Dixon PERSONAL LIFT 3302 Manual de instrucciones

TECHNICAL DATA

ZTR Model 3302

IMPORTANT -READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

SEAT ADJUSTMENT

1. Pull or lift body retention latch P/N 3954

from transaxle backing plate, raise and

push body and seat assembly forward.

2. Loosen four seat bolts, P/N 3227 and

slide seat forward or backward to

desired position.

3. Re-tighten seat adjustment bolts P/N

3227. DO NOT operate mower without

seat adjustment bolts properly

tightened.

4. Close upper body and push retention

latch P/N 3954 over transaxle backing

plate.

DIXON INDUSTRIES, INC. A

BLOUNT COMPANY AIRPORT

INDUSTRIAL PARK

PO BOX 1569

COFFEYVILLE KS 673370945

316251 2000

FAX 316 251 4117

Page 1 of 8

REMOVING THE BODY

1. The 3302 has a two -piece polyethylene body. The upper body can be folded forward to

expose the transaxle. In some cases, it may be necessary to remove the upper body to

service the transaxle.

2. To remove upper body, remove two bolts P/N 3093 from the front of upper body hinge

located on the brake shaft P/N 9283. Disconnect seat switch P/N 4761 at plug-in.

3. Reverse above procedure to reinstall.

ADJUSTMENT OF MOWER DECK DRIVE BELT

1. This mower deck drive belt is tensioned by a spring loaded engagement idler quadrant.

2. This system is designed to maintain the proper belt tension at all times.

3. Belt tension can be adjusted by moving the engaging rod P/N 7013 into the outside hole of

engagement handle P/N 7020.

4. After belt tension is adjusted, check to assure that the mower blade will not turn freely when

the engaging rod is in the "OFF" position.

5. lf the mower blade turns freely, adjust the blade brake byloosening nut P/N3205 at

the end

of the brake rod P/N 2988.

6. After adjustment is achieved, perform the safety checks listed below.

REMOVING THE MOWER BLADE

Secure blade P/N 2483 from turning. Remove blade bolt from center of blade P/N 3268, and

blade washer P/N 6260 then remove blade P/N 2483. To reinstall, reverse above procedure.

Tighten blade bolt to 60 ft. Ibs. of torque.

WARNING: Sharp edges on blade can cause injury!

Caution should be exercised when service is required on blade.

REMOVING THE MOWER DECK

1. Loosen belt keepers P/N 7026 & 7027 located under the engine by loosening the mounting

bolts, allowing the deck drive belt to come free of the rear pulley.

2. Disconnect the wiring loom at the deck safety switch P/N 4242.

3. Remove the two clevis pins P/N 3072 from the two rear L-rods P/N 1355 and slide from slots.

4. Remove clevis pin P/N 3072 from L-rod attached to lift handle and slide from slot.

5. Remove clevis pin P/N 3072 from front deck hanger shaft P/N 1332, located at front of

mower deck on slide plates welded at battery box, and remove.

6. Lift front of mower chassis clear of deck. Roll chassis free of the deck.

7. To install, reverse the above procedure. -Page 2 of 8

MOWER BLADE OPERATION

To engage mower blades, turn engagement lever on floor slowly to the "ON" position. To

Disengage mower blades, turn lever slowly to the "OFF" position.

SAFETY CHECKS

IMPORTANT-PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS

1. After reassembly, while seated on mower, attempt to start engine with mower deck

engaged. Engine should not start. If engine does start, return the mower to an Authorized

Dixon dealer for adjustment or repair.

2. Disengage mower deck and start engine. With the operator in the normal seated position,

engage mower deck and remove weight from seat. The engine should stop. If the engine

does not stop when operator rises from seat, return the mower to an Authorized Dixon

dealer for adjustment or repair.

3. Engage, then disengage mower blade in each cutting height. Insure that blade

disengages and comes to a stop within (5) seconds in each height position. If blade does

not disengage properly, contact your Authorized Dixon dealer.

CAUTION: DO NOT OPERATE MOWER IF ANY SAFETY FEATURE IS NOT FUNCTIONING CORRECTLY

PARKING BRAKE ADJUSTMENT

Remove the body as described above. Tighten nut on brake rod P/N 2533 located in front of

the transaxle on each side, just enough to prevent brake from slipping when engaged.

CAUTION:

Over-tightening may cause premature wear on the brake band P/N 5085

Revised 7/93 P/N

8114

Page 3 of 8

Page 4 of 8

3302 BODY ASSEMBLY

Page 5 of 8

3302 CHASSIS ASSEMBLY

Page 6 of 8

3302 TRANSAXLE ASSEMBLY

3302 MOWER DECK ASSEMBLY 30"

Page 7 of 8

Page 8 of 8

3302 WIRING ASSEMBLY

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cortacésped de Dixon

Dixon

Dixon ZTR 2301 Manual de usuario

Dixon

Dixon D19KH42 Manual de usuario

Dixon

Dixon DX260D Manual de usuario

Dixon

Dixon ZTR 5000 Series Manual de usuario

Dixon

Dixon D149P21 Manual del propietario

Dixon

Dixon ZTR 966504101 Manual de usuario

Dixon

Dixon ZTR 5000 Series Manual de usuario

Dixon

Dixon ZTR 6000 Series Manual de usuario

Dixon

Dixon 27 KOH/968999588 Manual de usuario

Dixon

Dixon ZTRCLASSIC Manual de usuario

Dixon

Dixon D17K38 Manual de usuario

Dixon

Dixon 1999 ZTR 4515B Manual de usuario

Dixon

Dixon SPEEDZTR 46 Manual de usuario

Dixon

Dixon DX148/966663901 Manual de usuario

Dixon

Dixon ZTR Ram Ultra 61 Manual de usuario

Dixon

Dixon CE RAM Manual de usuario

Dixon

Dixon TECHNICAL DATA BROCHURE ZTR 308-311 Manual de instrucciones

Dixon

Dixon ZTR 5020 Manual de usuario

Dixon

Dixon RAM 48ZT Manual de usuario

Dixon

Dixon Ram Ultra 50 Manual de usuario

Dixon

Dixon D26BH54 Manual de usuario

Dixon

Dixon ZTR Mowers Manual de usuario

Dixon

Dixon SpeedZTR 30 ZTR Manual de operación y mantenimiento

Dixon

Dixon ZTR 3500 Series Manual de usuario

Manuales populares de Cortacésped de otras marcas

RHINO

RHINO 1958 Manual de usuario

Wolf Garten

Wolf Garten Compact plus 40 B Manual de usuario

Cub Cadet

Cub Cadet LTX 1045 Manual de usuario

Craftsman

Craftsman 917.378461 Manual de usuario

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manual de usuario

Challenge

Challenge CH18V2 Instrucciones de operación

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manual de usuario

DEWEZE

DEWEZE ATM-725 Manual de operación

Weed Eater

Weed Eater 180083 Manual de usuario

Husqvarna

Husqvarna Poulan Pro PP185A42 Manual de usuario

Better Outdoor Products

Better Outdoor Products Quick Series Manual de usuario

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manual de funcionamiento

MTD

MTD 795, 792, 791, 790 Manual de usuario

Toro

Toro Groundsmaster 3505-D Manual de usuario

Dennis

Dennis FT 610 Manual de usuario

AIRFORCE

AIRFORCE F-15 Gen 3 Manual de usuario

MTD

MTD 126-220-000 Manual de usuario

Toro

Toro 74806 Manual de usuario