DS18 NXL-X8TPNEO Manual de usuario
NXL-X8TPNEO
OWNER’S MANUAL
8” WAKEBOARD POD TOWER SPEAKERS
NXL-X8TPNEO
General Specifications
Nominal Diameter..............
Nominal Impedance..........
RMS Power Handling.........
MAX Power Handling.........
Sensitivity (1w/1m).............
Frequency Response.........
Body / Features
Enclosure Material.............
Marine Grade Type.............
RGB LED..............................
Grill Type..............................
Pair.......................................
Clamps.................................
Front Logo...........................
Finish...................................
Woofer Specifications
Voice Coil Diameter.............
Cone Material.......................
Surround Material...............
Basket Material...................
Magnet Material..................
Magnet Grade......................
Passive Radiator..................
Tweeter Specifications
Voice Coil Diameter.............
Type.......................................
Diaphragm Material............
Magnet Material...................
Crossover..............................
8”
4ohm
180W
550W
95dB
60Hz-21Khz
Injection PC+ABS
IP65 + UV Stable
Integrated LED-RGB Speaker Lighting
Integrated LED-RGB Acrylic Ring Lighting
6 Core Wires for Lighting and Speaker
ABS+316 Stainless Metal Mesh
Yes
Die-Cast adjustable (1" ~ 2")
360 Degree Rotation Mounting
Buried Wire or Open Wire Mounting Optional,
Included NBR Pad And Stainless Hardware
(Screws,Stop Washers,Hexagon wrench,
Safety Rope, Screw fastening Glue)
Yes, Can be Rotated For Correct Angle Display
Matte Black
2"
Waterproof Compress Paper + Carbon Fiber
Soft PC Damping Glued
PC Injection Molded Composite
Neodymium
N40H
4" With LED RGB Light
1"
Compression Driver with CNC Solid Aluminum Horn
PEN
Neodymium
12dB with Over Power Protection
SPECIFICATIONS
NXL-X8TPNEO
Thiele & Small Parameters
Equivilant Volume
Excursion (one way)
Free Air Resonance
Total Factor
Speaker Measurements
Overall Diameter................................
Overall Depth......................................
Overall Height.....................................
Vas.........
Xmax.....
Fs...........
Qts..........
17.5L
3mm
62Hz
0.756
8.59" / 218.1mm
13.89" / 352.9mm
12.37" / 314.3mm
SPECIFICATIONS
1 Pair 8” Wakeboard Pod Tower Speaker
1 Piece 6 mm Hex wrench Chromed
1 Piece 4 mm Hex wrench Chromed
1 Pair NBR P ad For 1” to 3” tube adjust
1 Pair Stainless Safety Rope
1 Pcs Screw Fastening Glue
READ BEFORE INSTALLATION
INSTALLATION EQUIPMENT
PACKAGING INCLUDES
SETUP
INSTALLATION & CONNECTION OPTIONS
4
Cut the length of rubber pad and wires outlet according to the diameter of installation pipe.
5
speaker wires
Soldering,Heat shrink
6
INSTALLATION
Step 7:Wrap the rubber pad around the pipe and align wire out hole According to the diagram.
Step 8: Push the wire into the tube, press on the rubber pad,and lock the the top clamp .
Step 9: Take down the safety rope and hang it on the pipe, lock the screw gasket safety rope lifting ring
on the clamp base, and apply screw fastening glue on the screw before locking.
Step 10: If need be ,rotate the speakers for best dispersion,this easily done by locating the 6mm&4mm
hex wrench set screw on the side of the clamp base,rotate the speaker / enclosure to the desired angel,
once there ... locking the screws tight , Avoid vibration ,clamp loose!!!
Step 7
Step 9
Rubber pad
INSTALLATION
Step 11: During the mounting process
you should have located the spot to
drill your tower bar for the 6
conductor wire (Speaker and RGB
lightning wiring) insertion. Or NOT
(see Tie-wrap solution below)
Step 12: Remove Wire NBR Plug and
Slide the wire threw the hole Snake
the wire down to the bottom of the
tower tube in a location that the
wires can be attached to the audio
(And lighting) system. Solder or butt
connect the speaker wire coming
from the tower to the speaker wire to
the system. Then heat-shrink it for
added protection from water /
moisture.
INSTALLATION
Step 13
2.40” / 60.9mm 4.69” / 119.1mm
2” / 50.8mm TO
1” / 25.4mm
13.89” / 352.9mm
8.59” / 218.1mm
12.37” / 314.3mm
4.19” / 106.4mm
DIMENSIONS
INSTALLATION
FOR MORE INFORMATION
PLEASE VISIT
DS18.COM
Tabla de contenidos
Otros manuales de Oradores de DS18
DS18
DS18 8XL800-8 Manual de usuario
DS18
DS18 PRO-X8.4RGBCAP Manual de usuario
DS18
DS18 HYDRO CF-8M Manual de usuario
DS18
DS18 PRO-64XA Manual de usuario
DS18
DS18 PRO-X6.4BMRGB Manual de usuario
DS18
DS18 6XL650NB-4 Manual de usuario
DS18
DS18 PRO-88XA Manual de usuario
DS18
DS18 ZXI-44 Manual de usuario
DS18
DS18 G6.5XI Manual de usuario
DS18
DS18 SLC-N525X Manual de usuario
DS18
DS18 12XL1500-8 Manual de usuario
DS18
DS18 JK-HARNESS Manual de usuario
DS18
DS18 12XL1500-4 Manual de usuario
DS18
DS18 NXL-6 Manual de usuario
DS18
DS18 PRO-X6.4RGBCAP Manual de usuario
DS18
DS18 PRO-FR6NEO Manual de usuario
DS18
DS18 SLC-N4X Manual de usuario
DS18
DS18 CF-8m Manual de usuario
DS18
DS18 Hydro CF-X8PRO Manual de usuario
DS18
DS18 ZXi-112LD.RG Manual de usuario
