Digital Equipment PCXCV-Dx Manual de usuario
TM
PCXCV-Dx Auto-Scanning
Color Monitor
Installation Guide
Order Number: ER−XCVDX−IV. A01
Digital Equipment Corporation
May 1997
The information in this document is subject to change without notice and should
not be construed as a commitment by Digital Equipment Corporation. Restricted
Rights: Use, duplication, or disclosure by the U.S. Government is subject to
restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical
Data and Computer Software clause at DFARS 252.227-7013.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. Any changes or modification made to this equipment may
void the user’s authority to operate this equipment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception; however, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DO NOT attempt to modify this equipment. If modified, the FCC may void your
authority to operate this equipment.
VCCI Class 2 - Japan
Canadian Department of Communications Statement
This Class B digital apparatus meets all requirements of the Canadian
Interference Causing Equipment Regulations.
DEC and the DIGITAL logo are trademarks of Digital Equipment Corporation.
IBM is a registered trademark of International Business Machines Corporation.
VESA is a registered trademark of the Video Electronics Standards Association.
All other trademarks and registered trademarks are the property of their
respective holders.
As an ENERGY STAR™ partner, Digital Equipment Corporation has determined
that this product meets the ENERGY STAR™ guidelines for energy efficiency.
1997 Digital Equipment Corporation.
All Rights Reserved.
iii
Contents
Introduction
Overview ......................................................................................1
DDC (Display Data Channel)..................................................2
Installation
Installation/Operating Guidelines..................................................2
Tilt/Swivel Stand Installation.........................................................3
Monitor Installation .......................................................................4
Servicing
Cleaning the Monitor ....................................................................7
Maintenance and Troubleshooting................................................7
Specifications
Display Modes..............................................................................8
Monitor Specifications ..................................................................9
Power Management System.........................................................10
Environment.................................................................................12
iv
Tables
Table 1 User Controls and Functions ..........................................6
Table 2 Identifying and Correcting Problems...............................8
Table 3 Display Modes and Addressability ..................................8
Table 4 Monitor Specifications.....................................................9
Table 5 Power Saving States ......................................................10
Figures
Figure 1 PCXCV-Dx Color Monitor..............................................1
Figure 2 Tilt/Swivel Stand Installation..........................................3
Figure 3 PCXCV-Dx Monitor (Rear View)....................................4
Figure 4 Control Panel, LED, and Power Switch..........................5
Audience
This guide is intended for user’s who wish to install the monitor.
Conventions
The following conventions are used in this document:
Convention Meaning
Note Provides general information.
Caution Provides information to prevent damage to
equipment.
Warning Provides information to prevent injury.
1
Introduction
Overview
The PCXCV-Dx monitor is a color monitor with high resolution and
auto-scanning, compatible with VGA, SVGA, and 1024 x 768 modes.
The PCXCV-Dx monitor offer the following features:
• 1024 horizontal x 768 vertical non-interlaced resolution
• 85 Hz refresh with SVGA 800 x 600 mode
• Power Management system that exceeds EPA ENERGY STAR™
requirements for saving energy.
• VESA Data Display Channel - DDC1/2b
• Complies with Swedish MPR2 standards for low magnetic
emissions
• Anti-glare screen with anti-static coating
• Tilt-swivel base
Figure 1. PCXCV-Dx Color Monitor
2
DDC (Display Data Channel)
DDC is a communication channel over which the monitor automatically
informs the host system about its capabilities. DDC uses formerly
unconnected signal pins in the 15-pin VGA connector. The system
performs the “Plug ‘n Play” feature if both the monitor and the host
implement DDC protocol.
Installation
Installation/Operating Guidelines
Observe the following basic rules for installation and use.
Do . . .• Use the power cord from the PC country kit, which is UL-, CSA-, and
VDE-approved.
• Turn the monitor off when not being used for an extended period of
time, or use Power Management if applicable.
Do Not . . .
• Overload the ac outlet.
• Move the monitor on a stand over carpet or thresholds.
• Push objects into the monitor’s openings.
• Add accessories that are not designed for this monitor.
• Operate the monitor near water or in a damp environment, which
could cause an electrical hazard.
• Operate the monitor near magnets, motor devices, transformers,
high power lines, or large steel pillars, which can cause distortion in
the picture.
• Obstruct the ventilation openings in the monitor’s cabinet, such as
placing the monitor on a rug or within an enclosure.
• Place the monitor near a radiator or heat source.
3
Tilt/Swivel Stand Installation
To install the stand:
1. Insert the hooks on the stand into the slots in the bottom of the
monitor.
2. Apply pressure near the latch so it is secure. (To remove the stand,
pull on the latch.)
Figure 2. Tilt/Swivel Stand Installation
4
Monitor Installation
To connect the monitor:
1. Make sure the power to the monitor and the computer is off.
2. Connect the monitor’s signal cable to the back of the monitor (1) and
to the 15-pin interface connector on the High Resolution Graphic
Video Adapter on the back of the computer.
3. Plug the ac power cord to the monitor (2), then to a properly-
grounded ac electrical outlet.
Figure 3. PCXCV-Dx Monitor (Rear View)
5
Figure 4. Control Panel, LED, and Power Switch
Turn On Power to Monitor
Push the power switch button (1) to turn on the monitor. The power
indicator
LED (2) to the left of the switch should light green. The control panel (3)
is described in Table 1.
6
Table 1. User Controls and Functions
Item Icon Name Function
1
Select Select adjustment
+, - Plus, Minus Changes the setting of the
selected function.
Recall Pressing the + and the - buttons
simultaneously returns the
settings of the standard six display
modes to their factory values.
V-Center Adjusts the vertical centering.
V-Size Adjusts the vertical size.
H-Center Adjusts the horizontal centering.
H-Size Adjusts the horizontal size.
Pincushion Corrects the bowing in or out.
Trapezoid Corrects the geometric distortion.
Contrast Adjusts white level for comfortable
viewing.
Brightness Adjusts black level for comfortable
viewing.
2 Power/DPMS
indicator Identifies the power state of the
monitor.
3 Power switch Turns the monitor on and off.
Note: Once the adjustments are made, they are stored in
memory even if the power is removed.
Tabla de contenidos
Otros manuales de Monitor de Digital Equipment
Digital Equipment
Digital Equipment PCXCV-Gx Manual de usuario
Digital Equipment
Digital Equipment VT420 Manual de usuario
Digital Equipment
Digital Equipment VR320 Manual de usuario
Digital Equipment
Digital Equipment PCXBV-Px Manual de usuario
Digital Equipment
Digital Equipment VR14 Manual de usuario
Digital Equipment
Digital Equipment VRC20-Hx Manual de usuario
Digital Equipment
Digital Equipment PCXBV-Ux Manual de usuario
Digital Equipment
Digital Equipment PCXBV-Rx Manual de usuario
Digital Equipment
Digital Equipment VR315 Guía
Digital Equipment
Digital Equipment VR315 Manual de usuario
Digital Equipment
Digital Equipment VRE01 Guía
Digital Equipment
Digital Equipment PCXBV-Y Series Manual de usuario
Digital Equipment
Digital Equipment VRC21-Hx Manual de usuario
Digital Equipment
Digital Equipment VRT19 Manual de usuario
Digital Equipment
Digital Equipment VR320 Guía
Digital Equipment
Digital Equipment VR319 Manual de usuario
Digital Equipment
Digital Equipment VR14 Manual de usuario
Digital Equipment
Digital Equipment FP-770T Series Manual de usuario
Digital Equipment
Digital Equipment PCXBV-Tx Manual de usuario
