Duxot Accelero Manual de usuario
INSTRUCTION
MANUAL
For more details on operating this timepiece please
refer to the enclosed booklet or visit :
DUXOTWATCHES.COM
CHRONOGRAPH WATCH
This watch is powered by
a quartz Chronograph movement capable of
split micro measurements of time.
With pin point accuracy you may use this watch
to time separate periods of time elapsed
even as you are able to read
the current time simultaneously.
Accelero
Vol. 1.28 EN
28
Remarks :
The measurement time indicated by the stopwatch
hands move independently of the center hands.
MINUTE HAND
DATE
SECOND HAND
HOUR HAND 24 HOUR
HAND
CHRONOGRAPH
SECOND HAND
CHRONOGRAPH
60 MINUTE
HAND
BUTTON A
BUTTON B
SCREW-
DOWN
CROWN 24
618
12
60
2040
60
30
20
10
40
50
400
300
240
200
170
140
150
120
110
100
90
80
85
75
70
65
60
24
618
12
60
2040
60
30
20
10
40
50
24
618
12
60
2040
60
30
20
10
40
50
400
300
240
200
170
140
150
120
110
100
90
80
85
75
70
65
60
1
USING THE SCREW-DOWN CROWN
DO NOT PULL THE CROWN UNLESS IT IS
FIRST:
NOTE: Failure to SECURELY screw down the crown
after setting the watch may affect its water
resistance.
TO UNSCREW: Turn the
crown anti-clockwise until it
turns freely without tension.
GENTLY pull the crown out to
the other desired positions for
watch setting (see specific
operating instructions on the
following pages).
TO SCREW: Push the crown
ALL THE WAY IN (towards the
watch) THEN begin to turn
clockwise until it is securely
screwed down.
0
2 3
PLEASE READ THE FOLLOWING
BEFORE UNSCREWING THE CROWN:
SCREW-DOWN CROWN
Screw-down crowns are used to ensure water
resistance. ALWAYS be certain that your crown is
securely screwed down ( Position [0] is secured.
Positions [1], [2] and [3] are not secured for water
resistance ).
Do NOT unscrew your crown while you are in any
environment where moisture is present.
0 1 2 3
CLOSED
Securely screwed
+ Water Resistance
OPENED
Not secured
For Water Resistance
(2nd click)(1st click)
1
4
HOW TO SET THE DATE AND TIME
*Before setting the time, check that the
chronograph measurement is stopped.
1. Pull out the crown to the position [2]-(1st click).
2. Turn the crown clockwise until the previous day's
date appears.
3. Pull out the crown to the position [3]-(2nd click).
when the second hand is at the 12 o'clock
position. It will stop on the spot. Set the hands to
the desired time of the day (make sure AM/PM is
set correctly) by turning the crown.
* When the crown is at the position [3]-(2nd click),
do not press any pusher. Otherwise the
chronograph hands will move.
4. Push the crown back in the position [1]in
accordance with a time signal.
5
* Do not set the date between 9:00 P.M. and 3:00
A.M. , otherwise the day may not change properly.
If it is necessary to set the date during the time
period, first change the time to any time outside
it, set the date and then reset the correct time.
STOPWATCH FUNCTION
• The measurement of time is indicated by the
stopwatch hands that move independently of the
center hands and 24-hour hand.
• The stopwatch can measure up to 60 minutes.
STANDARD MEASUREMENT
START STOP RESET
6
Restart and stop of the stopwatch can be repeated
by pressing the button A.
ACCUMULATED ELAPSED TIME
MEASUREMENT
STOPRESET
START STOP RESTART
7
WATER RESISTANCE
The water resistance indicated on your timepiece serves
only as a guide. Actual water resistance may vary
depending on a number of important factors including
temperature, water salinity, and actual use under water.
The water resistance of your timepiece may eventually be
compromised over time with general wear and tear and
the use of your watch under adverse conditions.
Always remember to employ the screw down crown (if
available) to maintain the water resistance of your
timepiece. Warranty may be voided if the screw down
crown has not been properly employed.
Note that you should NEVER wear your watch in a jacuzzi,
hot shower or steam room where steam may enter the
case despite the watertight seals used to protect your
watch.
The steam may cause condensation inside your watch,
which may affect and damage the inner workings of your
watch – which would also not be covered by the warranty.
Measurement and release of split time can be
repeated as many times as necessary by pressing
the button B.
SPLIT TIME
MEASUREMENT
STOPRESET
START SPLIT SPLIT
RELEASE
8
Tabla de contenidos
Otros manuales de Mirar de Duxot
Duxot
Duxot MERGULHO Manual de usuario
Duxot
Duxot Numis Manual de usuario
Duxot
Duxot Treasury Manual de usuario
Duxot
Duxot AUDENTIS DX2022 Manual de usuario
Duxot
Duxot Decimo Manual de usuario
Duxot
Duxot Aurum Manual de usuario
Duxot
Duxot Atlantica Manual de usuario
Duxot
Duxot La Plata Manual de usuario
Duxot
Duxot Atlantica Manual de usuario
Duxot
Duxot ARGENTINA DX-2049-04 Manual de usuario
