Digital Equipment 100BaseFX Mod-MAC Manual de usuario
EK-DLXFX-IM. A01
Installing and Cabling the 100BaseFX Mod-MAC (DLXFX)
Introduction
The 100BaseFX Mod-MAC is part of the Mod-MAC product family (which includes the 100BaseTX and
10BaseFL). It provides connectivity between a DIGITAL MultiSwitch 612EX and network devices using
100BaseFX Multimode Fiber (MMF). The 100BaseFX Mod-MAC only operates in the DIGITAL MultiSwitch
612EX. As illustrated above, the 100BaseFX Mod-MAC contains a transmit (1) and receive (2) connector.
Installation Procedure
Before you install a 100BaseFX Mod-MAC, make sure that the module has no power connected to it. The
100BaseFX Mod-MACs are not hot-swappable. To install the 100BaseFX Mod-MAC, complete the following
steps. A Phillips-head screwdriver is required.
1Remove the dust cap from the module’s modular interface connector.
2Hold the 100BaseFX Mod-MAC by its bezel so that it is parallel with a slot opening on the module.
3Insert the 100BaseFX Mod-MAC and align its sides with the guide in the module’s slot opening.
4Push the 100BaseFX Mod-MAC into the slot until it is firmly seated inside the module.
5Align and securely fasten the two Phillips-head screws on the 100BaseFX Mod-MAC bezel.
NPB-0600-96F
2
1
NPB-0611-96F
6Insert the transmit (1) and receive (2) 100BaseFX cable connectors into the transmit and
receive100BaseFX Mod-MAC port connectors, respectively , respectively.
When the module is powered on, the following 100BaseFX Mod-MAC LEDs become operational:
Reference
If the LEDs do not operate as described, refer to the troubleshooting information in the DIGITAL MultiSwitch
612EX Installation and Configuration manual. The manual provides safety and product specification information.
The informationisalso available on the DigitalEquipmentCorporation Network Products EngineeringHome Page
on the World Wide Web at the following addresses:
North America: http://www.networks.digital.com
Europe: http://www.networks.europe.digital.com
Australia: http://www.digital.com.au/networks
© Digital Equipment Corporation 1997. All rights reserved.
Digital, and the DIGITAL logo are trademarks of Digital Equipment Corporation.
Item Name Description
1 Activity LED Flickers in response to traffic on this port.
2 Port Status Is turned off if there is no connection; blinks if the port has
been disabled by management; steady on if there is a
connection.
NPB-0610-96F
1
2
NPB-0609-96F
2
1
DLXFX-MA
Tabla de contenidos
Otros manuales de Tarjeta PCI de Digital Equipment
Digital Equipment
Digital Equipment Fast EtherWORKS DE500-BA Manual de usuario
Digital Equipment
Digital Equipment EtherWORKS Turbo PCI Manual de operación
Digital Equipment
Digital Equipment 10BaseFL Mod-MAC Manual de usuario
Digital Equipment
Digital Equipment EtherWORKS Turbo PCI Manual de operación
Digital Equipment
Digital Equipment 9FX Vision 330 Manual de usuario
Manuales populares de Tarjeta PCI de otras marcas
Belkin
Belkin F5D7000F Manual de usuario
Pericom
Pericom PI7C7100 Manual de usuario
ADLINK Technology
ADLINK Technology cPCI-3548 Manual de usuario
Digium
Digium TE200 Series Manual de usuario
Allo.com
Allo.com 2nd Gen E1/T1/J1 Manual de usuario
Western Digital
Western Digital FireWire PCI Adapter Manual de usuario