4 | P a g e
5. Gain access to the rear of the screen & disconnect the 3 cables that are aached.
6. Set the unit aside for ease of installaon of the UCI.
7. The free end of the 22 pin T-harness that is plugged into the radio head, is routed behind the dash to the screen
locaon.
8. The 18 pin connector is inserted into the port labeled “Radio T-harness”.
9. Locate the WHITE, ROUND connector that was removed from the screen. Insert this cable into the WHITE port
labeled “LVDS IN”.
10.Take the provided LVDS cable and insert the BLACK end into the BLACK port (LVDS OUT). The other end will be
connected to the screen later.
11.If installing a rear view camera, insert the 8 pin MOLEX plug into the port labeled “Video IN”. Of the connecons
available, there’s;
a. Twisted Pair – Used for factory installed camera only on the 4.3” screens. This input is not used on the
8.4” screens. On the 8.4” screens, the factory camera input is on the back of the radio head.
b. Video 1, 2 & 3- Used for an aermarket camera input using composite video (yellow RCA connecon).
*Power connections for therear view camera can be made at the cigarette lighter.
12.If installing navigaon into the system, proceed to the navigaon installaon secon. Otherwise connue to
step 13.
13.Aer all the connecons are made, securely mount the UCI module in the dash.
14.Connect the WHITE end of the provided LVDS cable into the screen. Make all other connecons and reassemble
the radio/screen.
15.Make the necessary changes in the SETUP menu & test.
16.Using the plasc pry tool, gently pry around the dash panel to release the locking tabs. Take extra care when
releasing these tabs, they may fall from the dash panel and into the dash.
If Installing Directus Navigation
Once you complete step 12 of the UCI installaon, connue from this point.
1. Plug in the supplied 24 pin Navigaon harness into the port labeled NAVIGATION/AV.
2. Route this cable down to the driver’s side under dash or any locaon that is secure. Be sure to securely fasten it
to exisng wiring and brackets. Route away from any sharp or moving parts.
3. Using Velcro, secure the module. For added stability, a large zip e should be used to secure the module in
place.
4. Plug the routed cable from the UCI into the
Directus navigaon unit.
a. Black Din - RGB
b. Grey Din – DATA
c. 4-pin MOLEX – DC IN
NOT USED
5. Included in the kit is an external speaker, it is used for turn by turn navigaon or any audio output from the
navigaon unit. The speaker can be mounted on one of the metal rails running vercally under the steering
column. It is recommended that the speaker faces the opening under the steering column for best volume.
6. Plug the speaker into the 3.5mm jack labeled SPK on the navigaon.
