Drinkpod 5 Manual de usuario
Use & Care Guide
English
DRINKPOD 5
Countertop Purier·Dispenser
Model: DPWPA500CTB
Customer Assistance
1-844-374-6576
www.drinkpod.com
Drinkpod and the Drinkpod logo are the registered
trademarks of Drinkpod, LLC.
All Rights Reserved.
Table Of Contents
IMPORTANT SAFETY INSTRUCTIONS II
GETTING TO KNOW YOUR DRINKPOD 1-1
Filters 1-5
Technical Specications 1-7
Regarding Connecting Other Appliances 1-7
USING YOUR DRINKPOD 1-8
Powering On/O Your Drinkpod 1-8
Dispensing Water 1-8
Replacing Your DRINKPOD 5’s Filters 1-8
MAINTAINING YOUR DRINKPOD 1-10
Storing & Relocating Your DRINKPOD 5 1-10
Leaving Your DRINKPOD 5 (Vacation) 1-12
TROUBLESHOOTING YOUR DRINKPOD 1-13
Issue #1: My DRINKPOD 5 is dispensing slowly. 1-13
Issue #2: My lter lifespan seems very short. 1-13
Issue #3: My DRINKPOD 5 isn’t powering on. 1-14
Issue #4: My DRINKPOD 5’s Hot Mode won’t dispense. 1-14
Issue #5: My DRINKPOD 5’s Hot Mode isn’t hot. 1-14
Issue #6: My DRINKPOD 5’s Cold Mode isn’t cold. 1-14
Issue #7: My DRINKPOD 5 is leaking water. 1-15
NOTES 1-16
WARRANTY 1-17
Table of Contents
Important Safety Instructions
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed,
including the following:
1. Read all instructions.
2. Should your appliance ever fail, please disconnect the power and water immediately before
calling for assistance.
3. To avoid leakage and damage, never remove appliance parts.
4. Unsupervised children should not be allowed to operate the machine.
5. Please use the product in a dry place within the temperature ranges of 40°F and 100°F.
6. Ensure the power cord is always unplugged before performing any maintenance,
troubleshooting, or lter upgrades.
7. Only use Kenmore or Drinkpod accessories and lters to avoid causing damage and voiding
product warranty.
8. For all service and support related issues, please immediately contact support at 1-844-374-
9. Any and all repairs should only be attempted by qualied persons designated by Drinkpod.
10. Do not install the machine in a location exposed to direct sunlight.
11. Never store or expose your DRINKPOD 5 in an environment less than 32°F.
12. This appliance is not intended for use by persons with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure they do not play with the appliance.
13. If the supply cord is damaged, it must be replaced by the manufacturer, one of its designated
service agents, or similarly qualied person, in order to avoid all hazards.
14. Do not store explosive substances such as aerosol cans, or other items with a ammable
propellant, in this appliance.
15. This appliance is intended to be used in household and similar applications, kitchens, oces,
and similar non-retail applications.
16. The appliance should only be plugged into a grounded three prong socket. A surge protector is
recommended.
17. The appliance should never be turned upside down, or tilted more than 45°.
18. The appliance should never be cleaned utilizing a compressed water stream.
19. This product is designed for household use only!
20. WARNING: To avoid any hazards due to instability of the appliance, it must be
installed, maintained, and repaired, in accordance with this manual.
SAVE THESE INSTRUCTIONS!
Getting To Know Your DRINKPOD
Getting To Know Your DRINKPOD 1-1
A
B
C
D E
F
G
A
Hot Dispense Button -
Dispenses hot water.
B
Child Safety Lock
- Helps prevent small children from burning themselves.
C
Cold Dispense Button - Dispenses cold water.
D
Hot Water Dispenser - Nozzle where hot water ows from.
E
Cold Water Dispenser - Nozzle where cold water ows from.
F
Drip Reservoir - Removable reservoir that collects spilled water.
G
Drip Tray - Sits inside the top of the drip reservoir.
Getting To Know Your DRINKPOD
Getting To Know Your DRINKPOD 1-2
Y
H
I
J
J
K
K
G
F
L
M
N
Q
Q
A
C
R
S
T
U
Getting To Know Your DRINKPOD 1-3
Getting To Know Your DRINKPOD
H
Cooling System Coils
I
Side Panel Venting
- DO NOT OBSTRUCT THIS!
J
Power Cable
K
Filter System to Dispenser Connection
- Connects external lter hub to water
dispenser.
L
Ice & Coee Connect Port
- Outlet that supplies puried water for accessory
appliances..
M
Water Input Line - Water inlet valve that you connect to your water source.
N
Polishing Scrub Pod (Filter 3) - See “Filters” on page 1-5.
O
ULTRA Scrub Pod (Filter 2) - See “Filters” on page 1-5.
P
Chemical Scrub Pod (Filter 1) - See “Filters” on page 1-5.
Q
EZ-Twist Filter 3 Mount - Pivoting mount for Filter 3.
R
EZ-Twist Filter 2 Mount
-
Pivoting mount for Filter 2
.
S
EZ-Twist Filter 1 Mount
-
Pivoting mount for Filter 1
.
T
Heating System Power Switch
- Powers on/o the heating system.
U
Cooling System Power Switch -
Powers on/o the cooling system.
V
Appliance Drain Port -
For draining appliance when relocating or storing.
Getting To Know Your DRINKPOD
Getting To Know Your DRINKPOD 1-4
QR S
O PN
L
M
T
U
J
K
H
V
Getting To Know Your DRINKPOD 1-5
Getting To Know Your DRINKPOD
Filters
Shown above are the available pod lter options in Drinkpod’s water purication
product line.
F1. Particle Scrub (Optional Use / Sold Separately) - It is only recommended to use
this additional lter (with external lter attachment) if you water source has unusually
high levels of larger contaminants. Use of this lter in such scenarios may extend your
primary (internal) lters lifespan. The Particle water lter replacement pod utilizes
depth lter to greatly reduce contaminants greater than 5 microns in size (i.e. cysts
and rust).
F2. Chemical Scrub (Included)-The Chemical water lter replacement pod utilizes
activated carbon granules to improve the safety of drinking water by eectively
removing common disinfection byproducts (THMs), organic contaminants like
chlorinated solvents and other industrial pollutants, pesticides, and select heavy
metals such as lead and mercury. The process reduces undesirable taste, odor, and
color.
F3. ULTRA Scrub (Included) ULTRA water lter replacement pod utilizes a hollow ber
UF membrane to greatly reduce contaminants greater than 0.02 microns in size (i.e.
bacteria, colloids, and large organic molecules).
OP N
O
P
F5F1 F2 F3 F4
Getting To Know Your DRINKPOD
Getting To Know Your DRINKPOD 1-6
F4. Polishing Scrub (Included)-The Polishing water lter replacement pod utilizes
activated carbon block lter to remove eliminate odors and discoloration in your
water, while also improving taste. Additionally, it provides particle and chemical
ltration.
F5. ULTRA+3 Hybrid Scrub
(Not Recommended For This Product)
- The
ULTRA+3 hybrid water lter replacement pod utilizes activated carbon block lter
(rst stage) to greatly reduce particles, eliminate odors and discoloration, and
reduce chemicals in your water, while also improving taste. This is followed by a UF
membrane (2nd stage) that removes sub micron contaminants, like bacteria, colloids,
and large organic molecules, down to 0.02 microns.
N
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Dispensador de Drinkpod
