Page 4 of 4
Before replacing parts or storing the system, turn off the power and let it cool down to the
room temperature.
Warning: this tool must be placed on its stand when not in use.
Afire may result if the appliance is not used with care, therefore
----be careful when using the appliance in places where there are combustible material;
----do not apply to the same place for a long time;
----do not use in presence of an explosive atmosphere;
----be aware heat may be conducted to combustible materials that out of sight;
----place the appliance on its stand after use and allow it to cool down before storage;
----do not leave the appliance unattended when it is switched on.
6.3 take care of your tools
Do not use the tools for any applications other than soldering or desoldering.
Do not rap the iron/gun against the work bench or otherwise subject the iron to severe shocks.
Do not file the soldering tip to remove the oxide, please wipe the tip on the cleaning sponge.
Use only accessories or attachments which are listed in the operation manual. Use of other
tools and other accessories can lead to a danger of injury.
Please turn off the power before connecting or disconnecting the soldering iron.
6.4 Maintenance
Before further use, safety devices or slightly damaged parts must be carefully checked for
error-free and intended operation. Inspect moving parts for error-free operation and that they
don’t bind, or whether any parts are damaged. Damaged safety devices and parts must be
repaired or replaced by a qualified technician, so long as nothing else is indicated in the
operation manual. Use only accessories or attachments which are listed in the operation
manual. Use of other tools and other accessories can lead to a danger of injury.
6.5 Keep children at a distance
Warning: this appliance is not intended for use by young children and infirm persons
unless they have been adequately supervised by a responsible person to ensure that they
can use the appliance safely.
Warning: Young children should be supervised to ensure that they do not play with the
appliance.
Unused soldering tools should be stored in a dry location which is out of the reach of children.
Switch off all unused soldering tools.
6.6 Work environment
Do not use the soldering tool in a moist or wet environment. The soldering iron and the hot air
gun should be placed on the holder after finished using.
6.7 Observe the valid safety regulations at your work place.
Note: This instruction is also available to download from the distributor’s
website: www.doss.com.au.
