring Privacy Manager for Your Soundmasking Network
The default IP search range is set to the default IP address
of a DS3002 or DS3008 (192.168.100.5). If additional
devices are being used, the range of IP addresses in your
system must be entered into the Network Setup screen.
If there are unused IP addresses between the starting and
ending numbers, the unused numbers should be entered
into the exclusion eld so that, during operation, Privacy
Manager software is not delayed attempting to locate non-
existing devices. For exception IP addresses, enter only the
last segment of the IP address. Complex exceptions may be
specied similar to page numbers in a word processor. For
example you could exclude devices 5,8,10-15,20 which would exclude IPs ending in 5,8,10,11,12,13,14,15,
and 20.
Connecting Your Computer to the Soundmasking Network
Communications between the Windows-based PC and the DS3002/3008 and networked DS8000s are done
via a 100 base, T-switched network connection. You must set your PC Network Interface Card to a xed IP
as shown below. The DS3002/DS3008 default factory IP address 192.168.100.5. Default IP addresses for
DS8000s are 192.168.100.6 through 192.168.100.200. You should set your computers network IP to a xed IP,
out of the range of other network devices, such as 192.168.100.240.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Equipo de grabación de Dynasound
Manuales populares de Equipo de grabación de otras marcas
Strymon
Strymon NIGHTSKY Manual de usuario
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manual de usuario
Tews Technologies
Tews Technologies TPMC465 Manual de usuario
Honeywell
Honeywell Excel 50 Manual de usuario
SeaLevel
SeaLevel COMM+8.LPCI Manual de usuario
Arturia
Arturia AUDIOFUSE STUDIO Manual de usuario
