DPVIDEO DZP907 Manual de usuario
AUTO MULTIMEDIA AUDIO/VIDEO PLAYER
DZP907
DZP907
Contents
Thanks for choosing our products. Please read this User Manual carefully for functions and
operations of this product and follow the precautions in it. Keep it properly for future reference.
* Important Tip: Calibrate the touch sreen before first use of this product (refer to Page 5).
* Note: As the technologies upgrade from time to time, the specifications shall be subject to
change without prior notice.
1-2
3-4
5-11
12-15
16-17
17-19
19-22
22-23
23-27
27-34
34-36
36-37
38-39
40-41
41
1. Safety Precautions
2. Introduction to Panel Functions
3. Touch Screen Operation
4. Remote Controller
5. Basic Operations
6. Radio Operations
7. Bluetooth Operations
8. TV Operations
9. DVD/VCD/CD Operations
10. System Setup
11. MP3 Operations
12. Installation Guide
13. Troubleshooting
14. Technical specifications
15. Accessories
precations.
Retain this manual
Control
screen
1
1. Safety Precautions
Improtant Safety Measures
1) Make wiring according to the installation guide. Improper wiring may lead to maifuntction to
this product or damage to auto electric appliance.
2) Lead for speaker 1 shall be connected to termianl of the speaker 1. Never connect the lead
to the car body or an incorrect speaker terminal.
3) Make sure the wiring is correct before powering on the product.
4) When replacing a fuse, only use a new fuse with the same specification.
5) Do not block the ventilation hole or heat sink, or overheating inside this product may lead to
unstable performance.
6) After installation, begin to use the product (including replacement of automobile batteries).
First remove front panel, press "Reset" on the base with a pointed tool (it is forbidden to use
a sharp pointed object) to make the system in initial setup status.
Replace aFuse
When replacing a fuse, make sure the original and new fuse have the same amperage. If the
fuse is burnt, check power supply connection first before replacing it. If the new fuse is burnt
out shortly, there may be internal fault and in this case, you shall contact the dealer.
Warning:
Never use a fuse with a larger amperage than the fuse installed in this product, or it may lead
to damage to this product.
Precautions
This product support the following discs:
malfunction of
the vehicles electrical system.
the terminal of
must
specifications
be sure wiring is installed
to begin using the product after installation or replacement of the vehicles battery,
remo v e th e
enter in to
burns
be an
should
of
supports
MPEG-4
MP3
DVD
VCD
CD
12cm
12cm
12cm
12cm
12cm
DIGITAL VIDEO
VIDEO CD
DIGITAL AUDIO
Mp3
DIGITAL AUDIO
DIGITAL AUDIO
2
Disc Type Disc Mark Disc Content
Audio and Image
Audio and Image
Only Audio
Only Audio
Audio and Image
Disc Size
Note: VCD of this product is compatible with VCD 1.0/1.1/2.0/3.0 DVD disc.
* Do not alter this product as it may lead to accident.
* Any operations to this product which may affect normal driving shall be conducted only after
the auto has been stopped.
* Do not keep this product running under excessively high or low temperature. Make sure the
internal temperature is within +60 and -10 before turning on the power.
* When playing CD, pay attention to the following precautions for optimal vedio and audio
effect:
- Hold the disc on the edge to keep it clean.
- Do not use adhesive or ink on the disc.
- Do not use a disc with a sticker on it, as when the sticker falls off it may damage this product.
- Only use the special-purpose soft cloth wiping from the center to the edge to clean a disc.
operation of
should
a CD,
video
DZP907
3
2. Introduction to Panel Functions
1. Monitor.
2. MENU: In DVD mode, press the key
to return to the root directory of disc
menu; in radio mode, press the key to
switch to function operation interface.
3. :Stop playback.
4. EQ: Press the key to select preset
sound mode.
5. LOUD: Long press to enter/exit LOUD
function.
6. MIC: Pleas keep close the MIC input
in case avoiding communication under
Bluetooth mode.
7. RPT: Repeat Play.
8. VOL/SEL: Turn the key to regulate the volume.
Press SEL, the following items will appear: L-front
/R-front/L-rear/R-rear/Subwoof/Bass/Middle/Treble/Volume.
9. / : under radio mode, press it to search channels automatically, and long press
it to search channels manually; under TV mode, press it to select the previous/next TV
channel; under playback mode, press it to select the previous/next music track, and long
press it to go fast forward and backward.
a preset
Please
knob
4
10. SRC: Press the key to change modes.
11. BAND: under radio mode, press it to switch the radio bands;
12. AMS : In radio mode, press to scan the preset radio programs; long press to
auto-search and store radio programs.
13. : Play/Pause button.
14. PWR/ : Under power off mode, short press to turn on; power on mode, long press to turn
off. On work condition, short press for mute function.
15. AV IN: Under AV1 mode, audio and vedio input jack.
16. (USB Jack): Support 1.0/2.0 USB interface.
17. IR (Remote window): It can receive infrared signal transmitted by remote controller
supplied with the product.
18. : Short press to enter/exit disc control function, long press to force exit.
19. OPEN: The TFT LCD is floating structure. Under power off condition, press this button to
turn on and flip up TFT screen, repress it to flip down TFT screen.
20. SD/MMC Card Insert Jack.
21. Reset button.
video
rec ei v es the
by the
control
the disc
is a
conditions,
down the
5
3. Touch Screen Operations
You can control the device by touching the screen.
Radio
1. : Tap this area to go back to SOURCE.
2. Radio channel preset keys: Display list of
preset channels. Tap any preset key to receive
the program from pre-saved radio channel.
Long tap to save the current radio channel.
3. : Tap it to switch wave bands.
4. : Tap it to select between long-range and
short-range radio channels.
5. : Tap it to browse preset channels. Long
tap it to search for and automatically save radio channels.
6. : Tap them to search for radio channels downwards/ upwards automatically; Long tap to
search for radio channels downwards/upwards manually.
7. : Tap SYS to switch to system setup mode; when there is RDS function in the unit, this button
will change to , Tap PAGE1 to RDS set up interface.
8. LOUD: Tap it to turn on/off LOUD function.
9. EQ: Tap it to select form preset sound modes.
Multimedia
In DVD mode, tap any point on the screen to
display the following keys:
1. : Tap it to play/pause the playing.
2. : Tap it to stop playing, tap twice to stop
playing completely.
3. : Tap it to select the previous/next music track.
to the
Displays a
from a
from
6
Note: In DVD mode, tap twice the left side on the screen to display TITLE MENU; tap twice the lower
right corner to display ROOT MENU. In other playing modes, tap the upper right corner to display
numeric keys and then tap any key to operate.
4. : Tap it to display DVD SETUP.
5. : Tap it to display SOURCE.
TV
1. Preset TV channels: Display list of preset TV
channels. Tap any channel to receive corresponding
program. Long tap current channel to save it.
2. : Tap it to turn to the previous/next page.
3. : Tap it to automatically search for and save
TV channels.
4. : Tap them to search for TV channels
downwards/upwards automatically. Long tap them
to search for TV channels downwards/upwards manually.
5. : Tap it to display system setup interface.
6. PAL-DK: Tap it to switch between TV systems.
Bluetooth
Hands-free Telephone
1. : Bluetooth main menu
2. : Telephone directory
3. : Bluetooth setup page
4. : SOURCE.
5. Number area
6. : Dial key
7. : Clear key
8. : Hang-up key
9. : Switch mode of voice output
1
234
5
6
1
3
2
4
5
6
7
8
9
the left side of the s creen twice
the lower right
corner twice
display the
tap the
7
Telephone directory
1. : Display list of answered phone calls.
2. : Display list of dialed phone calls.
3. : Display list of missed phone calls.
4. : Turn to the next page.
Bluetooth setup
1. : Link to Bluetooth devices.
2. : Pair up with Bluetooth devices.
3. : Disconnect from Bluetooth devices.
4. : Restart.
5. : Play/pause.
6. : Stop playing.
7. : Back to the previous or go to the next.
8. : Adjust volume.
In A2DP mode, press keys 5-7 to make touch
screen operation.
Setup
Switch to setup function. The screen will
automatically go back to the current mode
interface if no operations are conducted in 5s.
INFO
8
1. : Display options in front-seat mode.
Tap it to select the front-seat mode.
2. : Tap it to display the current play information
3. : Tap it to display the following:
Volume, L-front, R-front, L-rear, R-rear, Subwoofer,
Bass, Middle, Treble
Tap to turn to the next page and adjust the
desired items; Tap to adjust the above items.
INFO
INFO
INFO
Tabla de contenidos
Otros manuales de Reproductor multimedia de DPVIDEO
