Dj power X-1 Manual de usuario

DRY ICE MACHINE

DRY ICE MACHINEDRY ICE MACHINE

GUANGZHOU DJPOWER ELECTRONIC TECHNOLOGY CO.,LTD

X-1

Foreword

Thank you very much for choosing the DJPOWER X-1 Dry Ice Machine. This

item is a compact and portable dry-ice fogger generating huge amount of thick

ground-hugging fog. It is pretty stable for the durable corrosion-resistant

polyethylene housing.

Before start operating the unit, we strongly suggest to read the user manual

carefully. Following the instructions in the user manual will ensure long-term

stable and satisfactory effects.Please follow these operation, safety and

maintainance instructions to ensure the machine’s normal work and prolong its

usage life.

How to get and store the dry ice.

Please prepare the dry ice before usage due to it will sublimate with time.

Storing it into a adiabatic or heat-isolated container can help mitigate the

disappearance.Usually the seller of dry ice would supply the container when

you buy the dry ice.

There are many shapes of dry ice, such as powder, granule, bulk, and globe.

Among these, small globular one is the best,because there is no need to

break it. If for a big massive one, you must break it into small pieces. Before

that, please cover the bulk with cloth to avoid the dry ice fragments hurting

eople.

Introduction

X-1 is a professional dry ice machine which produces thick, white fog that hugs

the floor and dissipates without rising. The powerful machine heats enough

water to create fog from 8kg of dry ice to provide 8 minutes of run time. Output

and flow are easily controlled by adjustable multi-level control arm. Dual

heaters allow for faster heat-up and recycle time. The unique design allows

remaining dry ice to be stored temporarily in the machine for next uses within

20 min. A low water sensor increases safety.

Features

Aerodynamics based design instead of traditional fan-driven;

Rotational molded body with insulated high-intensity composite material, Light

and compact, only 14kg;

Durable and extremely low failure rate;

Dual heaters ( 1,500 W / 3,000 W ) allow for faster heat-up (only 30 min) ;

Clear water level display and low water sensor;

Note: Requirements towards Solid CO (Dry ice). Please use

columnar dry ice. To achieve best effects, the size of dry ice

should be as big as thumb.

Create strong fog from at most 8kg of dry ice one time to cover max 250㎡;

5 minutes of run time when full on, 10 minutes of run time when 50% output;

All stainless-steel metal parts, firm, durable and extremely low failure rate;

Easy to pour out the remaining water after use;

Increase safety with low-water and temperature sensors that automatically

shut off heaters;

Manipulate the output and flow with the adjustable, multi-level control handle;

Safety Precautions

Ensure that any operation of the machine is supervised by trained and

authorized personnel.

Do not modify the machine or use a machine which has been damaged .

Protect the machine from any direct weather effects and wet locations.

Do not continue to produce fog when visibility is reduced to 50cm or below.

Avoid directing fog output at people, structures or objects within close

proximity of the nozzle.

Ensure that adequate exhausting equipments are available in the event of an

emergency.

The Dry Ice Fogger Principal

Dry Ice is a solid form of carbon dioxide. With its ability to sublimate, transform

from the form of solid to gas without generating liquid and its low temperature

up 87.5 Celsius degree, the dry-ice-based fogger come into being. When

immersed in hot water or boiling water, the dry ice sublimates which will stir the

water violently and spray many water droplets into the air. The released cold

CO gas will cause the water vapor in the air to form more droplets. This great

expansion of gas pushed moisture out of the machine. Because when exposing

to the relative cold air, it sinks to the floor, plus the droplets in the air, low fog

effects then come into being.

Opening the package and inspecting the machine

Please make sure the machine is in good condition after opening the package.

If there is any damage, please contact with your dealer directly and do not

power on the machine

The following parts should be included when you receive the package

One X-1 Dry Ice Machine

11.

10.

One power cord

One user manual

Operation

Place the machine on a firm and level surface where it will be used. Take off the

lid and fill with about 5 gallons(18 liters) water(hot or cold). Connect the unit to

power, when the red light is on, it means the machine is heating up.

Plug the cord into a grounded 22-amp receptacle. The heater draws 11 amps at

230 volts.

While the machine is heating up, raise the built-in basket to its highest level

and fasten it with the black handle on the side of the machine.

After steaming the water for approximately 30-50 minutes, the machine will be

ready to use.

Using protective gear load, the basket can hold 8 kilograms (about 18 lbs) of

dry ice. Please Note: Usually the dry ice being used here cover 2/3 of the whole

basket. Put into the dry ice at the last possible moment when needed, because

the steamy atmosphere in the machine will make the dry ice inside evaporate if

it is put inside too long beforehand.

After holding the dry ice, tighten the lid, and screw the lid latch according to the

instruction of imprint.

When the fog is in need, grasp the operation lever and slowly lower the handle.

A full basket should not be plunged into the hot water completely, because the

violent dry-ice sublimating would result in high and dangerous pressure in the

housing . The operation lever is used to allow the basket to move up and down

in the water. As the solid CO is immersed, thick cloud-like fog will be produced

from the nozzle. To increase the rate, lower the lever to the end. Fully raising

the handle will quickly stop the fog output. Thus it is possible to realize the

“ON” and “OFF” control by adjusting the operation lever.

When the machine is to be emptied, allow it to cool. Empty the remaining water

in the machine to buckets where the machine stands rather than carrying it to

drain. Do not move the machine with hot or boiling water in.

Maintainance

Keeping lid latch slightly oiled will protect them and allow them to operate

easily.

Make sure no other barriers in the rubber lid seal, otherwise it will allow gas

escape through the lid gasket.

When you heat up the machine, leave the lid off. This prevents the carry

handles from getting hot before adding dry ice.

Do not pour cold water directly onto hot heating element as this will cause

premature failure.

To replace the components or repair a broken seal:

a. Remove components or clean.

b. Replace the rubber gaskets and sealing washers. Do not reuse the old

ones.

c. Tighten bolts evenly to compress the seal.

DJPOWER company considers all of it's product to be safe for use in the

application it was intended.

DJPOWER company takes no responsibility for misuse or incorrect use.

Always refer to the Product Manual for proper use.

Technical Specifications

Voltage : 100- 120 V, 60 Hz

Main Power: 1,500 W

Assistance Power: 1,500 W

Total Power: 3,000 W

Heat-up Time: 50 min (1,500 W)

Shortest Heat-up Time: 30 min (3,000 W)

Electronic Temperature Control: 75 ℃~85 ℃

Water Consumption: 18 L

Max Output Time: 4~5 min

Max Coverage: Around 250㎡

N.W.: 14 kg

G.W.: 16 kg

Machine Size: 524/474/468 (mm)

Package Size: 600/550/560 (mm)

Consumables: Columnar dry ice

Diagram

Rotary bolt lock

Sealing strip

Hand shank

Gear groove

Heater

Handle

Lid

Heating finished

Heating indicator

Line box

Main power

Assistant power

Nozzle

Airframe,built-in dry ice basket

10.

11.

12.

13.

14.

Optional parts

Optional (charge extra) movable rolling cart, convenient to be used.

Optional (charge extra) 2-meter hose, cater for different occasions.

Otros manuales de Máquina de niebla de dj power

dj power

dj power DFZ-800 Manual de usuario

dj power

dj power DJV STAGEEFFECTS F-650 Manual de usuario

dj power

dj power DSK-1500VS Manual de usuario

dj power

dj power WP-4 Manual de usuario

dj power

dj power H-6 Manual de usuario

dj power

dj power H-2VSD Manual de usuario

dj power

dj power H-2VD Manual de usuario

dj power

dj power DJV DF-V9C Manual de usuario

dj power

dj power DSK-3000 Manual de usuario

dj power

dj power 102630 Manual de usuario

dj power

dj power djV PT-1500 Manual de usuario

dj power

dj power WP-1S Manual de usuario

dj power

dj power DSK-4000 Manual de usuario

dj power

dj power DJV DF-V6C Manual de usuario

dj power

dj power DSK-1800 Manual de usuario

dj power

dj power DJV PT-1500V Manual de usuario

dj power

dj power DSK-1000V Manual de usuario

dj power

dj power H-SW3000 Manual de usuario

Manuales populares de Máquina de niebla de otras marcas

Antari

Antari ICE Manual de usuario

Boost

Boost BOOST-FOG400LED-BK Manual de usuario

Home Accents Holiday

Home Accents Holiday FM1000-ASH Manual de usuario

EuroLite

EuroLite ZEITGEIST FOG-1200 Manual de usuario

Dyna-Fog

Dyna-Fog CYCLONE ULTRA 2734 Manual de usuario

PROEL

PROEL DRAGO HEAVY PLFD150HY Manual de usuario

Sparklyn

Sparklyn Y846 Manual de usuario

Magicfx

Magicfx CO2 Gun Manual de usuario

Ibiza

Ibiza LSM500LAS Manual de usuario

Antari

Antari M-5 Manual de usuario

Venue Lighting Effects

Venue Lighting Effects ULTRA MINI-FOGGER Manual de usuario

High End

High End F-100 Manual de usuario

Chauvet

Chauvet ARENA 2100 FLEX Manual de usuario

Antari

Antari X FAZER Manual de usuario

Beamz

Beamz F1600 Manual de usuario

Sagitter

Sagitter SG ARS900C Manual de usuario

KISANKRAFT

KISANKRAFT KK-STF-480 Manual de usuario

Orion

Orion OT-U250PP Guía

dj power X-1 Manual de usuario

Manuales populares de Máquina de niebla de otras marcas