Overall Cut-Out (Round x Depth)
PRO-650W 6-5/8" x 9-1/4” 6-1/2" x 2-3/8"
INSTALATION GUIDE
Eco-Series
Rectangular In-Wall Loudspeakers
Congratulations! You have purchased a high quality
stereo loudspeaker. When matched to comparable
electronic equipment, expect years of quality high fidelity
sound. Our belief is that music matters and we are
focused on delivering superlative music reproduction
everywhere in your home.
The following manual is designed to give you, the
installer or owner, basic information as to the speaker’s
installation and operation. It is beyond the scope of this
manual to go into all the details that must be taken into
consideration in a sophisticated high fidelity system.
If you have any questions regarding this speaker which
are not answered by this manual, contact your local
dealer for assistance. For the most current information
please visit www.ditopro.com.
GENERAL DESCRIPTION
These two-way speakers have specially designed
woofers with linear long throw butyl rubber surrounds for
long life and superior damping. Dome tweeters are
utilized for excellent high frequency dispension through-
out your entire listening environment. The frame and
grille can be custom painted to match the room decor.
SHIPPING DAMAGE
Each speaker is throughly tested before it leaves the
factory. However, in shipment, accidents may occur.
Please inspect your speakers carefully when you receive
them to make sure there is no damage. If there is,
please notify your dealer or supplier inmediately for
assistance. If you received your speakers by public
transportation, report the damage inmediately to the
shipping company.
AMPLIFIER OPERATION
These speakers will perform well with amplifiers from 5
to 125 Watts RMS. However, damage to the speakers
can be done by amplifiers of nearly any power rating if
the amplifier is overdriven into clipping. “Amplifier
clipping” is a phrase used to describe a condition when,
because of the volume demand, an amplifier is being
asked for more power than it can give. Clipping cause
distortion of the audio signal. If you should hear an
unusual amount of distortion at high listening levels then
consider reducing the volume. DAMAGE TO A
SPEAKER BY CLIPPING IS NOT COVERED UNDER
THE WARRANTY.
SPEAKER PLACEMENT
Placement of Wall Mounted Speakers should be
carefully considered. Ideally, the speakers should be
located where they will provide the best possible sound
and ease of installation. It is beyond the scopre of this
publication to discuss all of the various aspects of
speaker placement. Please contact a professional for
assistance if you are uncomfortable with the planning or
installation process.
Note: Though these speakers are referred to as “wall
mount”, they are also suitable for installations in ceilings
and custom cabinetry.
WIRING
To achieve maximum performance we strongly suggest
the use of good quality stereo cable. There are many
good brands available. We recommend that the cable
be at least 16 gauge or larger for runs of over 50 feet
and that the wire be double insulated. This is often
referred to as “jacketed” speaker cable. “Zip cord”,
which is single insulated and is often made with clear
insulation, should be avoided as it is not as durable. It is
important when installing the wiring and speakers that
you adhere to all local codes and regulations. We
suggest that a professional be consulted in order to
maximize your system’s performance. The following,
however, are some useful suggestions.
In-Wall
Install Guide Page 2 of 2
www.ditopro.com
