Digi-tech DigiGate Manual de usuario

digiGate

User Manual

This guide is for the digiGate control system and should be read

extensively before installation and usage of the digiGate system.

Please feel free to print this document.

English

V1.5

digiGate.co.uk

IMPORTANT

Read the following to prevent injury or death from using digiGate.

1. You should

ONLY

operate digiGate when you have clear vision of the

automated device you are controlling (Electric Gates, Garage door etc.).

2. digiGate should

ONLY

be controlled by adults and

NOT

children.

3. You

MUST

ensure that there is nothing blocking the free movement of your

automated device when using digiGate. Operating your digiGate without

making sure it is clear can lead to damage of property and injury or even death.

digiGate.co.uk

1 In the box .......................................................................................................................... 5

2 Technical specification ..................................................................................................... 6

3 digiGate system ................................................................................................................ 7

4 How it works ..................................................................................................................... 8

4.1 Switch cables ............................................................................................................ 8

4.2 Electric Gate System ................................................................................................. 8

4.3 Electric Garage System ............................................................................................. 8

4.3.1 Single Garage .................................................................................................... 8

4.3.2 Single Garage (2 buttons) ................................................................................. 9

4.3.3 Double Garage .................................................................................................. 9

5 General installation .......................................................................................................... 9

5.1 Positioning ................................................................................................................ 9

5.2 Waterproofing .......................................................................................................... 9

5.2.1 Located outside near control unit .................................................................. 10

5.2.2 Located inside near switch/push button ........................................................ 10

5.3 Switch cabling ......................................................................................................... 11

5.4 Connecting power .................................................................................................. 12

5.4.1 5V Mains Plug (110/230v) .............................................................................. 12

5.4.2 Hardwire Kit (110-240v) ................................................................................. 12

5.4.3 POE Splitter ..................................................................................................... 14

6 Electric Gate installation ................................................................................................. 14

6.1 Automatic closing pre-requisite ............................................................................. 14

6.2 Connecting directly to gate control unit ................................................................. 15

6.3 Connecting to override switch/push button .......................................................... 16

7 Single Garage installation (1 button) .............................................................................. 17

7.1 Single Garage (1 button) pre-requisites ................................................................. 17

7.1.1 Connecting to garage controller directly ........................................................ 17

7.1.2 Connecting to push button ............................................................................. 18

8 Single Garage installation (2 buttons) ............................................................................ 19

8.1 Single Garage (2 buttons) pre-requisites ................................................................ 19

8.1.1 Connecting to garage controller directly ........................................................ 19

8.1.2 Connecting to push buttons ........................................................................... 20

9 Double Garage installation ............................................................................................. 21

9.1 Double Garage pre-requisites ................................................................................. 22

Table of contents

digiGate.co.uk

9.1.1 Connecting to garage controllerS directly ...................................................... 22

9.1.2 Connecting to push buttons ........................................................................... 23

10 Mounting your digiGate ................................................................................................. 24

11 Network connections ..................................................................................................... 25

11.1 Ethernet (RJ45) ....................................................................................................... 25

11.2 WiFi connection ...................................................................................................... 25

12 GSM Call-To-Open Module ............................................................................................. 26

13 digiGate Mobile App ....................................................................................................... 27

14 digiGate Web Portal ....................................................................................................... 27

15 digiGate Card .................................................................................................................. 27

16 Factory reset digiGate .................................................................................................... 28

17 Changing WiFi connection .............................................................................................. 28

18 Useful links ..................................................................................................................... 28

digiGate.co.uk

1 IN THE BOX

Standard Components

Optional Extras

1 x Power supply option

Garage systems come with mains plug as standard.

1 x digiGate control unit

1 x mounting bracket

1 x Standard USB WiFi antenna

Standard WiFi antenna can be upgraded to long range

waterproof antenna when ordering.

POE splitter power option does not come with WiFi antenna.

USB GSM ‘Call-To-Open’ Module

Appearance may vary

Documentation

1 x digiGate card

digiGate.co.uk

2 TECHNICAL SPECIFICATION

15cm

7cm

3.3cm

digiGate control unit

Power supply Weight

Input: 5v via plug or POE splitter 180g

Outputs

Gate system: 1 output (NO + COM)

Gate system with pedestrian control: 2 outputs (NO + COM x 2)

Single Garage system (1 button): 1 output (NO + COM)

Single Garage system (2 buttons): 2 outputs (NO + COM x 2)

Double Garage system (2 doors, 1 button per door): 2 outputs (NO + COM x 2)

Inputs

4 x USB ports

1 x Ethernet port

1 x Power

digiGate.co.uk

3 DIGIGATE SYSTEM

Switch terminals

Power

Ethernet

4 x

USB ports

Used for USB GSM ‘call to open’ module

and WiFi antenna (if used).

Ethernet network port

This is where an ethernet cable connects

to. The other end connects to your

router, network switch or ethernet-over-

power device to connect your digiGate to

the internet.

Switch terminals

These are where the switch cables that

connect to your gate/garage are inserted.

Output 1

1 - (NO) Normally Open

2 - (COM) Common

3 & 4 - unused

5 - (NC) Normal Closed

Output 2

6 - (NO) Normally Open

7 - (COM) Common

Only Gate with pedestrian function, Single

garage (2 buttons) and Double garage systems

have 2 outputs.

digiGate.co.uk

4 HOW IT WORKS

4.1 SWITCH CABLES

This user manual refers to the cables used to connect digiGate to your gate/garage as

‘switch cables’. These cables can be any length and thickness should start from 0.2mm.

digiGate systems include a complimentary length of this cable to demonstrate what should

be used.

4.2 ELECTRIC GATE SYSTEM

Your electric gate system will have a control unit which is a circuit board where digiGate

connects. This control unit will either be positioned at the gate itself in a waterproof

enclosure (most common) or in a nearby building.

digiGate connects to this control unit via 2 switch cables. These cables can be any length

which means you can position digiGate either beside the control unit itself or inside a

nearby building (recommended). The connection points on the control unit are often

referred to as ‘dry contacts’.

You might also have an override switch or push button for the gate in the

house/office/outbuilding nearby which controls the gate. This situation is the simplest for

installation as digiGate can simply connect to this.

4.3 ELECTRIC GARAGE SYSTEM

The digiGate Garage system has 3 variants:

Single garage (1 button) – You have 1 push button that both opens and closes the door.

Single garage (2 buttons) – You have 2 push buttons: one for open and another for close.

Double garage – You have 2 garage doors, both of which are controlled by 1 push button

each.

4.3.1 SINGLE GARAGE

Your garage will have a motor with control unit which controls the movement of the door.

You will also most likely have a push button which connects to the control unit and controls

the door.

digiGate connects either directly to the motor, control unit or push button via 2 switch

cables of any length.

digiGate.co.uk

4.3.2 SINGLE GARAGE (2 BUTTONS)

This connects the same way as the standard single garage system but with 4 switch cables of

any length. This is because you use 2 cables for the open connections and 2 cables for the

close connections on the garage motor/control unit/push button.

4.3.3 DOUBLE GARAGE

Your garage doors will have a motor for each with a control unit which controls each door.

You will also most likely have a push button which connects to each control unit and

controls the doors simultaneously.

digiGate has 1 output for each door and connects via 2 switch cables of any length to either

the motor, control unit or push button for the respective door.

5 GENERAL INSTALLATION

IMPORTANT: Your digiGate system and all ancillaries are not waterproof unless explicitly

specified. Any water damage will void the warranty across all components.

5.1 POSITIONING

We recommend, where possible, to install your digiGate inside the nearest building where

the Internet connection is. The switch cabling used to connect digiGate to the gate/garage

control board can be any length which gives flexibility to the installation location.

Should the digiGate unit require to be installed outside beside the control board, a

waterproof enclosure will be required to house the digiGate and all ancillaries.

5.2 WATERPROOFING

If you are positioning the digiGate outside, it will need to be installed in an IP rated

waterproof enclosure alongside all ancillaries. Only the optional upgraded 13dBi Waterproof

WiFi antenna can be installed outside with the USB cable routed into the waterproof

enclosure through the bottom of the enclosure via a secure duct.

An enclosure with minimum dimensions 30cm x 15cm x 10cm will be enough to fit the

digiGate, power supply, standard WiFi antenna and optional GSM ‘call to open’ module.

digiGate.co.uk

5.2.1 LOCATED OUTSIDE NEAR CONTROL UNIT

Your digiGate system and all components must be installed within a waterproof enclosure.

Step 1: Install a waterproof enclosure at the gate. This waterproof enclosure will house the

digiGate, power supply, WiFi antenna (if selected) and call to open module (if selected).

Step 2: Install power supply by following steps at section 5.4.

Step 3: Mount the digiGate inside the enclosure using the provided mounting bracket. A din-

rail adapter or double-sided tape/velcro can be used here to fix the bracket.

Step 4: Network connection

Standard WiFi antenna: If you purchased a digiGate with the standard WiFi antenna,

insert this into any of the spare USB ports.

13dBi Waterproof WiFi antenna: If you purchased a digiGate with the upgraded

waterproof WiFi antenna, drill a small hole in the bottom of the waterproof

enclosure (if required) and feed the USB cable through this. Ensure the hole is

correctly ducted and sealed to ensure no water can enter.

Ethernet only: If you are using an Ethernet connection, insert the Ethernet cable into

the port on the digiGate. Do not insert any USB WiFi antennas into the digiGate if

ethernet is in use.

Step 5: If purchased, Insert GSM call-to-open module (with SIM inserted) into any spare USB

port. Full GSM call-to-open module instructions can be found at section 12.

Step 6: Connect digiGate to control board using switch cables by following the steps at

section 5.3.

5.2.2 LOCATED INSIDE NEAR SWITCH/PUSH BUTTON

If you are installing your digiGate inside a watertight location, you do not need to use a

waterproof enclosure.

Step 1: Position your digiGate mounting bracket on a wall

close to your control unit and mark the position with a pencil

by drawing through the 4 screw holes. This is where

your digiGate will be permanently situated.

Step 2: Drill into the wall where you marked the 4 holes and insert screw plugs.

Step 3: Position the digiGate bracket over these plugs and screw screws through the bracket

holes into the plugs so the bracket sits firmly on the wall. Orientation does not matter.

Otros manuales para digiGate

Tabla de contenidos

Otros manuales de Adaptador de digi-tech

digi-tech

digi-tech xc4132 Manual de usuario

digi-tech

digi-tech XC4833 Manual de usuario

Manuales populares de Adaptador de otras marcas

PCB Piezotronics

PCB Piezotronics 090B274 Manual de usuario

Auvidea

Auvidea J20 Manual del producto

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manual de usuario

Akribis

Akribis ITF-21-BISS-MIT Manual de usuario

Tenda

Tenda W54U Manual de usuario

ROHO

ROHO AGILITY Manual de usuario

PROLiNK

PROLiNK WN2001 Manual de usuario

Hawking

Hawking HUF2 Manual de usuario

Airlink101

Airlink101 AWLC4030 Manual de usuario

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manual de usuario

Philips

Philips SWA4554S/10 Manual de usuario

JVC

JVC TS-C9D2B Manual de instrucciones

NETGEAR

NETGEAR A6100 Manual de usuario

D-Link

D-Link DWA-121 Manual de usuario

Philips

Philips SWA2037 Manual de usuario

Basalte

Basalte 0610-20 Manual de usuario

Yealink

Yealink EHS40 Manual de usuario

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manual de usuario

digi-tech digiGate Manual de usuario

Manuales populares de Adaptador de otras marcas