INSTRUCTIONS
Stock No.16395 Part No.MTC100
Manual Tyre Changer
DRAPER
TOOLS
LTD,
HURSLEY
ROAD,
CHANDLER'S
FORD,
EASTLEIGH,
HANTS.
SO53
1YF.
U.K.
drapertools.com
e-mail:
[email protected]DBKC0516
2. OPERATION
1. TECHNICAL DESCRIPTION
Tyre bar x1
Support plate x1
Clevis pin x2
Bolt M10x25 x4
Flat washer Ø10 x4
Lock washer Ø10 x4
Nut M10 x4
Long leg x1
Short leg x1
Pedestal x1
Bead breaker x1
Locking pin x2
Force handle x1
Slotted press plate x1
Threaded cap x1
Locating pin x1
Bead breaker head x1
2.1. BREAKING THE BEAD - FIG. 1
• Remove all wheel weights and tyre valve core to release tyre pressure, lay the wheel flat on the base leg
in front of the bead breaker .
• Adjust bead breaker (if required) and position the bead breaker head between tyre wall and
wheel rim, using the tyre lever inserted into the force handle and lever down to break the bead.
Repeat around the wheel until bead is free from wheel rim, then turn the wheel over and repeat the
process until the tyre is free from both beads.
2.2. TYRE REMOVAL - FIG. 2
• Lubricate both tyre beads with appropriate tyre soap.
• Mount the wheel onto the support base (valve side up), ensure the locating pin is through one of the
wheel holes and lock down using the slotted press plate and threaded cap .
• Place the flat end of the tyre lever between the tyre bead and the wheel rim, while applying pressure
to the tyre side wall, lever against the cap and rotate the tyre lever in a clockwise direction.
Repeat action on second bead.
2.3. FITTING - FIG. 3
• Lubricate both tyre beads.
• Using the tyre lever foot end, locate between the lower bead and wheel rim, lever against the cap and
rotate clockwise around the cap.
• Repeat action on second bead, then replace valve core, inflate tyre to ensure tyre locates correctly onto
rim (DO NOT exceed maximum allowance tyre pressure) the set tyre pressure to require valve.
• We would recommend that wheel is correctly balanced before use.
FIG.2
FIG.1
FIG.3
NOTE: For safe and effective use of this tyre changer it MUST be securely bolted
down to the floor using suitable fixings.
WARNING:
Extreme caution must be used if
attempting to replace tyres on
alloy wheels.
This machine is designed to be
used on steel wheels and Draper
Tools Ltd accepts no responsibility
for any damage to wheels or tyres.
