Dreamland R7521 Manual de usuario
Instructions for use
HEATED THROW
HEATED THROW
COUVERTURE CHAUFFANTE
SOFADEKEN
HEIZÜBERWURF
PLAID RISCALDABILE
VÄRMEFILT
EN
FR
NL
DE
IT
SE
PAGE 1
PAGE 11
PAGINA 21
SEITE 31
PAGINA 41
SIDA 51
TYPE R7521
R7526
1
EN
ILLUSTRATIVE GUIDE
DESCRIPTION OF THE APPLIANCE
TECHNICAL DATA
1. Throw connector
2. Control unit connector
3. Mains socket
4. Rating Label
5. Throw
6. Timer selector
7. ON/OFF button
8. Temperature selector
9. Stand-by LED
10. Auto shut off timer LED
11. Temperature LED
Temperature table
6Fast Pre-heat
5-4
Medium Pre-heat
3-1 Continuous or all
night use
[B]
3
5
4
[A]
1 2
[C]
6
7
8
911
10
TYPE R7521
220-240 V 50/60 Hz 150 W TYPE R7526
220-240 V 50/60 Hz 150 W
2
EN
Dear Customer, thank you for choosing our product. We feel certain
you will appreciate its quality and reliability as it was designed and
manufactured with customer satisfaction in mind. These instructions
for use are compliant with the European Standard EN 82079.
INDEX
Illustrative guide page 1
Description of the appliance page 1
Technical data page 1
Symbols page 2
Important instructions page 3
Use page 5
Cleaning and maintenance page 7
Storing the throw page 8
Troubleshooting page 9
Disposal page 9
Assistance and warranty page 10
SYMBOLS
Class II appliance Prohibition
Read the instructions Information
Caution/Warning/Danger NOT to be used by very
young children (0-3 years)
Wash at a maximum
temperature of 30 °C on a
delicate cycle
Do not insert pins
Dry in a tumble dryer on a cycle
at a moderate temperature Do not bleach
Do not iron Do not dry clean
3
EN
I
MPORTANT INSTRUCTIONS.
RETAIN FOR FUTURE USE.
WARNING! Instructions and warnings for safe use.
Before using this appliance, carefully read the instructions
for use and in particular the safety notes and warnings,
which must be complied with. Keep this manual together
with its illustrative guide for future consultation. Should
you transfer the appliance to another user, make sure
you hand over this documentation as well.
NOTE: should any part of this manual be difficult to understand or any
doubt arise, contact the company at the address indicated on the last
page before using the appliance.
NOTE: persons with impaired vision may consult these instructions for
use in digital format at the website www.tenactagroup.com
• After unpacking, make sure the appliance is intact, complete with all its parts as
shown in the illustrative guide and with no sign of damage. If in any doubt, do not
use the appliance and contact an authorised service centre.
WARNING! Risk of suffocation.
Children shall not play with the packaging. Keep the plastic bag
out of the reach of children.
• This appliance must be used only for the purpose for which it was
designed, namely as a throw (wrap) for home use. Any other use is
considered not compliant with the intended use and therefore dangerous.
• Before connecting the appliance to the mains supply, make sure that the
voltage and frequency indicated on the technical data of the appliance
correspond to those of the mains supply. The rating is on the appliance
or on the power supply unit, if any (see illustrative guide).
• This appliance can work automatically at a frequency of 50 Hz or 60 Hz.
4
EN
• This appliance is only to be used with the types of detachable control
unit that are marked on the appliance.
Children under the age of three are not to use this appliance
due to their inability to react to overheating.
• This appliance can be used by children older than 3 years and younger
than 8 years under supervision and with the control always set to
minimum temperature (heat setting 1).
• This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance must not be carried out by children without
supervision.
• This appliance must not be used by persons insensitive to heat and other
very vulnerable persons who are unable to react to overheating.
• The cable and control unit of the appliance can give rise to risks
of entanglement, strangulation, tripping or treading if not correctly
arranged. The user shall make sure that electric cords shall be arranged
in a safe way.
• Always disconnect the appliance from the mains supply before cleaning
or performing maintenance and when the appliance is not in use.
• Examine the appliance frequently for signs of wear or damage. If the
appliance has been misused or does not work, contact an authorised
technical service centre before switching it on again.
• If the supply cord is damaged, take the whole appliance to an authorised
technical service centre for the replacement of the control unit, so as to
prevent all risks.
• If the appliance is used on an adjustable bed, check that the blanket and
cord do not become trapped or rucked, for example in hinges.
• This appliance is not intended for medical use in hospitals.
• DO NOT use if wet.
5
EN
DO NOT INSERT PINS OR NEEDLES.
• When storing the appliance, allow it to cool down before folding.
WARNING! DO NOT crease the appliance by placing items
on top of it during storage.
WARNING! For use, cleaning, maintenance and storage of
the appliance, please follow the instructions specified in the
corresponding chapters.
• Persons with a pacemaker must NOT use this appliance.
• DO NOT use the appliance with wet hands or damp feet.
• DO NOT pull the power cable or the appliance itself to remove the plug
from the socket.
• DO NOT pull or lift the appliance by the supply cord.
• When using the appliance at home outside, do not expose the appliance
to humidity, to the effects of weather (rain, snow, etc. ) or to extreme
temperatures. DO NOT leave the appliance outside after use.
• If the appliance is faulty or malfunctions, switch it off and do not tamper
with it. Contact an authorised technical service centre for any repairs.
• DO NOT use this appliance to warm animals.
• DO NOT tuck in.
• See the external packaging for the characteristics of the appliance.
USE
• Spread the throw over your sofa, armchair or bed ensuring that the throw
connector is at the foot position.
• Place the throw over you without wrapping it tightly and without sitting on it as this
may cause the overheat protection system to activate.
CONNECTING THE CONTROL UNIT
• Insert the control unit connector (2) in the throw connector (1) to connect the control
unit to the throw.
• Insert the plug of the control unit cable in the mains socket (3). Every time the plug is
6
EN
inserted, the control unit automatically performs a self-diagnosis, lighting up all LEDs
(10, 11) in a clockwise sequence for around two seconds.
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
The control unit can be set to the following temperature levels:
6: Fast pre-heat temperature
5-4: Medium pre-heat temperature
3-1: Continuous or all-night use
• To switch the throw on press the ON/OFF button (7). Every time the appliance is turned on,
the control unit automatically checks the appliance is working correctly, lighting up all LEDs
(10, 11) in a clockwise sequence. Following this check, the control unit automatically sets
temperature 6 and the timer (auto-o time) to 1 hour.
• For fast pre-heat, use maximum temperature 6. If you like a medium pre-heat temperature,
then you can select 4-5 by pressing the temperature selector button (8) until the LED for
the required temperature lights up (11). The higher the number selected, the higher the
temperature.
IMPORTANT: The time needed for the throw to warm up will depend on the room
temperature. To judge the temperature accurately, lie on your sofa with the throw
draped over you. Do not rely on a hand placed on the throw.
CONTINUOUS USE
For continuous use, set the control unit to temperature levels
from 1 to 3 only.
To set the control unit to the continuous use temperature, press the temperature selector button
(8) until LEDs 1, 2 or 3 light up (11).
DO NOT set the control unit to a higher temperature than
recommended for continuous use.
If the control unit is set to a higher temperature the user may
suer skin burns or heat stroke.
WARNING! DO NOT place the control unit under the pillow
or under the sheets when in use.
7
EN
AUTO SHUT OFF TIMER
The throw has an automatic shut o timer of 1,3 or 9 hours. When switched on, the control
unit automatically sets itself to 1 hour on the auto shut o timer and LED 1h lights up in
green (10). To set a dierent auto shut o timer, press the timer selector button (6) and
select the desired timer. Each time the auto shut o time is reset, the timer starts from
zero. When the time has elapsed, the throw switches o and the standby LED (9) lights
up in blue.
NOTE:
should the power supply accidentally be interrupted during use, when
the control unit is switched back on, it will maintain the temperature and timer
settings in use previously and the timer counter will start from zero.
NOTE: the light intensity reduces around 15 seconds after any button is last
pressed, so that the display light does not bother users. Similarly, the standby
LED becomes less bright 15 seconds after it is activated.
SWITCHING OFF
Switch the throw o by pressing the ON/OFF button (7) and remove the plug from the socket (3).
CLEANING AND MAINTENANCE
The throw is washable. Check the washing symbols on the label to ensure it is washed
correctly.
WARNING! Always disconnect the appliance from the mains
and disconnect the control connector from the throw before
cleaning or performing maintenance.
BEFORE WASHING
• Take the plug of the control unit cable out of the mains socket (3).
• Press the grip levers at the sides of the control unit connector (2) to remove the control
unit connector from the throw connector (1).
MACHINE WASHING
• The throw can be cleaned in the washing machine at 30°C, on a delicate cycle.
• Use only the delicate cycle for spinning. DO NOT make an additional spinning cycle.
DRYING IN THE TUMBLE DRYER
• The throw can be dried in a tumble dryer on a delicate cycle at a moderate temperature,
8
EN
but at the end of the drying cycle it must be air-dried to allow it to dry completely.
• Remove the throw from the tumble dryer at the end of the drying cycle and reshape it
to its original size.
• Allow the throw to fully air-dry before using it again.
DRYING IN THE OPEN AIR
• When the throw is spread out to dry on a clothes airer, it must be stretched so the original
size is more or less maintained. This is best done while the throw is still damp, working
alternately on the opposite corners and pulling one side at a time.You might have to repeat
this procedure several times until the throw is completely dry.
WARNING! Dry the appliance flat without using pegs to avoid
damaging it. Leave it to dry, laid out flat on a clothes airer, not
in direct sunlight
.
• Only use the throw when it’s thoroughly dry.
• Do not iron the throw.
WARNING! Examine the appliance against the light to make sure
the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or if
problems arise with the internal cables contact an authorised service
centre for a safety check.
STORING THE THROW
When not in use, store as follows:
• If the throw has been washed, wait until it’s completely dry;
• Fold it like a normal throw;
• You are advised to store the throw in the original packaging it was supplied in;
• When storing the appliance, allow it to cool down before folding;
• Put the throw away in a dry place.
Examine the appliance and its supply cord frequently for signs of wear or damage.
lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
9
EN
TROUBLESHOOTING
This chapter describes the most common problems that can arise using the
appliance. If the problems cannot be solved with the information below, please
contact the Authorised Service Centre.
Problem Solution
The LEDs on the control unit
do not light up.
Check that the control unit plug is fully inserted in
the socket (3). If the LEDs remain off, remove the
control unit plug from the socket (3) and return the
throw to an authorised technical service centre.
The blue warning light is
flashing.
Turn the control unit off and remove the plug from
the socket (3). Check that the control unit connector
(2) is fully inserted in the throw connector (1) and
reinsert the plug in the socket (3). If the standby LED
continues to flash, return the throw to an authorised
technical service centre.
Temperature LED 1 (11) is
flashing.
Return the throw to an authorised technical service
centre to be checked.
The product has been used
incorrectly or is damaged.
The power cable or another
internal wire is damaged.
The control unit is damaged.
There are holes or tears in the
fabric or stubborn creases that
do not spread out.
DISPOSAL
The packaging of the appliance is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de Almohadilla térmica de Dreamland
Dreamland
Dreamland LUXURY R7526 Manual de usuario
Dreamland
Dreamland R7604 Manual de usuario
Dreamland
Dreamland R9001 Manual de usuario
Dreamland
Dreamland R6705 Manual de usuario
Dreamland
Dreamland R9005 Manual de usuario
Dreamland
Dreamland L1647 Manual de usuario
Dreamland
Dreamland RELAXWELL F2001 Manual de usuario
