Dreamline FLEX Manual de usuario

FLEX

SHOWER ENCLOSURE INSTALLATION INSTRUCTIONS

IMPORTANT

DreamLineTM reserves the right to alter, modify or redesign products at any time without prior

notice. For the latest up-to-date technical drawings, manuals or any other details please refer

to the support.BathAuthority.com web page.

Please read these instructions carefully before installing. If you have any questions regarding

installation, please call our technical support specialists Monday through Friday 9:00 AM – 5:00

PM EST at Phone: 1-866-731-2244, Fax:1-866-227-1533 or e-mail our technical support group

[email protected].

For more information on DreamLineTM Shower Enclosure please visit www.BathAuthority.com

“FLEX” Enclosure Rev.1, Ver.3 03/2014 2

Preparation

1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed

parts are included in the package by marking all the components on the “Detailed Diagram of

Shower Door Components”. Examine boxes and packages for shipping damage. If the unit has

been damaged, has a finishing defect, or is missing parts, please contact our customer support

department within 5 business days of the delivery date. Please note that DreamLineTM will not

replace any damaged products or missing parts free of charge after 5 business days or if the

product has been installed. Feel free to contact DreamLineTM if you have any questions.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine is

not responsible for code compliance standards for your project and will not accept any

returns.

3. If this unit is going to be installed in a new construction, please, install all of the required plumbing

and drainage before installing the shower. Use a competent and licensed (if required by local

code) plumber for all plumbing installation period.

4. Prior to installation, please ensure that the installation surface is level and solid and will be able to

support the total weight of the unit. Also, make sure that the walls are plumb. Depending on the

type of unit you are installing, some adjustments in leveling may be possible. However, irregular

installation, surface level or out of square conditions can result in serious problems for your

installation. Please note that some adjustments and drilling may be necessary. Please protect all

primary surfaces of the product during installation. Never set your glass down directly onto a

tile floor. Always use a piece of wood or cardboard to protect the bottom edge and corners of

the glass.

Tools Required

Caulk Tape

Measure Pencil Screwdriver

Phillips

Level Gun

Caulk Drill

Electric Hammer

Drill bit

(Ø=5/16")

(Ø=1/8")

“FLEX” Enclosure Rev.1, Ver.3 03/2014 3

Detailed Diagram of Shower Enclosure Components

110 11

Door packing List

01 Wall profile 2pcs* 06 Decorative cover 8pcs

02 Door assembly 1set 07 Flanged anti-water strip 1pc

03 Wall anchor 8pcs 08 Bottom anti-water strip 1pc

04 Round head screws ST4.2×10 8pcs 13 Handle 1pc

05 Round head screws ST4.2×40 8pcs

Return panel packing List

04 Round head screw ST4.2x10 4pcs 10 Corner profile 1pc

06 Decorative cover 2pcs 11 Return wall profile 1pc

09 Return glass panel 1pc

* - For shower enclosure please use only one wall profile.

NOTE: Unpack your unit carefully and inspect it. Lay it out and identify all parts using parts diagram

and part list in your manual as a reference. Before discarding the carton, check for small hardware

bags that tend to fall to the bottom of the box. If any parts are damaged or missing, please contact

DreamLineTM for replacement.

NOTE: Retain these installation instructions for future reference.

“FLEX” Enclosure Rev.1, Ver.3 03/2014 4

Door Assembly Diagram

Alluminum profile

Expandable rail

Glass door

Stationary glass

Alluminum profile

Corner profile

Glass panel

Return

Wall profile

“FLEX” Enclosure Rev.1, Ver.3 03/2014 5

Shower Enclosure Installation

NOTE: The installation of this shower enclosure

requires two installers.

NOTE: The shower enclosure can be installed on the

shower base or custom threshold.

1. Prior to the Shower door installation, Shower base

installation and plumbing must be completed.

See Fig. 1 for details.

2. The width of the shower enclosure is adjustable

and can be adjusted to the size of your shower

base or custom threshold.

Mark position of the Wall profile (01) and the

Return wall profile (11) on the wall according

to the model size and dimensions provided in

the size table.

Place the Wall profile and the Return wall

profile onto the Shower base or threshold

against the finished wall and level it vertically.

See Fig. 2 and table below for details.

Model No. W1 W2

SHDR-2230300-RT-01

SHDR-2234340-RT-01 30 1/2"

34 1/2" 28 1/2" - 32 1/2"

32 1/2" - 36 1/2"

Fig. 2

Fig. 1

W1 W2

“FLEX” Enclosure Rev.1, Ver.3 03/2014 6

3. Trace the drilling holes on the wall through the

predrilled holes in the Wall profile (01).

Drill the holes on the wall using a Ø 5/16 drill bit

and insert the Wall anchors (03).

Apply a bead of silicone to the wall along the

drilled holes and around the holes.

Attach the Wall profile to the wall with the Round

head screws ST4.2×40 (05).

See Fig. 3 and Fig. 5 for details.

4. Trace the drilling holes on the wall through the

predrilled hole in the Return wall profile (11).

Drill the holes on the wall using a Ø 5/16 drill

bit and insert the Wall anchors (03).

Apply a bead of silicone to the wall along the

drilled holes and around the holes.

Attach the Return wall profile to the wall with

the Round head screws ST4.2×40 (05).

See Fig. 4 and Fig. 5 for details.

Fig. 4

Fig. 3

Ø 5/16"

“FLEX” Enclosure Rev.1, Ver.3 03/2014 7

5. Slide the Corner profile (10) over the aluminum vertical edge of

the Return glass panel (09). Drill the holes into the aluminum

profile on the Return glass panel using an Ø 1/8 drill bit through

the predrilled holes in the Corner profile.

Secure the Corner profile to the Return glass panel with the

Round head screws ST4.2×10 (04). Set this Return glass panel

assembly aside.

See fig. 6 and Fig. 7 for details.

Ø 1/8"

Fig.

Fig. 5

“FLEX” Enclosure Rev.1, Ver.3 03/2014 8

6. Install the Handle (13) onto the Door assembly (02). Move

the Door assembly onto the Shower base and slide the

Stationary glass side into the Wall profile (01).

See Fig. 8 and Fig. 9 for details.

Fig. 8

Fig. 7

“FLEX” Enclosure Rev.1, Ver.3 03/2014 9

7. Slide the Return glass panel (09) assembly into the

groove of the Return wall profile (11).

See Fig. 10 for details.

Fig. 10

Fig. 9

“FLEX” Enclosure Rev.1, Ver.3 03/2014 10

8. Extend width of the Door assembly (02) by

stretching the top and bottom Expanding rails

toward the Corner profile (10). Insert Glass door

side into the Corner profile.

NOTICE:

The maximum adjustable length of the Expanding

rails is: 4 1/2"

See Fig. 11 and Fig. 12 for details.

Fig. 12

Fig. 11

Tabla de contenidos

Otros manuales de Cabina de ducha de Dreamline

Dreamline

Dreamline AQUA-Q SWING SD-373472Q Series Manual de usuario

Dreamline

Dreamline HORIZON Manual de usuario

Dreamline

Dreamline Oceana DLG-63 Manual de usuario

Dreamline

Dreamline ENIGMA AIR SHEN-6434480 Series Manual de usuario

Dreamline

Dreamline UNIDOOR PLUS STYLE F Manual de usuario

Dreamline

Dreamline Elegance Manual de usuario

Dreamline

Dreamline ENIGMA SHDR-6060791272 Manual de usuario

Dreamline

Dreamline LINEA SHDR-3230721 Series Manual de usuario

Dreamline

Dreamline DUET Manual de usuario

Dreamline

Dreamline UNIDOOR MADRID D245872MB01 Series Manual de usuario

Dreamline

Dreamline Charisma SHDR-1348760 Series Manual de usuario

Dreamline

Dreamline SHDR-22287200-01 Manual de usuario

Dreamline

Dreamline SPARKLE Manual de usuario

Dreamline

Dreamline MYSTERIE SHDR-61AMZ48 Series Manual de usuario

Dreamline

Dreamline ENIGMA-X Manual de usuario

Dreamline

Dreamline SHEN-1332460 Series Manual de usuario

Dreamline

Dreamline MIRAGE-X SHDR-1948723L Series Manual de usuario

Dreamline

Dreamline Prism DLT-1132320 Manual de usuario

Manuales populares de Cabina de ducha de otras marcas

Insignia

Insignia INS3000 Manual de usuario

RIHO

RIHO BALTIC B309 Manual de usuario

SANIKU

SANIKU DKA/EL-EC 0041 Manual de usuario

AM.PM

AM.PM BLISS Manual de usuario

Samo

Samo B0980 Manual de usuario

AM.PM

AM.PM BLISS SQUARE Manual de usuario

Cello

Cello Ice 70x90 Manual de usuario

agape

agape FLAT D E1P Guía

glass 1989

glass 1989 nonsolodoccia home 140/90 Manual de usuario

AM.PM

AM.PM ADMIRE STEAM CABIN A Manual de usuario

Schulte

Schulte MasterClass D1209030 Manual de usuario

Linie

Linie Tarifa Manual de usuario

US HORIZON

US HORIZON SORRENTO Series Manual de usuario

Arblu

Arblu PERSEO ANGOLO Q-R 2SL+1LF Guía de instalación

Novellini

Novellini R90 base p.80 Manual de servicio

SANPLAST

SANPLAST KP1DJa/TX5b Manual de usuario

Insignia

Insignia 9015 Manual de usuario

Kohler

Kohler Sterling 2375 Series Manual de usuario