Thank you for purchasing our digital portable radio (compatible with analog radio). We
believe that the quality and function of this radio will meet your requirements and bring you
stable, reliable, clear and high-efficient communication.
As a product compliant with the DMR standard, this digital portable radio supports TDMA
(direct mode/repeater mode) and is compatible with high-end analog radio
(CTCSS/CDCSS). Its ergonomic design and high-quality OLED display make it easy to
operate even under strong sunlight. Besides, its digital functions (Digital Noise
Reduction, Private Call, Group Call, All Call, Message, Radio Disable, Monitor, Radio
Check, Call Alert, etc.) enable you to be responsive to critical situations.
Our digital portable radio of this series has 4 programmable keys which can be
programmed based on your actual needs (such as VOX/ Scan/ Power Switch/ Zone).
Besides, it supports Working Zone Management, Contact, Missed Call/ Incoming
Call/ Outgoing Call Management as well as Chinese/ English and Working Status
Indication, etc. It enables various functions to be easy to operate and ensures you a
smooth and high-efficient communication.
Preface
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply
with the limits for a Class B digital device , pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
NOTE 2: Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
- T h is ra d io is desi g ned fo r a n d c las s ifi e d a s
“Occupational/Controlled Use Only”, meaning it must be used
only during the course of employment by individuals aware of the
hazards, and the ways to minimize such hazards; NOT intended
for use in an General population /uncontrolled environment.
- DO NOT operate the radio without a proper antenna attached,
as this may damage the radio and may also cause you to
exceed RF exposure limits. A proper antenna is the antenna
supplied with this radio by the manufacturer or an antenna
specifically authorized by the manufacturer for use with this
radio.
- DO NOT transmit for more than 50% of total radio use time,
more than 50% of the time can cause RF exposure compliance
requirements to be exceeded.
- This transmitter may operate with the antenna(s) documented
in this filing in Push-to-Talk and body-worn configurations. RF
exposure compliance is limited to the specific belt-clip and
accessory configurations as documented in this filing and the
separation distance between user and the device or its antenna
shall be at least 2.5 cm.
FCC Statement
