DITEC BIX AG4 Manual de usuario
www.ChronoRemoteControl.com
Manual
DITEC: BIX AG4, BIX LG4, BIX LP2,
BIX LP2 RED et BIX LS2
1) Press the PRG button on the receiver (turned on) the SIG LED lights up.
2) BIXLS2 only. Select the desired encryption code available from 1024 codes
through the 10 DIP switches.
3) Make a transmission by pressing any of the CH buttons of the transmitter
(within the range of receiver at the power).
4) The transmitter is activated. During this phase, the SIG LED indicator will
flash. When the light becomes steady, it is possible to activate a new
www.ChronoRemoteControl.com
transmitter.
5) Activate all transmitters by making a transmission as stated above.
6) The procedure automatically stops 10 seconds after the last transmission
Note: (Only with BIXLS2). It is sufficient to memorize a single transmitter (remote
control). All transmitters with the same code are automatically activated.
To activate the new transmitters without opening the electrical cabinet, press
PRG of an already memorized transmitter (within the range of the receiver
power) and press any of the CH buttons of the new transmitter.
Note: Be careful not to accidentally memorize your neighbors’transmitters.
Este manual sirve para los siguientes modelos
4
Tabla de contenidos
Otros manuales de Mando a distancia de DITEC
DITEC
DITEC Bixa G4 Manual del propietario
DITEC
DITEC Gol4C Manual del propietario
DITEC
DITEC BIX L Series Manual de operación y mantenimiento
DITEC
DITEC GOL4-C Manual del propietario
DITEC
DITEC BIXLR22-GOL Manual de usuario
DITEC
DITEC BIXLR22-GOL Manual de usuario
DITEC
DITEC GOL4 Manual de usuario
DITEC
DITEC BIXLR4 Guía rápida
DITEC
DITEC BIX L Series Manual de operación y mantenimiento
