Digital Watchdog VMAX IP 4CH Manual de usuario

1 | VMAX IP™ User Manual

Safety Information

The safety information is provided for the wellness of the equipment and for the safety of the

operator.

Please review and observe all instructions and warnings in this manual.

Preparations before installation

To protect your NVR from damage and to optimize performance, be sure to keep the NVR away from dust, humidity, and

area with high voltage equipment such as refrigerator.

Do not install or place equipment in areas where the air vents can be obstructed, such as in tight enclosures or small utility

closet. Keeping the unit in a temperature-controlled room with ample regulated power is highly recommended. Do not

overload the wall outlet, as this can result in the risk of fire or electric shock.

Uninterruptible power devices such as UPS power surge protectors are recommended, and the NVR units must at least be

connected with UL, CUL, or CSA approved power surge protector. Avoid direct sun light and avoid heat.

FCC Information

This equipment has been tested and found to comply with the limits of Class Adigital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and radiates radio frequency energy, and if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required

to correct the interference at his own expense. Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment under FCC rules.

UL Information

- for pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible

- if the battery is placed elsewhere in the equipment, there shall be a marking close to the battery or statement in the servicing

instructions.

AUTION

RISK OF EXPLOSION IF AN INCORRECT TYPE REPLACES BATTERY.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTION.

THIS EQUIPMENT IS FOR INDOOR USE, AND ALL THE COMMUNICATION WIRING IS LIMITED TO

INSIDE OF THE BUILDING, OR ANY SIMILAR WORD.

Note: Keep this manual handy every time you operate this equipment. Also, check with your dealer

for further assistance and for the latest revision of this manual. Your dealer might provide you with a

digital version of this manual. We also ask to keep the original box and packing materials in case of

return and for long-term storage of the NVR unit.

VMAX IP ™ User Manual | 2

Contents

CHAPTER 1:NVR USER MANUAL

1GETTING STARTED 5

1.1 Checking Supplied Items 5

1.2 Connecting Peripheral Device 6

1.3 System Startup 7

2EXPLANATION FOR EACH FUNCTION 9

2.1 Front Panel 9

2.2 Rear Panel 10

3OPERATION 10

3.1 User Log-in 11

3.2 Quick Setup 12

3.3 Live Display Mode 13

3.4 Playback of Recorded Video 18

3.5 Simultaneous Live and Playback (CAMEO) 19

3.6 Quick Backup during Live & Playback 19

3.7 Search Recording Image 21

3.8 DST Setting and Screen Saver 24

3.9 Screen Saver 25

4SETTING 26

4.1 System 27

4.2 Device 34

4.3 Record 37

4.4 Alarm 39

4.5 Network 43

5WEB CLIENT 47

5.1 Web Login 487

5.2 Web monitoring 48

5.3 Web Playback 51

5.4 Web Configuration 52

3 | VMAX IP™ Complete IP System Bundle

CHAPTER 2:PIVOT™CLIENT SOFTWARE USER MANUAL

6PIVOT™USER GUIDE 53

6.1 PC Requirements 54

6.2 Software Installation 54

6.3 Software removal 56

6.4 Basic Operations 57

6.5 Pivot Functions 67

6.6 Pivot Setup 72

CHAPTER 3:MAC ACS CLIENT SOFTWARE USER MANUAL

7MAC ACS USER GUIDE 79

7.1 System Requirement 78

7.2 Install 78

7.3 Basic Operation 80

CHAPTER 4:APPENDIX

8APPENDIX :NETWORK SETUP FOR EXTERNAL USAGE 86

9APPENDIX :SPECIFICATION 87

VMAX IP ™ User Manual | 4

Chapter 1

NVR USER MANUAL

5 | VMAX IP™ Complete IP System Bundle

1GETTING STARTED

1.1 Checking Supplied Items

Make sure that you have the following items supplied with your NVR. If any of these items are missing or damaged, notify

your vendor immediately. Keep the packing utilities for moving or storage purposes afterwards.

Items

Photo

Quantity

Quick Start Guide

1 Set

CD (Manual & Software)

Rubber Mount

1 Set

1 Set (4 Pieces)

12V 3A DC Adaptor

Power Cable

1 Set

48V 1.4A PoE Adaptor

Power Cable

Option

USB Mouse

1 Set

IR Remote Controller

1 Set

(8 / 16

Channel models only)

Screws

4 Pieces: Top cover

(8 / 16 Channel

models only)

User’s Manual | 6

1.2 System Startup

1.2.1 System Startup

After connecting peripheral devices such as cameras, monitors and a mouse to the NVR, power up the NVR by connecting

DC12V 3Aadaptor to the power jack on the rear panel. The boot logo will display as shown below. Please wait until the boot

process completes. Optional PoE needs independent power input of 48VDC.

To login, right-click anywhere on the screen. This will bring up the login screen, where you can enter the username and

password. There is only one Administrator Account configurable in the NVR. It is assigned with an unchangeable User ID

marked as ‘admin’. The default password is empty (No Password).Administrator account has full access to the NVR and its

configurable parameters. TheAdministrator Account also has the ability to create new users and to assign rights to the new

user accounts. Those new users created by theAdministrator can also login with a specific password set by the

Administrator.

OTE

Do not forget the administrator’s password that was set for the first time. In case the password is lost,

contact your vendor.

OTE

The mouse is included. In case you need to replace it, it is highly recommended to choose well-known

major brands such as DELL, MICROSOFT, LOGITECH, or SAMSUNG.

7 | VMAX IP™ Complete IP System Bundle

1.2.1 System Shutdown and change password

The system can be power off by ‘Shut Down’ button. The ‘Shut Down’can be done by clicking a right button of mouse.

The default password for ‘admin’account is none. Therefore, just click ‘OK’button on the popup window. If you change the

password for ‘admin’account, please type in the changed password to login.

NOTE

User can type in the password using the virtual keyboard.

User’s Manual | 8

2EXPLANATION FOR EACH FUNCTION

2.1 Front Panel

[4CH (W) 114x (H) 166x (D) 248mm]

[8/16CH (W)360x(H)66x(D)356mm]

No. Items Functions

1 LED Indicator Indicate Power, Record, Network

2 USB Port USB Port (Ver. 2.0) for Mouse Operation, Backup Device or Firmware Update

3 Standby Button Press the button one time to set the system on stand-by mode.

Press the button twice to restart the system

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de DVR de Digital Watchdog

Digital Watchdog

Digital Watchdog Stand alone DVMR Manual de usuario

Digital Watchdog

Digital Watchdog VMAX A1 Plus DW-VA1P41T Manual de usuario

Digital Watchdog

Digital Watchdog DW-VHD4 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX AHD CORE DW-VAC44 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX A1 G4 DW-VA1G44 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX IP PLUS DW-VP9P Manual de usuario

Digital Watchdog

Digital Watchdog VMAX Manual de usuario

Digital Watchdog

Digital Watchdog VMAX IP G4 DW-VG416 T16P Series Manual de usuario

Digital Watchdog

Digital Watchdog VMAXip PLUS DW-VP9P Manual de usuario

Digital Watchdog

Digital Watchdog VMAXD1 16 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX A1 PLUS DW-VA1P4T Series Manual de usuario

Digital Watchdog

Digital Watchdog VMAX IP PLUS Manual de usuario

Digital Watchdog

Digital Watchdog DW-VAC42T Manual de usuario

Digital Watchdog

Digital Watchdog Vmax960-8 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX Manual de usuario

Digital Watchdog

Digital Watchdog VMAX AND CORE DW-VACB2T Manual de usuario

Digital Watchdog

Digital Watchdog Nexus Manual de usuario

Digital Watchdog

Digital Watchdog VMax Flex DW-VF4 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX 480 Manual de usuario

Digital Watchdog

Digital Watchdog DW-VAONE 41T Manual de usuario

Digital Watchdog

Digital Watchdog Transporter Manual de usuario

Digital Watchdog

Digital Watchdog VMAX IP PLUS DW-VP12P Manual de usuario

Digital Watchdog

Digital Watchdog VMAX A1 Plus DW-VA1P8 Manual de usuario

Digital Watchdog

Digital Watchdog VMAX960H CORE Manual de usuario

Manuales populares de DVR de otras marcas

FLIR

FLIR M3100E Series Manual de usuario

VTRACKPRO

VTRACKPRO FPRO300 Manual de usuario

Swann

Swann NVR-7085 models Manual de usuario

XtendLan

XtendLan DVR-1670C Manual de usuario

urmet domus

urmet domus 1093/004AHD Manual de usuario

Holux

Holux M1 Manual de usuario

CMOS DOTCOM

CMOS DOTCOM ANX-1670 Manual de usuario

Whistler

Whistler D16VRS Manual de usuario

Defender Security

Defender Security 82-20235 Manual de usuario

MISUMI

MISUMI MP-WF100M Manual de usuario

Speco

Speco D8HU Manual de usuario

UST

UST DDR-E04AA Instrucciones de uso

Consolidated

Consolidated Digital Video Recorder Manual de usuario

Mace

Mace DVR0404RW Guía de inicio rápido

RCA

RCA RTD315W Manual de usuario

FSM

FSM Colibri Grande PRO Manual de usuario

Hauppauge

Hauppauge HD PVR 2 Manual de usuario

Identivision

Identivision ICR-PH161i PIONEER Manual de usuario